- Article
A highly linear fully self-biased class AB current buffer designed in a standard 0.18
A highly linear fully self-biased class AB current buffer designed in a standard 0.18
Carbon doping in the buffer of AlGaN/GaN high-electron-mobility transistors (HEMTs) leads to the notorious current collapse phenomenon. In this paper, an HEMT structure with a source-connected p-GaN (SCPG) embedded in the carbon-doped semi-insulating...
The water-blocking buffer layer of high-voltage cross-linked polyethylene (XLPE) power cables is prone to degradation during long-term operation due to factors such as moisture and ablation. The degradation may cause an increase in leakage current, w...
The peak voltage depending on the load current can be affected by the external capacitors installed in the output stage of the LDO regulator. However, the capacitor-less LDO regulator proposed in this study was applied a current driving buffer struct...
Current Differencing Buffered Amplifiers (CDBAs) are a critical class of analog circuit components capable of handling both current and voltage signals with minimal power consumption. Due to their low impedance voltage output, they play a significant...
This paper introduces an innovative low-voltage, low-power current differencing buffered amplifier (CDBA). The proposed CDBA utilizes a bulk-driven MOS transistor operating in the subthreshold region, allowing it to function effectively at low supply...
A low leakage poly-Si thin film transistor (TFT) is proposed featuring hydrogenated amorphous silicon (a-Si:H) buffer layer and source/drain extension (SDE) by using technology computer aided design (TCAD) simulation. This architecture reduces off-cu...
We investigated the effects of GaN buffer resistance of AlGaN/GaN high-electron-mobility transistors (HEMTs) on direct current (DC), low-frequency noise (LFN), and pulsed I-V characterization performances. The devices with the highest GaN buffer resi...
A systematic study of epi-AlGaN/GaN on a SiC substrate was conducted through a comprehensive analysis of material properties and device performance. In this novel epitaxial design, an AlGaN/GaN channel layer was grown directly on the AlN nucleation l...
With the increasing number of failures in high-voltage cross-linked polyethylene cables caused by buffer layer ablation, it is of great significance to investigate the electro–thermal coupling characteristics and ablation driving mechanisms und...
The buffer and surface trapping effects on low-frequency (LF) Y-parameters of Fe-doped AlGaN/GaN high-electron mobility transistors (HEMTs) are analyzed through experimental and simulation studies. The drain current transient (DCT) characterization i...
This research proposes the design of a mooring system that allows the floating platform to stably dive deep enough to prevent damage induced by typhoon waves. The design principle of the mechanism is that the submarined floating platform with negativ...
This research proposes a mooring design which keeps the turbine ocean current, static, balanced, and fixed at a predetermined depth under water, to ensure that the ocean current generator can effectively use current to generate electricity, and that...
This research proposes a mooring system for an ocean current generator that is working under the impact of typhoon waves. The turbine and the platform are kept stable at a designed water depth to ensure that the generator remains undamaged and contin...
This paper presents a driver amplifier with high bandwidth-power efficiency, high capacitor-driving capacity, and low total harmonic distortion (THD). One complementary differential pair composed of self-cascode transistors is incorporated to obtain...
The multiseeding technique is a method to grow large-sized REBa2Cu3O7−δ (REBCO, where RE is a rare earth element) high temperature superconducting bulks. However, due to the existence of grain boundaries between seed crystals, the superco...
The application of the flipped voltage follower to implement two high-performance circuits is presented: (1) The first is a class AB cascode flipped voltage follower that shows an improved slew rate and an improved bandwidth by very large factors and...
Low-power electric all-terrain vehicles (ATVs) experience repeated acceleration, grade-driving, and regenerative-braking events that impose high transient current demand on the battery pack. This study presents a reduced-switch battery/supercapacitor...
Shock loads can pose a great threat to personnel or instruments, and efficient control of the buffering process is an effective means of reducing damage from shock energy. In this paper, magneto-rheological grease was used as the internal controllabl...
In this paper, an electromagnetic variable valve train with a magnetorheological buffer (EMVT with MR buffer) is proposed. This system is mainly composed of an electromagnetic linear actuator (EMLA) and a magnetorheological buffer (MR buffer). The va...
A high-slew-rate, low-power, CMOS, rail-to-rail buffer amplifier for large flat-panel-display (FPD) applications is proposed. The major circuit of the output buffer is a rail-to-rail, folded-cascode, class-AB amplifier which can control the tail curr...
The downstream process of monoclonal antibodies (mAbs) is expensive and significantly contributes to overall manufacturing costs. One primary reason is the extensive consumption of water and chemicals required for preparing large volumes of various b...
Aiming at the problem that the current double direction buffering algorithm is easy to use to seal the “bottleneck” area when simplifying coastlines, an adaptive simplification method for coastlines using a skeleton line “bridge&rdq...
The influences of gold nanoparticles (GNPs) and the buffer layer on the performance of organic light-emitting diodes are investigated in this study. The GNPs are doped into poly (3,4-ethylenedioxythiophene)-poly(styrenesulfonate) (PEDOT:PSS) and the...
In this paper, we present a CMOS rail-to-rail second-generation voltage conveyor (VCII) suitable for low power applications, implemented in 180 nm CMOS technology with a supply voltage of ± 0.9 V. The proposed VCII consists of a current and vo...
In an Sb2Se3-based solar cell, the buffer layer is sandwiched between the absorber and the window layer, playing an essential role in interfacial electricity. Generally, CdS is used as a buffer layer, but its toxic nature and low bandgap can cause cu...
Limited hardness and corrosion resistance restrict 7050 aluminum alloys in aggressive environments. Cr coatings, applied as single layers or over Ti, Al, or Ni buffer layers, were deposited onto 7050 aluminum alloy by direct-current magnetron sputter...
This paper presents an incremental second-order delta-sigma modulator with a coarse-fine input buffer in 180-nm CMOS. The modulator’s architecture was implemented as a second-order cascade of integrators with a feedback structure. The switched-...
In this work, step-graded AlGaN buffer layers were introduced into GaN high-electron-mobility transistors to enhance their off-state voltage-blocking capability without intentional deep-level buffer doping. Hall measurements showed increased two-dime...
The high electron mobility transistor (HEMT) structures on Si (111) substrates were fabricated with heavily Fe-doped GaN buffer layers by metalorganic chemical vapor deposition (MOCVD). The heavy Fe concentrations employed for the purpose of highly i...
In this work, a single-crystalline silicon nanobelt field-effect transistor (SiNB FET) device was developed and applied to pH and biomolecule sensing. The nanobelt was formed using a local oxidation of silicon technique, which is a self-aligned, self...
The buffer zone of a historical or cultural heritage always surrounds the core protected area of the heritage. Currently, there are no mature or universally applicable methods for buffer zone delineation. This study examines the historical and cultur...
This paper presents safety-related modifications to the improved high-voltage unity-gain buffer and their impact on the operation quality of this circuit. The analyzed buffer architecture combines the virtues of source and gate followers. It provides...
This paper analyzes the results of a trial operation of a battery-based buffer station supporting a selected section of trolleybus power supply systems in Pilsen, Czech Republic. The buffer station aims to prevent the catenary from excessive voltage...
In this study, a 50-nm Al0.05Ga0.95N back barrier (BB) layer was used in an AlGaN/GaN high-electron-mobility transistor between the two-dimensional electron gas channel and Fe-doped/C-doped buffer layers. This BB layer can reduce the channel layer. T...
The clutch is currently developing towards high power, high stability, and intelligent operation. The traditional hydraulic buffering valve mostly uses a passive hydraulic buffer valve or a high speed on-off valve and a proportion valve. It has a sin...
The vortex-induced vibration (VIV) dynamics of commercial-scale deep-sea mining risers with complex component arrangements (pumps, buffer stations, buoyancy modules) remain insufficiently explored, especially for 6000 m systems with nonlinear tension...
This work investigates the transient characteristics of an AlGaN/GaN lateral Schottky barrier diode (SBD) and its recovery process with a dedicated dynamic measurement system. Both static and dynamic characteristics were measured, analyzed with the c...
Parasitic oscillations in the rectifier diode voltage of phase-shifted-full-bridge (PSFB) converters limit their application in high-voltage and high-power situations. The conventional analysis method for parasitic oscillation in rectifier diode volt...
Heteroepitaxial growth of β-Ga2O3 thin films on Si for solar-blind ultraviolet photodetectors faces severe challenges due to lattice mismatch and interfacial oxidation, leading to high dark current and low responsivity. In this work, β-Ga2O...
Enhancing energy efficiency is essential for proton exchange membrane fuel cells (PEMFCs) operating in a dead-ended anode (DEA) mode. This study proposes the integration of a buffer tank, positioned between the mass flow meter and the fuel cell, to r...
In mobile short-form video streaming, the video application usually provides the user with a playlist of recommended videos to be played one by one. In order to prevent playback stalls caused by possible fluctuations in the mobile network, after fini...
The continuity of food production and improved food security largely depend on the climate change risk-hedging mechanisms that food system stakeholders, such as farmers, build as buffers against adverse climatic conditions. Farmers’ financial b...
A high emission current with relatively low operating voltage is critical for field emission cathodes in vacuum electronic devices (VEDs). This paper studied the field emission performance of single-wall carbon nanotube (SWCNT) cold cathodes prepared...
The electrochemical behaviors of thiazolidine (tetrahydrothiazole) on gold and platinum electrodes were investigated in a Britton-Robinson buffer (pH 2.77–11.61), acetate buffer (pH 4.31), phosphate buffer solutions (pH 2.11 and 6.38) and methanol or...
In this work we present the preparation and characterization of cerium doped lanthanum zirconate (LCZO) films and non-stoichiometric lanthanum zirconate (LZO) buffer layers on metallic Ni-5% W substrates using chemical solution deposition (CSD), star...
23 May 2023
Evidence suggests that intimate partner violence (IPV) is associated with negative mental health outcomes. There is currently limited research on the impact of IPV on the outcomes of mental health for transgender women. The current study aimed to exa...
The issue of agricultural non-point source pollution has attracted global attention. A buffer zone is an effective, eco-friendly, and economically feasible remediation ecosystem to reduce the impact of agricultural non-point source pollution on water...
Buffer stops have always been installed on blind tracks to mitigate the hazards associated with overruns due to insufficient or wrong braking. Conventional buffer stops fixed to the rails may absorb only limited energy while Energy-Absorbing Buffers...
Overshoot and undershoot caused by the current load impact the accuracy of the required output voltage and circuit performance. The transient response issue in existing low-dropout (LDO) regulators is a dynamic specification that must be addressed at...
of 28