Talaromyces sp. DC2 is an endophytic fungus that was isolated from the stem of Catharanthus roseus (L.) G. Don in Hanoi, Vietnam and is capable of producing vinca alkaloids. This study utilizes the PacBio Sequel technology to completely sequence the...
Conventional unidirectional DC-DC converters for DC grid application employ DC-AC-DC two-stage conversion technology and suffer from high converter cost and power loss. To solve these issues, a unidirectional step-up DC-DC autotransformer (UUDAT) and...
This article presents a novel impedance-source-based direct current (DC)-to-alternating current (AC)/DC converter (Z-Source DAD Converter). The Z-Source DAD converter converts the input DC voltage into AC or DC with buck or boost in the load voltage....
Raising the electrification ratio to 100% is still a formidable challenge in Indonesia, especially in the remote areas of the eastern part of the archipelago. A DC microgrid system is one of the most viable solutions to increase the electricity suppl...
The constant increase in electrical energy consumption has led to a growth of photovoltaic installations (PV) along with the corresponding power converters for proper operation. Power electronics converters represent a challenge to maintain the syste...
In DC microgrids, distributed energy storage plays a key role in stabilizing the DC bus voltage. The bidirectional DC/DC converter in the distributed energy storage system should be designed according to the voltage level and electromagnetic isolatio...
This paper has two aims. The first is to develop a robust hierarchical tracking controller for the DC/DC Buck-Boost–inverter–DC motor system. This controller considers a high level control for the inverter–DC motor subsystems and a...
Offshore wind farms (OWFs) integration are attractive extensively for furnishing more robust power than land wind farms. This paper introduces a modular combined DC-DC autotransformer (MCAT), which contributes to the offshore wind power integration o...
The high frequency transformer in single-phase full-bridge DC-DC converter is prone to saturation because of the asymmetry of circuit parameters. Transformer saturation will increase power consumption, accelerate the aging of winding insulation, and...
In this paper, the modeling and the experimental verification of the “bidirectional DC/DC boost converter–DC motor” system are presented. By using circuit theory along with the model of a DC motor, the mathematical model of the syst...
A conceptually new circuit macromodeling of a DC-to-DC converter will be introduced. The motivation comes from the need for the simulation of converters in an electrical environment exhibiting very slow response. By introducing the circuit macromodel...
A new DC fault current limiter (FCL)-based circuit breaker (CB) for DC microgrid (MG) clusters is proposed in this paper. The analytical expressions of the DC fault current of a bidirectional interlink DC/DC converter in the interconnection line of t...
This paper presents an on-board vehicular battery charger that integrates bidirectional AC/DC converter and DC/DC converter to achieve high power density for application in electric vehicles (EVs). The integrated charger is able to transfer electrica...
It is a common practice for storage batteries to be connected to DC microgrid buses through DC-DC converters for voltage support on islanded operation mode. A feed-forward control based dual-loop constant voltage PI control for three-branch interleav...
A decentralized DC power-exchange method is proposed to enable direct bidirectional power transfer among geographically distributed DC microgrids. Each microgrid is connected to a shared power-exchange grid via a bidirectional DC/DC converter, allowi...
Currently, high-performance power conversion requirements are of increasing interest in microgrid applications. In fact, isolated bidirectional dc-dc converters are widely used in modern dc distribution systems. The dual active bridge (DAB) dc-dc con...
This paper provides an overview of modern feedback control methods for the voltage regulation in DC/DC converters of DC microgrids. Control objectives and practical restrictions are defined and used as indicators for the analysis and performance asse...
DC–DC interlinking converters (ILCs) allow bidirectional energy exchange between DC buses of different voltage levels in microgrids. This paper introduces a multimode control approach of a half-bridge DC–DC converter interlinking an extra...
Bipolar DC grids have become an adequate solution for high-power microgrids. This is mainly due to the fact that this configuration has a greater power transmission capacity. In bipolar DC grids, any distributed generation system can be connected thr...
The development of technologies to improve the performance of photovoltaic (PV) module integrated converters (MICs) is fundamental to increase the use of distributed generation systems with photovoltaic power source in large urban centers, mainly for...
Multiple-output DC–DC converters are essential in a multitude of applications where different DC output voltages are required. The interest and importance of this type of multiport configuration is also reflected in that many electronics manufa...
Numerous research studies on high capacity DC-DC converters have been put forward in recent years, targeting multi-terminal medium-voltage direct current (MVDC) and high-voltage direct current (HVDC) systems, in which renewable power plants can be in...
Increasingly more power electronic devices are being connected to DC microgrids, which reduces the inertia of a DC microgrid, and the DC bus voltage has poor resistance to disturbance. Adding a virtual DC motor control to the converter can effectivel...
The optimization of DC-DC converters is crucial for enhancing their performance and efficiency in various applications. This study focuses on the sensitivity analysis of DC-DC converters to parametric variations, which plays a key role in designing r...
The paper discusses the methods of fast analysis of DC–DC converters dedicated to computer programmes. Literature methods of such an analysis are presented, which enable determination of the characteristics of the considered converters in the s...
This paper introduces the concept, theory of operation and applications of soft open points for direct current networks (DCSOPs). The DCSOP is based on a bidirectional DC–DC converter actively controlled to behave like a normal conductor. Unlik...
Flying-capacitor multiplexed modulation technology is suitable for bipolar DC microgrids with higher voltage levels and higher current levels. The module combination and corresponding modulation method can be flexibly selected according to the voltag...
Voltage step-down converters have gained attention, with the rapid development in industrial robotics, Internet of things, and embedded system applications. Therefore, a comprehensive analysis has been performed, to identify the topologies and archit...
Electrical energy conversion and storage in DC systems, with increasing importance in industry, requires DC–DC power electronic converters with performances adapted to today’s requirements. In recent years, the applications of DC–DC...
Unlike the modular multilevel converter (MMC) topology operated under the rectifier or inverter modes, control of the balanced state for the submodule (SM) capacitor voltage has emerged as the key issue for DC-DC MMCs. This is mainly caused by no bal...
With the significant increase in DC loads (such as data and telecommunication centers) at the power distribution level, an additional set of power electronic converters are required to connect these DC loads to the AC-dominant power network. Notably,...
Due to the increase in DC load and DC Power generation, the need for DC power system is emerging. Accordingly, FRT (fault ride through) and LVRT (low voltage ride through), which are related regulations for renewable energy sources, have been enacted...
Existing large-signal control schemes for DC/DC converters formulate control strategies based primarily on nonlinear control theory, and the associated design and implementation are relatively complex. In this work, a decomposition modeling and inver...
In order to mitigate the influence of negative impedance characteristics on the stability of a DC microgrid with a constant power load, and the influence of nonlinear characteristics of a bidirectional converter on DC bus voltage, a control method of...
With the introduction of switch-mode power supplies (SMPS) in the mid-1970s, the efficiency of DC–DC conversion rose from 60 to 80% and SMPS became a popular power supply solution. However, linear regulators have not become obsolete. The modern...
A step-up DC/DC converter is required to match the fuel cell’s stack voltage with the DC-link capacitor of the propulsion system in fuel cell-based electric vehicles (FCEVs). Typically, the nominal voltage of a single fuel cell ranges from 0.5...
Large signal perturbations, such as abrupt load changes and sudden voltage surges, pose significant challenges to the stable operation of DC microgrids. Various control strategies have been explored to mitigate these disturbances. Among them, termina...
In this paper, a novel high-gain DC-DC boost converter with reduced component count is proposed. The converter that is proposed in this paper provides high DC voltage gain, while keeping the overall component count significantly lower in comparison t...
Wind energy is a good alternative to fossil fuels, as the use of fossil fuels has seriously exacerbated the emission of greenhouse gases such as carbon dioxide and has greatly affected the environment. Conventional AC wind farms and AC transmission s...
A multi-input-port bidirectional DC/DC converter is proposed in this paper for the energy storage systems in DC microgrid. The converter can connect various energy storage batteries to the DC bus at the same time. The proposed converter also has the...
Stand-alone power systems based on renewable energy sources are used to replace generators based on fossil fuels. Those renewable power systems also require Energy Storage Devices (ESD) interfaced by a charger/discharger power converter, which consis...
With remarkable advances in IoT, big data, and AI, the fourth industrial revolution is upon us. Low power design methodologies and techniques have been greatly contributing to these advancements by addressing the critical issue of how to increase the...
The research on DC-DC power converters has been a matter of interest for years since this type of converter can be used in a wide range of applications. The main research is focused on increasing the converter voltage gain while obtaining a good effi...
The erosion phenomenon has a significant influence on many metallic materials used in numerous industrial sectors. In this paper, we present the results of an analysis of the influence of abrasive impact erosion on surface and properties of DC03/1.03...
In electric vehicles (EVs), bidirectional DC/DC(Bi-DC/DC) is installed between the battery pack and the DC bus to step up the voltage. In the process of mode switching under step signal, the Bi-DC/DC will be affected by a large current inrush which t...
This study offers a modular isolated grid-connected DC/DC medium-voltage DC aggregation converter to support offshore full DC wind farms’ need for lightweight and highly efficient power aggregation and transmission. The converter can simultaneo...
The presence of DC grids in distribution networks is being increased nowadays and is expected to be quite relevant in a near future, due to several advantages compared to traditional AC systems. Regardless of this, Power Quality in DC grids (DC PQ) (...
This paper proposes a high-performance control strategy for dc–dc converters supplying combined loads (constant current/power, and/or linear loads). This strategy combines a feedback law with a feedforward compensation. The feedback law is base...
In response to the challenges faced by traditional LLC resonant converters in simultaneously achieving a wide output voltage and high efficiency, this paper proposes a cascaded DC-DC converter. The front stage of the converter adopts a new LLC topolo...
Recently, a lot of interesting research has been conducted to solve the fault current problem of the DC system. In long-distance transmission, DC transmission is more economical than AC transmission. The connection of power grids with a DC system can...
of 331