This work reports the dielectric behavior of the biopolymer ethyl cellulose (EC) observed from transient currents experiments under the action of a direct current (DC) electric field (~107 V/m) under vacuum conditions. The viscoelastic response of th...
This paper introduces the implementation of a DC–AC step up isolated converter from associations of bidirectional Conversion Standard Cells (CSCs). The designed multi-cell converter is an array of standardized converter cells. It is described a...
Olivine-like NaFePO4 glasses and nanocomposites are promising materials for cathodes in sodium batteries. Our previous studies focused on the preparation of NaFePO4 glass, transforming it into a nanocomposite using high-pressure–high-temperatur...
This paper investigates the effect of the ratio of ammonium nitrate (AN) on the structural, microstructural, magnetic, and alternating current (AC) conductivity properties of barium hexaferrite (BaFe12O19). The BaFe12O19 were prepared by using the sa...
The AC conductivity response of disordered materials follows a universal power law of the form
Semiconductor materials based on metal high crosslinked-vinyl polymer composites were prepared through loading of Pd(OAc)2 on both Poly(ethylene-1,2-diyl dimethacrylate) (poly(EDMA)) and poly(ethylene-1,2-diyl dimethacrylate-co-methyl methacrylate) (...
This study investigates the feasibility of using a wearable system with full-wave alternating current (AC) excitation to measure electrodermal activity (EDA). Typically measured using direct current (DC) excitation, EDA is often affected by signal dr...
This paper documents the manufacture and testing of a humidity sensor based on a combination of In2O3/SiO. A number of different sensor samples have been produced by thermal deposition and the effect of varying the vacuum pressure has also been inves...
In variable speed applications, the cycloconverter-based AC to AC power conversion technique has gained more attention among researchers and academics than the traditional rectifier-inverter-based AC to AC power conversion process. The conventional r...
In this study, the role of ion dissociation on formation of silver nanoparticle and DC conductivityin PVA:AgNO3 based solid polymer electrolyte has been discussed in detail. Samples of silver ion conducting solid polymer electrolyte were prepared by...
As a contribution to the graphene-based nanoferrite composites, this article is intended to present Mn, Co, and Co-Mn nanoferrites for the preparation and investigation of such samples. Nanoparticles of Co ferrite, Mn ferrite, and Co-Mn ferrite were...
In coastal hot and humid regions, the steel pin of AC porcelain insulators often suffers from severe electrochemical corrosion due to surface contamination and moisture, leading to insulator string breakage. Contrary to the common belief that AC corr...
Two ceramic samples of sodium tantalate (NaTaO3), doped with metal ions of copper (Cu; sample S1) or aluminum (Al; sample S2), were obtained by the sol-gel method. Complex impedance measurements in the frequency range (200 Hz–2 MHz) and at temp...
The goal of this paper is to study the effects of gamma irradiation and samples’ aging on the AC-electrical properties of hybrid epoxy resin as a function of frequency, temperature, and (zinc oxide) ZnO content (0, 0.049, 0.099, 0.149, and 0.19...
In this work, the role of poly(vinyl alcohol) (PVA) blending on structural and electrical properties of chitosan:silver nitrate systems is studied. The X-ray diffraction (XRD) results show that the crystalline phase of chitosan (CS) is greatly scarif...
The effects of gamma radiation on the AC electrical properties of highly cross-linked epoxy resin/bisphenol A-based polycarbonate samples have been investigated as a function of concentrations of bisphenol A-based polycarbonate, frequency, and temper...
In this work, the influence of semi-conductive SiC nanoparticles on the AC breakdown voltage and partial discharge development in natural ester oil FR3 is examined. Primarily, the dielectric constant and the electrical conductivity of the nanoparticl...
In the present work, chitosan (CS) as a natural biopolymer was used to prepare nanocomposite polymer electrolytes (NCPEs) in order to reduce plastic waste pollution. The plasticized CS-based NCSPE has been prepared via the solution casting technique....
This paper presents a test stand for testing alternating current electrical parameters of Cu–SiO2 multilayer nanocomposite structures obtained by the dual-source non-reactive magnetron sputtering method (resistance, capacitance, phase shift ang...
Polypyrrole (PPy)-doped bismuth calcium manganite (BCM) nanocomposites were synthesized by chemical polymerization. The amorphous nature of the polypyrrole and the monoclinic crystal structure of the BCM particles (35–65 nm) were confirmed by v...
Chitosan (CS) films doped with sodium triflate (NaTf) were prepared by the solution cast technique. The structural and morphological behaviors of the samples were examined by X-ray diffraction (XRD) and scanning electron microscopy (SEM) techniques....
The electronic states in flat bands possess zero group velocity and null charge mobility. Recently, flat electronic bands with fully localized states have been predicted in nanowires, when their hopping integrals between first, second, and third neig...
This study addresses the effect of nanoparticles’ conductivity and surface charge on the dielectric performance of insulating nanofluids. Dispersions of alumina and silicon carbide nanoparticles of similar size (~50 nm) and concentration (0.004% w/w)...
In this study, silver nanoparticles (Ag NPs) were synthesized on the surface of rutile-phase titanium dioxide (R-TiO2) using a plasma-assisted technique. Comprehensive analyses were conducted to investigate the structural, morphological, optical, and...
In this work, new samples of PVA-TiO2/Cu nanocomposites were prepared via the casting method. The prepared samples were examined using different analytical methods. An XRD analysis showed the semi-crystalline nature of the PVA polymer, as well as sho...
EMC simulations are an indispensable tool to analyze EMC noise propagation in power converters and to assess the best filtering options. In this paper, we first show how to set up EMC simulations of power converters and then we demonstrate their use...
In this work, nickel oxide nanoparticles (NiO NPs) were synthesized sonochemically in the ionic liquid 1,2-(propanediol)-3-methylimidazolium hydrogen sulfate ([PDOHMIM+][HSO4−]) at different loadings (8 wt.%, 15 wt.%, and 30 wt.%), and subseque...
This paper reports on modelling outcomes for improvements to building energy performance in Indonesia. Long-term climate effects due to building energy demand and carbon emissions are also considered. The global change assessment model (GCAM) was use...
High thermal conductivity insulating dielectrics with good electrical properties have received widespread attention due to the continuous development of power systems and power electronic technologies. In this paper, the effects of differently struct...
In this work, orthorhombic (α-BiNbO4) and triclinic bismuth niobate (β-BiNbO4) ceramics were prepared by a wet chemical route. The structure of the obtained powders was characterised by X-ray diffraction and the morphology by scanning elec...
This study proposes and implements a DCHC-based CRM/CCM hybrid control with a switching-period limit condition to improve light-load efficiency in an AC-coupled ESS power converter. In grid-connected ESSs, the operating point continuously varies depe...
A pure ferrite and epoxy samples as well as the epoxy/ferrite composites with different 20 wt.%, 30 wt.%, 40 wt.%, and 50 wt.% weight ferrite contents have been prepared by the chemical co-precipitation method. AC-conductivity and dielectric properti...
Thin film microfabrication technique was employed to fabricate a platinum based parallel-electrode structured impedance sensor. Electrochemical impedance spectroscopy (EIS) and equivalent circuit analysis of the small amplitude (±5 mV) AC impedance m...
The slow solvent evaporation approach was used to create a single crystal of (C7H6N3O2)2[ZnCl4] at room temperature. Our compound has been investigated by single-crystal XRD which declares that the complex crystallizes in the monoclinic crystallograp...
The compounds LiCo1−xMnxO2 (x = 0.5, 0.7) were synthesized via the solid-state method and exhibited crystallization in the cubic spinel structure (space group Fd-3m). UV–Vis spectroscopy reveals strong visible-light absorption and a reduc...
In this paper, the structural, microstructural, thermal, electrical, and dielectric properties of synthesized ZnS nanoparticles are studied using the co-precipitation technique. The precipitate was characterized using X-ray diffraction (XRD). Charact...
Nanocomposite materials have recently attracted great attention for their wide range of applications, such as in smart materials, flexible electronics, and deformation sensing applications. Such materials make it possible to combine a polymer with fu...
Magnetic nanoparticles of NiFe2O4 were successfully prepared by utilizing the sol–gel techniques. The prepared samples were investigated through various techniques such as X-ray diffraction (XRD), transmission electron microscopy (TEM), dielect...
We report a quasi T-channel electrokinetics-based micromixer with electrically conductive sidewalls, where the electric field is in the transverse direction of the flow and parallel to the conductivity gradient at the interface between two fluids to...
Epoxy nanocomposites reinforced with various grades of multilayer graphene nanoplatelets (GNPs) are manufactured and tested. The effects of size, surface area, and concentration of GNP, as well as alternating current (AC) frequency on the electrical...
This paper is aimed at studying the influence of conducting (Fe3O4), semi-conductive (ZnO), and insulating (ZrO2, SiO2, and Al2O3) nanoparticles (NPs) at various concentrations on the AC dielectric strength of MIDEL 7131 synthetic ester (SE) and part...
The authors of numerous measurements of conductivity for suspensions of nanoparticles of various types carried out in the last decade came to the general conclusion that the well-known Maxwell’s theory is not applicable to quantitative explanat...
Relatively new double perovskite material, Sr2CaTeO6, has been prepared through conventional solid-state procedures. Structural, dielectric, and optical characteristics of this exquisite solid-state material were analysed in this study. The single-ph...
This paper presents the design, simulation, and experimental evaluation of a low-cost, fixed-step MPPT algorithm based on the incremental conductance technique for operation in a low-power photovoltaic (PV) system with a full-bridge DC-AC converter....
Background: Ticagrelor is a reversible, direct inhibitor of the platelet adenosine diphosphate (P2Y12) receptor, widely used in combination with acetylsalicylic acid (ASA) as dual antiplatelet therapy (DAPT) in patients with acute coronary syndrome (...
By using the low loading of the conductor filler to achieve high conductivity is a challenge associated with electrically conductive adhesion. In this study, we show an assembling of nickel-coated polystyrene (Ni@PS) microspheres into 3-dimensional n...
There is an urgent need for the development of elastic dielectric materials for flexible organic field effect transistors (OFETs). In this work, detailed analysis of the AC and DC electrical conductivity of a series of flexible poly(dimethylsiloxane)...
The study determines the frequency–temperature dependence of the conductivity of a moist solid insulation component of power transformers, impregnated with the innovative bio-oil NYTRO® BIO 300X, manufactured from plant-based raw materials....
We systematically studied the electromagnetic properties of carbon nanohorns (CNHs) and polystyrene composites filled with CNHs in static regime, low frequency and microwave regions. CNHs were synthesized using the direct current arc-discharge method...
The vast applicability of spinel cobalt ferrite due to its unique characteristics implies the need for further exploration of its properties. In this regard, structural modification at the O-site of spinel with Li1+/Zn2+ was studied in detail for exp...
of 48