Power generation systems (PGSs) based on renewable energy sources are finding ever-widening applications, and many researchers work on this problem. Many papers address the problem of transformerless PGSs, but few of them aimed at conducting research...
Measurements and simulations of common-mode (CM) current in a commercial ABB TERRA 54CJ 50 kW electric vehicle fast charger are presented. Three-phase and neutral currents were measured using a Chauvin-Arnoux C.A 8336 power analyzer equipped with fou...
Capacitor voltage imbalance among submodules in energy storage modular multilevel converters (MMCs) can lead to current distortion, power oscillations, and even system instability. Traditional voltage control strategies, inherited from non-storage MM...
In this paper, the modeling methodology of the AC drive system with a Parallel Quasi-Resonant DC Link Inverter (PQRDCLI) is described. A presented modeling approach is an attractive tool used for the effective evaluation of a common-mode (CM) voltage...
The existence of high-frequency components in common-mode (CM) current would reduce the stability of a non-isolated PV grid-connected system. It has great impacts on the output power quality when the generated power from PV is low. The method of sing...
Suitable space vector modulation (SVM) with reduced high-frequency common-mode voltages (HF-CMVs) for grid-connected current-source inverters (CSIs) have not been well investigated yet. In this study, the potential of active zero-state SVM (AZS-SVM)...
This paper proposes a space vector modulation (SVM)-based common-mode (CM) currents reduction method of an H8 inverter for permanent magnet synchronous motor (PMSM) drives. There are power quality issues in the PMSM drive systems, such as current dis...
In this paper, a switched-capacitor multilevel inverter with voltage boosting and common-mode-voltage reduction capabilities is put forth. The proposed inverter is synthesized with one-half bridge and several switched-capacitor cells. Due to the volt...
In high-frequency 400 V/48 V matrix planar LLC resonant converters for data center power supplies, enlarged interwinding parasitic capacitance can induce significant transformer-related common-mode (CM) displacement currents. However, the effects of...
Grid voltage imbalance conditions often occur. Modular multilevel rectifiers (MMCs) have high DC-link voltage fluctuation under an unbalanced grid, which affects the normal operation of DC-side equipment. To suppress voltage fluctuation under an unba...
The electrification of mobility sectors, including automotive, aerospace, and robotics, has accelerated the need for compact and high-efficiency power converters in electric motor drives. Wide-bandgap (WBG) semiconductor–based inverters offer s...
High switching frequency and fast switching speed of wide bandgap power semiconductor device-based power converters may increase radiated emissions more than conventional silicon-power device-based power converters. Based on the background, this arti...
The output LC filter of a photovoltaic (PV) string three-level grid-tied inverter that connects the filter capacitor neutral point to dc-link capacitor neutral point can reduce the common-mode (CM) current injected to the grid by letting the CM curre...
Power inverters produce common mode voltage (CMV) and common mode current (CMC) which cause high-frequency electromagnetic interference (EMI) noise, leakage currents in electrical drives application and grid-connected systems, which consequently drop...
The silicon carbide (SiC) inverter brings great advantages to the motor drive systems of new energy vehicles; however, severe challenges to the bearings also happen. The high dc bus voltage and switching frequency of SiC inverter can increase the dis...
Pulse Width Modulated (PWM) voltage source inverters are widely used to power induction motors in industrial applications. However, they generate common-mode voltage (CMV), which induces high shaft voltages and bearing currents, leading to premature...
Photovoltaic (PV) electricity is widely used because of its positive environmental impact. To properly feed this energy into the grid, an electronic power converter, known as a PV inverter, is needed, which may or may not use a transformer. This arti...
A low-noise and -power readout integrated circuit (IC) for two-electrode electrocardiogram (ECG) recording is developed in this study using a common-mode charge pump (CMCP) for a robust 20-VPP common-mode interference (CMI). Two-electrode ECG recordi...
Power conversion equipment based on high-voltage SiC devices offers significant advantages in efficiency and power density. However, during high-voltage, high-power switching operations, severe electromagnetic interference (EMI) can easily occur. It...
A common-mode voltage (CMV) suppression strategy, namely double zero-sequence injection common-mode voltage (DZICMV), is proposed in this paper for an asymmetrical six-phase induction motor fed by two-level dual three-phase voltage source inverters (...
This paper presents a power line interference (PLI) reduction technique with a current-reused current-feedback instrumentation amplifier (CFIA) for electrocardiogram (ECG) recording. In a portable two-electrode ECG monitoring application, the presenc...
Wind energy integration in power grids is increasing day by day to reduce the use of fossil fuels, and consequently greenhouse gas emissions. Using the pulse-width modulated (PWM) power converters in wind turbine generators, specifically in doubly-fe...
The use of the common mode current for stator winding insulation condition assessment has been extensively studied. Two main approaches have been followed. The first models the electric behavior of ground-wall insulation as an equivalent
This paper analyzes a Digital Signal Processor (DSP) based One Cycle Control (OCC) strategy for a Power Factor Corrector (PFC) rectifier with Common-mode Voltage (CMV) immunity. It is proposed a strategy that utilizes an emulated-resistance-controlle...
This work deals with circuit modeling of noise mode conversion due to system asymmetry in a three-phase motor drive system. In fact, it is well-known that in case of system asymmetry (e.g., slightly asymmetrical LC filter parameters), differential-mo...
In order to achieve high accuracy in interferometric direction-finding systems, antennas with a stable phase center in the working bandwidth are required. This article proposes a miniaturized loaded open-boundary quad-ridge horn (LOQRH) antenna with...
In this paper, a comprehensive double-vector approach is proposed to alleviate the common-mode voltage of voltage-source inverters based on a model predictive control scheme. Only six active vectors are selected to alleviate the common-mode voltage....
For the grid-connected photovoltaic inverters, the switching-frequency common-mode voltage brings the leakage current, which should be eliminated. So far, many kinds of single-phase inverters have been published for this purpose, but most of them are...
The conventional carrier phase-shifted pulse-width modulation strategy may cause asymmetric output phase voltages in a modular multilevel converter (MMC)-based static var generator, leading to high-frequency variations in the system common-mode volta...
In grid-connected photovoltaic (PV) systems, a transformer is needed to achieve the galvanic isolation and voltage ratio transformations. Nevertheless, these traditional configurations of transformers increase the weight, size, and cost of the invert...
In this study, a current-equalization technology utilizing a variable-capacitance technique for a multiphase inductor–inductor–capacitor (LLC) converter is studied. Accordingly, the proposed method involves adjusting the resonant capacita...
Photovoltaic (PV) energy systems have found diverse applications in fulfilling the increasing energy demand worldwide. Transformer-less PV inverters convert the DC energy from PV systems to AC energy and deliver it to the grid through a non-isolated...
The present paper deals with a review on bearing currents in electrical machines, with major emphasis on mechanisms, impacts, and mitigation strategies. High-frequency common-mode voltages from the inverter-driven system have been found to be the mai...
In this work, we introduce the design of a 16-channel in-pixel neural analog front end that employs a current-based summing approach to establish a common-mode feedback loop. The primary aim of this novel structure is to enhance both the system commo...
Fast-switching transients and high dv/dt associated with PWM inverters exacerbate the reflected-wave effects in the motor feeder cable. This leads to higher motor-side overvoltages, which increase the stress on the motor winding insulation, potential...
This paper presents a single-phase transformerless bidirectional power factor corrector (PFC). A capacitor is inserted into a conventional full-bridge PFC by connecting the ac line terminal and a terminal of DC voltage. The functions of this inserted...
With an emphasis on common-mode voltage (CMV) and leakage current suppression, this research offers a thorough examination of three-phase, two-level buck inverter topologies for transformerless (TL) grid-tied photovoltaic (PV) systems. A comprehensiv...
In transformerless grid-connected photovoltaic (PV) systems, leakage currents should be properly addressed. The voltage fluctuations between the neutral point of the grid and the PV array, i.e., common-mode voltage (CMV), will affect the value of the...
The high frequency PWM voltage pulses from a two-level six-switch inverter produce a common-mode voltage in an electric machine’s windings, a fraction of which appears on the machine shaft due to electrostatic (capacitive) coupling. When the sh...
This study proposes an adaptive high-frequency injection method (AHFI) aimed at mitigating common-mode voltage (CMV) on the AC side and alleviating current stress on power semiconductor devices within each arm of a medium-voltage motor propulsion sys...
Inverters with Quasi-Z-Source Networks (QZSN) provide DC-DC boosting and DC-AC conversion in a single stage. It offers reduced cost, complexity, and volume compared with the classical two-stage conversion system, which is composed of a boost converte...
Induction motors are popularly used in various applications because of the proposed modest construction, substantiated process, and limited size of specific power. The traditional AC traction drives are experimentally analyzed. There is a high circul...
Common mode currents on antenna feeders usually occur when feeding a symmetric radiator through an asymmetric line, or when the ground plane is electrically small. Such currents may have magnitudes comparable to the feed currents and therefore have a...
This paper investigates the influence of power semiconductor parasitic components on the ground leakage current in the three-phase Current Source Inverter topology, in the literature called H7 or CSI7. This topology allows reducing converter conducti...
Several industrial applications rely on induction motors to carry out processes essential for product manufacturing. Speed control of an induction motor commonly requires a pulse width modulated inverter capable of driving a system with long cables,...
This paper proposes a new hybrid modulation mode (HMM) to eliminate the zero-crossing distortion of grid current and enable reactive power provision for a H6 configuration PV (photovoltaic) grid-tied inverter. The common mode voltage, leakage current...
Compared with isolated converters, transformerless converters are a preferred choice in low-voltage grids due to their efficiency and lower cost. However, leakage current and common mode (CM) voltage appear through the converter and ground in hybrid...
This paper presents a low-power photoplethysmography (PPG) readout system designed for wearable health monitoring. The system employs a differential current mirror (DCM) to convert single-ended PPG currents into differential voltages, inherently supp...
In this survey paper, typical solutions that focus on the reduction in negative effects resulting from the common-mode voltage influence in AC motor drive applications are re-examined. The critical effectiveness evaluation of the considered methods i...
A modified architecture of a comparator to achieve high slew rate and boosted gain with an improvement in gain design error is introduced and investigated in this manuscript. It employs the conventional architecture of common-mode current feedback wi...
of 15