This paper describes the design of a low-current, multichannel, handheld electronic device integrated with nanostructured chemiresistor sensor arrays. A key design feature of the electronic circuit board is its low excitation current for achieving op...
The advantages of pulsed low-current high-voltage discharges operated at atmospheric pressure and the ease with which such discharges can be implemented industrially contributed to their popularity. However, the high reactivity of a pulsed plasma imp...
In this work, we developed a portable device with low production and operation costs for generating an ambient air low-current arc (AALCA) that is transferred to the surface of a treated liquid. It was possible to generate a stable discharge, irrespe...
The atmospheric pressure plasma jet (APPJ) is a popular type of cold atmospheric plasma (CAP). APPJs based on a pulsed atmospheric arc (PAA) are widely spread in industrial processing. A plasma jet of this type, PlasmaBrush PB3 (PB3), is a subject of...
Non-equilibrium conditions in plasma are often achieved by pulsed power delivery, where the pulse shape and repetition rate determine the properties of the plasma constituents and thus its chemical reactivity. The evaluation of the latter is becoming...
Recent research trends show an increasing interest in non-equilibrium plasmas operated at atmospheric pressure, which are often used to tackle several environmental and health issues. Nevertheless, due to the complexity of the applications, these tre...
Single-phase-to-ground fault in low-current grounding systems represents a serious public safety concern. Low-voltage (LV) sensors, with their growing maturity, can now monitor multiple points of the mid-voltage (MV) distribution network. This paper...
A new compact linear proton accelerator project (named LINAC 7) for multiple low-current applications, designed and built in-house at the Beam Laboratory of the University of the Basque Country (UPV/EHU) is described. The project combines the Univers...
Low-current grounding systems are the main grounding method used in power distribution networks and belong to non-direct grounding systems. The most common fault in this type of system is a single-phase grounding fault, which may cause electrical fir...
This work investigates CO2 conversion using atmospheric pressure low-current gliding discharges (GD). The following three modifications are studied: classic GD; magnetically accelerated GD (MAGD); and magnetically retarded GD (MRGD). In the latter tw...
In this study, a low-cost surge current detection sensor (SCDS) that can measure high current surges using a low-current toroidal coil is proposed for maintenance of a surge protective device (SPD). The proposed SCDS is designed to display the predic...
This article presents the author’s methodology for testing selected parameters of a low-current vacuum arc, implemented using an innovative test stand based on a vacuum discharge chamber with a contact system mounted inside. In order to verify...
This paper introduces an innovative low-voltage, low-power current differencing buffered amplifier (CDBA). The proposed CDBA utilizes a bulk-driven MOS transistor operating in the subthreshold region, allowing it to function effectively at low supply...
An X-pinch scheme of a low-current generator (45 kA, 50 ns rise time) is characterized as a potential efficient source of soft X-rays. The X-pinch target consists of wires of 5 μm in diameter—made from either tungsten (W) or gold (Au)-plated...
Resistance spot welding of aluminum (Al5754) to magnesium (AZ31B) alloys results in the formation of a variety of solidification microstructures and intermetallic compounds that may affect the in-service performance of the weld. This study evaluates...
The main component of vacuum interrupters responsible for ensuring the correct flow of current is the contact system. In a vacuum environment, due to the higher values of the mean free path of electrons and particles in the contact gap, the material...
This paper presents a low-voltage, low-power voltage-to-current converter (V-I Converter) implemented in TSMC 40 nm CMOS technology. Operating at a supply voltage of 0.45 V with an input range of 0.1 V to 0.3 V, the proposed circuit achieves a temper...
This paper presents a novel low-power low-voltage current differencing transconductance amplifier (CDTA). To achieve a low-voltage low-power CDTA, the BD-MOST (bulk-driven MOS transistor) technique operating in a subthreshold region is used. The prop...
Owing to the increasing penetration level of distributed energy resources (DER) and direct current (DC) load, the usage of low-voltage direct current (LVDC) systems has expanded to achieve efficient operations. However, because the LVDC system reache...
Reverse bandgaps generate PVT-independent reference voltages by means of the sums of pairs of currents over individual matched resistors: one (CTAT) current is proportional to VEB; the other one (PTAT) is proportional to VT (Thermal voltage). Design...
The paper deals with the immunity to Electromagnetic Interference (EMI) of the current source for Ultra-Low-Voltage Integrated Circuits (ICs). Based on the properties of IC building blocks, such as the current-splitter and current correlator, a novel...
This article describes the design and the characterization of the ANTIGONE (ANalog To dIGital cONvErter) ASIC (Application Specific Integrated Circuit) built in AMS 0.35 m technology for low dc-current sensing. This energy-efficient ASIC was specific...
Designing low-noise current readout circuits at high speed is challenging. There is a need for preamplification stages to amplify weak input currents before being processed by conventional integrator based readout. However, the high current gain prea...
3 September 2020
Fully Depleted Silicon on Insulator (FD-SOI) CMOS technology offers the possibility of circuit performance optimization with reduction of both topology complexity and power consumption. These advantages are fully exploited in this paper in order to d...
This work gives a design perspective on low-power and wideband RF-to-Baseband current-reuse receivers (CRR). The proposed CRR architecture design shares a single supply and biasing current among both LNTA and baseband circuits to reduce power consump...
According to the requirements of weak current measurement in power grid, a weak current sensor with anti-low frequency interference ability is developed. The sensor adopts the principle of fluxgate detection and adds a magnetic ring on the original b...
This paper presents a comprehensive analysis of the dynamic properties of low-power current transformers (LPCTs) in the context of their application in both power systems and electromechanical systems. Momentary changes in external loads occurring in...
With the wide application of advanced portable devices, output-capacitorless low dropout regulators (OCL-LDO) are receiving increasing attention. This paper presents a low quiescent current OCL-LDO with fast transient response. A transient enhancemen...
To develop robust microelectromechanical systems (MEMS) switching technology for low voltage direct current (DC) applications (1–12 V) there is a requirement for the investigation of wear caused by hot switching (contact operated while carrying...
Metal anodes have attracted much interest in metal batteries because of their high theoretical capacity and outstanding electrochemical performance. However, practical applications of metal anodes are often limited by polarization effects, leading to...
The present work proposes a novel fractional-order multifunction filter topology in current-mode (CM), which is designed based on the Modified Current Feedback Operational Amplifier (MCFOA). The proposed design simultaneously generates fractional-ord...
Residual current protection can detect and isolate the grounding (leakage) fault of low-voltage distribution networks in time, which is an essential technical measure to reduce electric shocks and fire accidents and improve power supply safety. This...
Small sized electric motors providing high specific torque and power are required for many mobile applications. Air gap windings technology allows to create innovative lightweight and high-power electric motors that show low phase inductances. Low in...
An output capacitor-less low-dropout (OCL-LDO) regulator with a wide range of load currents is proposed in this study. The structure of the proposed regulator is based on the flipped-voltage-follower LDO regulator. The feedback loop of the proposed r...
A lightning current measurement method using a Rogowski coil based on an integral circuit with low-frequency attenuation feedback was proposed to address the issue of low-frequency distortion in the measurement of lightning currents on transmission l...
In the last decade, mainly due to political incentives towards energy efficiency, the share of lamps with power electronic interfaces, like Compact Fluorescent Lamps (CFL) and Light Emitting Diode (LED) lamps, has significantly increased in the resid...
Organic-inorganic hybrid perovskite photodetectors are gaining much interest recently for their high performance in photodetection, due to excellent light absorption, low cost, and ease of fabrication. Lower defect density and large grain size are al...
This paper presents a low-power CMOS voltage reference with low supply sensitivity, designed and verified in a 180 nm standard CMOS technology. A DIBL-based line-sensitivity (LS) compensation path is incorporated into the conventional PTAT generation...
A cost-effective light-emitting diode (LED) current balance strategy using a variable voltage regulator (VVR) with low dropout vDS control is proposed. This can regulate the multiple metal-oxide-semiconductor field-effect transistors (MOSFETs) of the...
The hybrid active power filter (HAPF) can effectively suppress the 75–125 Hz low-frequency harmonic current generated by the EAST poloidal field power supply. However, the low-frequency harmonic current suppression performance of HAPF is greatl...
In order to enhance the transient stability of offshore wind turbines (OWTs) in marine energy systems, the grid codes stipulate that OWTs should possess the low-voltage ride-through (LVRT) ability of being grid-tied and injecting reactive current dur...
Low-power instrument transformers (LPITs) are spreading among the distribution network thanks to their features (e.g., compactness, lightness, enhanced bandwidth, etc.). It is then a fundamental to guide users and manufacturers to a correct usage and...
In a multi-source permanent magnet synchronous motor (PMSM) drive, three distinct winding structures can be implemented: multi-sector, multi-three-phase, and highly coupled. However, due to variations in the magnetic coupling between windings, their...
The demand for smart, low-power, and low-cost sensors is rapidly increasing with the proliferation of industry automation. In this context, an Ultra-Low Power Eddy Current Displacement Sensor (ULP-ECDS) targeting common industrial applications and de...
The predictive current control method of permanent magnet synchronous motor has the advantages of fast dynamic response and easy digital implementation, so more attention has been paid to it. When the motor operates in a high-speed condition, the swi...
In this work, an ultra-low-voltage (ULV) technique to improve body-driven current mirrors is proposed. The proposed technique is employed to improve the performance of conventional differential-to-single-ended (D2S) converters which at these low volt...
According to standards, the harmonic content should be less than 5% at the time of calibration, while the calibration index proposed in this paper stipulates that the primary current amplitude of 1%~120% of the full range of the accuracy level reache...
In this article, we proposed an analytical model based on charge distribution for switched-capacitor trans-impedance amplifiers (SCTIAs). The changes in the load state of the amplifier under different operating conditions and the influence of the gai...
Background/Objectives: Low-frequency alternating current (LFAC) has been shown to induce nerve conduction block (LFACb). However, the effects of LFAC on conduction delay prior to block remain unclear. This study investigates the impact of LFACb on co...
In the present study, a novel multiple three-phase low-voltage and high-current permanent magnet synchronous generation system is proposed, which has only half-turn coils per phase. The proposed system is composed of a generator and two confluence pl...
of 680