- Article
Spin–orbit interaction enables the generation and manipulation of spin currents without external magnetic fields, providing opportunities for spin–orbitronic devices. Here, we theoretically investigate a two-dimensional Rashba channel emb...
Spin–orbit interaction enables the generation and manipulation of spin currents without external magnetic fields, providing opportunities for spin–orbitronic devices. Here, we theoretically investigate a two-dimensional Rashba channel emb...
This paper presents a new analytical geometry optimization model to depict the optimal current sensitivity and signal-to-noise ratio (SNR) for the current-mode Hall devices. The conformal mapping calculation is performed to study the influence of dev...
Soft tactile sensors have been applied to robotic grippers for assembly. It is a challenging task to obtain contact information and object orientation using tactile sensors during grasping. Currently, the design of Hall-effect-based tactile sensors t...
Topological states of matter can be classified only in terms of global topological invariants. These global topological invariants are encoded in terms of global observable topological phase factors in the state vectors of electrons. In condensed mat...
The present paper focuses on various aspects regarding Hall Effect sensors’ design, integration, and behavior analysis. In order to assess their performance, different Hall Effect geometries were tested for Hall voltage, sensitivity, offset, and temp...
One of the essential needs of humans that is influenced by architectural geometry is visibility in indoor areas. Prayer hall geometry dominates the mosque typology and morphology. The spatial–volumetric shapes of interior prayer halls affect wo...
Scanning Hall probe microscopy is attractive for minimally invasive characterization of magnetic thin films and nanostructures by measurement of the emanating magnetic stray field. Established sensor probes operating at room temperature employ highly...
The spin Hall effect of light, referring to the spin-dependent and transverse splitting of light at an optical interface, is an interface-dependent phenomenon. In contrast to this commonly accepted statement, it has been recently reported that the sp...
This manuscript analyzes the effects of design parameters, such as aspect ratio, doping concentration and bias, on the performance of a general CMOS Hall sensor, with insight on current-related sensitivity, power consumption, and bandwidth. The artic...
Magnetic skyrmions are considered promising candidates for use as information carriers in future spintronic devices. To achieve the development of skyrmion-based spintronic devices, a reasonable and feasible nanotrack is essential. In this paper, we...
The quantum Hall effect is a paradigmatic example of topological order, characterized by precisely quantized Hall resistance and dissipationless edge transport. These edge states are chiral, propagating unidirectionally along the boundary, and their...
Microfluidic Hall-effect biosensors detect superparamagnetic bead labels as they flow past a thin-film Hall element in a microchannel. Designing one couples bead magnetization, stray-field distribution, Hall transport, and channel flow across 14 para...
The resistivity and the Hall effect in the copper-oxide high-temperature superconductor YBa
Atmosphere-breathing Hall thrusters (ABHTs) have emerged as a promising propulsion technology for very low Earth orbit (VLEO) satellites because they can utilize residual atmospheric particles as propellant, reducing the need for onboard propellant s...
Controlling spin dynamics conventionally requires external magnetic fields, strong electric bias, or material-specific spin–orbit interactions, while the temporal reference frame remains fixed. Here we introduce curved-time spintronics, a frame...
In this paper, we consider the topological abelian BF theory with radial boundary on a generic 3D manifold, as we were motivated by the recently discovered accelerated edge modes on certain Hall systems. Our aim was to research if, where, and how the...
Many acoustic studies have been carried out in the Italian theatres built during the 17th and 18th centuries. Along with the development of technology, acoustic measurements become increasingly more accurate, able to capture the faithful acoustic con...
Quantum anomalous Hall effect (QAHE) represents a quantized version of the classical anomalous Hall effect. In the latter case the magnetization takes over the role of magnetic field and induces nonzero off-diagonal elements in the conductivity matri...
We improved a magnetic scanning microscope for measuring the magnetic properties of minerals in thin sections of geological samples at submillimeter scales. The microscope is comprised of a 200 µm diameter Hall sensor that is located at a dista...
As proved by the studies carried out but also from practical situations, the acoustic behaviour of an enclosed performance hall is strongly dependent on occupancy level. This happens because human bodies and upholstered seats contribute significantly...
This paper describes the route, from simulations toward experiments, for optimizing the magnetoelectric (ME) geometries for vortex magnetic field sensors. The research is performed on the base of the Metglas/Piezoelectric (PZT) laminates in both open...
We investigate the photo-assisted charge-heat mixed noise and the heat noise generated by periodic drives in Quantum Hall states belonging to the Laughlin sequence. Fluctuations of the charge and heat currents are due to weak backscattering induced i...
In Roman Baths, the Romans employed barrel and groin vaults of great dimensions, with maximum span more than 20 m; simple tools of structural analysis of ancient wide span vaulted halls are still lacking, due to geometrical and material complexity. I...
Studies on two-dimensional materials (such as topological insulators or transition metal dichalcogenides) have shown that they exhibit unique properties, including high charge carrier mobility and tunable bandgaps, making them attractive for next-gen...
We investigate emergent conductive phenomena triggered by collinear antiferromagnetic orderings. We show that an up-down-zero spin configuration in a triangle cluster leads to linear and nonlinear spin conductivities even without the relativistic spi...
Splinting techniques are widely used in medicine to inhibit the movement of arthritic joints. Studies into the effectiveness of splinting as a method of pain reduction have generally yielded positive results, however, no significant difference has be...
An efficient solution strategy based on fluid network modeling, computational fluid dynamics (CFD) and discrete particle modeling (DPM) is presented in order to predict and improve air quality, specifically regarding breathing aerosol concentration,...
We study a structure consisting of two electrostatically interacting objects, a uniformly charged square nanoplate and a uniformly charged nanowire. A straightforward motivation behind this work is to introduce a model that allows a classical descrip...
The terahertz wave generation by spiral photoconductive antennas fabricated on low-temperature In0.5Ga0.5As films and In0.5Ga0.5As/In0.5Al0.5As superlattices is studied by the terahertz time-domain spectroscopy method. The structures were obtained by...
Within these studies the piezoresistive effect was analyzed for 6H-SiC and 4H-SiC material doped with various elements: N, B, and Sc. Bulk SiC crystals with a specific concentration of dopants were fabricated by the Physical Vapor Transport (PVT) tec...
This paper investigates the design optimisation of a magnetic field based soft tactile sensor, comprised of a magnet and Hall effect module separated by an elastomer. The aim was to minimise sensitivity of the output force with respect to the input m...
Black phosphorous (BP) is one of the important emerging two-dimensional systems. We have undertaken a structural investigation of BP in the temperature range of 320 K to 85 K using synchrotron X-ray diffraction (XRD) studies. The XRD pattern of BP is...
This paper introduces a novel contactless sensing principle conceived for measuring the rotation angle of a shaft. The sensor is based on a smart combination of low-cost components that can be effectively integrated in a mechanical assembly of a rot...
We investigate the band structures and transport properties of a zigzag-edged bent bilayer graphene nanoribbon under a uniform perpendicular magnetic field. Due to its unique geometry, the edge and interface states can be controlled by an electric fi...
A trace acetylene (C2H2) detection system was demonstrated using the cavity-enhanced absorption spectroscopy (CEAS) technique and a near-infrared distributed feedback (NIR-DFB) laser. A Fabry–Perot (F–P) cavity with an effective optical p...
Extreme ultraviolet (EUV) pellicles must withstand intense thermal stress during exposure due to their limited heat dissipation, which results from their ultrathin geometry and the vacuum environment within EUV scanners. To address this challenge, we...
In recent years, antiferromagnetic kagome materials have attracted considerable attention in condensed matter physics owing to their distinctive lattice geometry. In this work, high-quality single crystals of D019-structured Mn2.16Ga were grown using...
Screw-drive in-pipe robots are widely used for inspection and maintenance of pipeline infrastructure because their tilted-wheel locomotion enables continuous traversal of horizontal, vertical, and curved pipes. However, most existing designs rely on...
Steel joints made out of circular hollow section profiles are used for many fields of applications, such as wide-span or representative halls for airports. By connecting two inclined pipes to a vertical third pipe, a ramified vertical column is creat...
Steel hollow section joints are mainly used for offshore structures, hall support or trusses. Current standards define different kinds of steel joints, but there are limitations regarding the geometry or load scenarios. Excluded joints are full-overl...
Sp2-hybridized monolayer semiconductors (e.g., planar group III-V and IV-IV binary compounds) with inversion symmetry breaking (ISB) display piezoelectricity governed by their σ- and π-bond electrons. Here, we studied their bond-orbital-reso...
The material science of additive manufacturing (AM) has become a significant topic due to the unique way in which the material and geometry are created simultaneously. Major areas of research within inorganic materials include traditional structural...
The spin-Seebeck effect (SSE) is an advective transport process traditionally studied in bilayers composed of a ferromagnet (FM) and a non-magnetic metal (NM) with strong spin-orbit coupling. In a temperature gradient, the flux of magnons in the FM t...
Magneto-optical response in quantum materials is typically treated as a deterministic consequence of fixed electronic band structure and Berry curvature. Halide perovskites, however, exhibit dynamic lattice disorder, ionic fluctuations, and local sym...
Examinations are typically used by educational institutions to assess students’ strengths and weaknesses. Unfortunately, exam malpractices like cheating and other forms of academic integrity violations continue to present a serious challenge to...
We study thrust production in a single-fluid magnetohydrodynamic (MHD) thruster with Hall-type coaxial geometry and show how velocity–field alignment and magnetic topology set the operating regime. Starting from the momentum equation with aniso...
Xiegong is a unique element of Chinese historic buildings that could date the heritage dynasty. It is more complicated than the Dougong and represents a high level of artistic and structural achievement. Archaeological research on Xiegong is urgent d...
Soft sensors are essential for robotic systems to safely interact with humans and the environment. Although significant research has been carried out in the field of soft tactile sensing, most of these sensors are restricted to a predefined geometry...
Liquivac pumps, with their unique shaped twin start helical rotor, have found utility in various sectors but the major drawback limiting in their global exploitation is their low performance. This paper investigates the study of performance of the Li...
The geometric configuration of curved roofing elements in historic structures provides valuable evidence of the design knowledge and construction practices of their respective periods. This study examines the geometric and proportional organization o...
of 2