- Article
The energy levels arising from the electronic orbital
The energy levels arising from the electronic orbital
This paper shows how clocked AC-DC charge pump circuits can be optimally designed to have the minimum circuit area for small form factor vibration energy harvesting. One can determine an optimum number of stages with simple equations and then determi...
Charge transfer dynamics fundamentally influence energy conversion efficiency in excited electronic states, directly impacting photoelectric conversion, molecular electronics, and catalysis. The core hole clock (CHC) technique enables the precise mea...
This paper presents the design and performance analysis of a wideband charge-pump phase-locked loop (CPPLL) characterized by low reference spur and low phase noise. The proposed CPPLL, operating as a wideband phase-locked loop (PLL) with a reference...
Kaluza was the first to realize that the four-dimensional gravitational field of general relativity and the classical electromagnetic field behave as if they were components of a five-dimensional gravitational field. We present a novel experimental t...
This paper presents an ultrasound transceiver application-specific integrated circuit (ASIC) directly integrated with an array of 12 × 80 piezoelectric transducer elements to enable next-generation ultrasound probes for 3D carotid artery imagin...
This paper describes a clocked AC-DC charge pump to enable full integration of power converters into a sensor or radio frequency (RF) chip even with low open circuit voltage magnetostrictive vibration energy transducer operating at a low resonant fre...
As the supply voltage decreases, there is a need for a high-speed negative charge pump circuit, for example, to produce the back-bias voltage (VBB) with high pumping efficiency at a low supply voltage (VDD). Beyond the basic negative charge pump circ...
Earlier work by some of the present authors identified power-law statistical regularities across the periodic table: a near-Zipf relationship
This paper proposes a 2.4-GHz fully-integrated single-frequency multi-channel RF energy harvesting (RFEH) system with increased harvested power density. The RFEH can produce an output power of ~423-μW in harvesting ambient RF energy. The front-end...
Quantum-dot cellular automata (QCA) is a low-power, non-von-Neumann, general-purpose paradigm for classical computing using transistor-free logic. Here, classical bits are encoded on the charge configuration of individual computing primitives known a...
This paper presents an investigation of the responsivity of a time-delay integration (TDI) charge-coupled device that employs anti-blooming clocking and uses a varying number of TDI stages. The influence of charge blooming caused by unused TDI stages...
This paper analyzes the performance requirements that need to be met by a clock generator applied to a low-temperature quantum computer and analyzes the negative effects on the clock generator circuit under low-temperature conditions. In order to mee...
Among all the functions that electronics currently perform, clock synthesis has a backbone role. Charge pump phase-locked loops (CP-PLL) are widely used to accomplish clock synthesis thanks to their versatility. One of the most critical parts of CP-P...
Applications such as non-volatile memories (NVM), radio frequency identification (RFID), high voltage generators, switched capacitor circuits, operational amplifiers, voltage regulators, and DC–DC converters employ charge pump (CP) circuits as they c...
Single Event Transients (SETs) in clock-distribution networks are a major source of soft errors in synchronous systems. We present a practical framework that assesses SET risk early in the design cycle, before layout and parasitics, using a Vulnerabi...
This paper presents a charge-pump phase-locked loop (PLL) frequency-synthesizer-based low-jitter wideband clock generator for multi-protocol data communications applications. Automatic frequency calibration (AFC) using linear variable time window tec...
This paper presents a charge pump circuit with a wide output range and low current mismatch applied to phase-locked loops. In this designed structure, T-shaped analog switches are adopted to suppress the non-ideal effects of clock feedthrough, switch...
Charge-coupled devices (CCD) allow imaging by photodetection, charge integration, and serial transfer of the stored charge packets from multiple pixels to the readout node. The functionality of CCD can be extended to the non-destructive and in-situ r...
Adiabatic logic has been proposed as a method for drastically reducing power consumption in specialized low-power circuits. They often require specialized clock drivers that also function as the main power supply, in contrast to standard CMOS logic,...
This paper proposes a one-dimensional (1D) maximum power point tracking (MPPT) design which only requires measurement of one parameter (the input voltage of a switched-capacitor charge pump) for calibrating a power converter including the charge pump...
This paper proposes an on-chip, ultra-low-power cold-start circuit for a low-voltage, fast start-up of a boost converter for autonomous thermal energy harvesting from slight temperature differences. An improved charge transfer obtained from a Schmitt...
The full-rate linear phase detector (PD) has not only phase detection capability but also single-sided frequency detection capability intrinsically. Previously, this fact has been discovered by researching the phase and frequency characteristics of t...
This paper presents the development of a peak-shaving equipment, composed by a multilevel converter in a cascaded H-bridge topology and battery banks on the DC links. Between specific time periods, when the demand is higher, the equipment injects act...
To monitor the position and profile of therapeutic carbon beams in real-time, in this paper, we proposed a system called HiBeam-T. The HiBeam-T is a time projection chamber (TPC) with forty Topmetal-II- CMOS pixel sensors as its readout. Each Topmeta...
Improved performance operational amplifier demand has continuously increased. IC designers use the charge pump technique as an advanced solution to implement the amplifier’s rail−to−rail input stage, but the need for a large load ca...
This work describes an energy-efficient monolithic Power Management Unit (PMU) that includes a charge pump adapted to photovoltaic cells with the capability of charging a large supply capacitor and managing the stored energy efficiently to provide th...
In this paper, we present a successive approximation register (SAR) analog-to-digital converter (ADC) with a charge-pump (CP) phase-locked loop (PLL) and a bootstrapped switch, also called PLL-SAR ADC. To meet system-on-chip (SOC) and industrial requ...
Micromachined gyroscopes require high voltage (HV) for actuation and detection to improve its precision, but the deviation of the HV caused by temperature fluctuations will degrade the sensor’s performance. In this paper, a high-voltage tempera...
An ultra-low-voltage low-power switched-capacitor (SC) delta-sigma (ΔΣ) modulator running at a supply voltage as low as 300 mV is presented for biomedical implant devices, e.g., cardiac pacemakers. To reduce the supply voltage, an inverter-based ampl...
A digital adaptive mismatch calibration (DAMC) circuit is proposed to decrease the output jitter of phase-locked loop (PLL). After amplifying the phase error with a linear time amplifier (TA), the DAMC adopts a successive approximation pulse width ca...
Two types of single-photon avalanche diodes (SPADs) with different diameters are investigated regarding their avalanche behavior. SPAD type A was designed in standard 0.35-µm complementary metal-oxide-semiconductor (CMOS) including a 12-µ...
Internet of Things (IoT) has enabled battery-powered devices to transmit sensitive data, while presenting high power consumption and security issues. To address these challenges, adiabatic-based physical unclonable functions (PUFs) offer a promising...
MEMS resonators have attracted attention for their wide applications in highly accurate clock references, sensors, wireless communications, frequency control, etc. Most of the output frequencies of MEMS resonators require post-processing or calibrati...
Interconnected transcriptional and translational feedback loops are at the core of the molecular mechanism of the circadian clock. Such feedback loops are synchronized to external light entrainment by the blue light photoreceptor cryptochrome (CRY) t...
Pack-side current, voltage and battery-state data can quantify charging episodes during driving, but an event-level model must not be credited for reconstructing its target from post-event electrical summaries. We re-examined 8181 negative-current in...
17 December 2023
A low-power and low-jitter 1.2 GHz Integer-N PLL (INPLL) is designed in a 65 nm standard CMOS process. A novel high-gain sampling phase detector (PD), which takes advantage of a transconductance (Gm) cell to boost the gain, is developed to increase t...
We propose a dual-channel interface architecture that allocates high and low transition-density bit streams to two separate channels. The transmitter utilizes the stacked drivers with charge-recycling to reduce the power consumption. The direct curre...
We present high-precision multi-configuration Dirac–Hartree–Fock (MCDHF) calculations for the metastable states of
In this paper, a pixel architecture that can be re-programmed to favor low noise, high speed, high dynamic range, or other characteristics desired in scientific imaging is proposed. Termed a programmable readout (PRO) pixel, this novel design combine...
We propose that gravitational interactions of cosmic neutrinos with the statistically homogeneous and isotropic fluctuations of space-time lead to decoherence. This working hypothesis, which we describe by means of a Lindblad operator, is applied to...
In this paper, the performance of the electronic conventional image motion compensation (IMC) method based on the time delay integration (TDI) mode was analyzed using the optical injection formula of charge coupled devices (CCDs). The result shows th...
Protected cultivation systems such as greenhouses are becoming increasingly popular globally and have been adopted because of unpredictable climatic conditions and their ability to easily control micro- and macroenvironments. However, limitations suc...
The time–energy uncertainty relation (TEUR) plays a fundamental role in quantum mechanics, as it allows the grasping of peculiar aspects of a variety of phenomena based on very general principles and symmetries of the theory. Using the Mandelst...
Precision laser spectroscopy of the 229-thorium nuclear isomer transition in a solid-state environment would represent a significant milestone in the field of metrology, opening the door to the realization of a nuclear clock. Working toward this goal...
Recently, shockwave food processing is drawing much attention as a low-cost non-thermal food process technique. In shockwave non-thermal food processing, underwater shockwaves are generated by a high voltage generator. Therefore, high inrush currents...
An architecture of a switched-capacitor integrator that includes a charge buffer operating in an open-loop is hereby proposed. As for the switched-capacitor filters, the gain of the proposed integrator, which is given by the input/output capacitor ra...
Content-addressable memory (CAM) performs a parallel search operation by comparing the search data with all content stored in memory during a single cycle, instead of finding the data using an address. Conventional CAM designs use a dynamic CMOS arch...
This paper presents a highly efficient, low-power, fully integrated neural stimulation circuit implemented using solely low-voltage devices. The circuit primarily consists of a high-voltage-generation circuit, an output driver circuit, and a constant...
As experts, scientists must inform the public and political actors about relevant topics by providing a well-balanced analysis and overview of existing as well as missing scientific evidence. Particularly in cases where evidence is not solid, they mu...
of 2