Legionella pneumophila (L. pneumophila) is the causative agent of Legionnaires’ disease and Pontiac fever, collectively known as legionellosis. L. pneumophila infection occurs through inhalation of contaminated aerosols from water systems in wo...
Phthalic acid esters (PAEs), ubiquitous semi-volatile organic compounds (SVOCs) in indoor environments, pose adverse effects on human health. However, their degradation mechanisms and pathways remain unclear. Herein, we developed an efficient phototh...
In this study, relationships between preparation conditions, structure, and activity of Pt-containing TiO2 photocatalysts in photoinduced reforming of glycerol for H2 production were explored. Commercial Aerolyst® TiO2 (P25) and homemade TiO2 pre...
Metallic Pt sites are imperative in the CO oxidation reaction. Herein, we demonstrate the tuning of Pt sites by treating a Pt catalyst in various reductive atmospheres, influencing the catalyst activities in low-temperature CO oxidation. The H2 pretr...
Efficient and low-cost degradation of ethylene has always been a difficult problem in the storage and transportation of fruits and vegetables. Although photocatalysis is considered to be a feasible and efficient solution for ethylene degradation, the...
In this work, we studied how TiO2 and ZrO2 coatings enhance the CO oxidation performance of SiO2-supported Pt catalysts under conditions relevant to automotive emissions control. SiO2 was coated with metal oxides TiO2 or ZrO2 by sol-gel method and th...
Proton exchange membrane fuel cells (PEMFCs) are the most promising clean energy source in the 21st century. In order to achieve a high power density, electrocatalytic performance, and electrochemical stability, an ordered array structure membrane el...
Sn-doped TiO2–carbon composites were identified as promising multifunctional supports for Pt electrocatalysts, in which the oxide component enhances resistance against corrosion and strong metal–support interactions at the Pt-oxide bounda...
This study presents conductance modulation in a Pt/TiO2/HfAlOx/TiN resistive memory device in the compliance region for neuromorphic system applications. First, the chemical and material characteristics of the atomic-layer-deposited films were verifi...
Photobiomodulation (PBM) therapy is known to have the potential to improve bone regeneration after implant surgery. However, the combinatory effect of the nanotextured implant and PBM therapy on osseointegration has not yet been proved. This study ev...
Conventional supported Pt catalysts have often been prepared by loading Pt onto commercial supports, such as SiO2, TiO2, Al2O3, and carbon. These catalysts usually have simple metal-support (i.e., Pt-SiO2) interfaces. To tune the catalytic performanc...
The present work aimed at the development of Pt-TiO2/SiO2 materials applied to the degradation of a pharmaceutical pollutant in a fixed-bed microreactor in continuous mode. First, a wide investigation of the optimal platinum content in TiO2/SiO2 was...
Copper catalysts were widely developed for CO2 conversion, but suffered severe sintering at temperatures higher than 300 °C. Platinum was the most active and stable metal for RWGS reactions. However, the high price and scarcity of platinum restrained...
There have been many articles on the degradation of pollutants by binary and ternary nanocomposites in the field of photocatalysis. However, there has been no research comparing the photocatalytic performance of Rhodamine B (Rh B) between (M(M=Pt, Ag...
Nanozymes possess major advantages in catalysis and biosensing compared with natural nanozymes. In this study, the AuPt@BaTiO3 bimetallic alloy Schottky junction is prepared to act as oxidase mimetics, and its photo−piezoelectric effect is inve...
Photo-catalysts based on titanium dioxide, and modified with highly dispersed metallic nanoparticles of Au, Ag, Pd and Pt, either mono- or bi-metallic, have been analyzed by multiple characterization techniques, including XRD, XPS, SEM, EDX, UV-Vis a...
Current Pt-based methane combustion catalysts require high noble metal loadings (≥1 wt%) and exhibit insufficient low-temperature activity. To address this, we developed a 0.5 wt% Pt catalyst supported by sulfate-modified Fe-Ce-TiO2 (denoted 0.5Pt...
Proton exchange membrane (PEM) fuel cells using Pt-based materials as electrocatalysts have achieved a decent performance, represented by the launched Toyota Mirai vehicle. The ideal PEM fuel cells consume stored pure hydrogen and air. However, SO2,...
To evaluate the effects of different TiO2 crystalline phases on the catalytic oxidation performance of benzene on Pt-loaded TiO2 catalysts, physicochemical examinations were conducted using several spectroscopic and analytical techniques. Obvious eff...
As a carbon-neutral and renewable raw material, cellulose can be transformed into biomass fuels to reduce the dependence on fossil fuels and carbon dioxide emissions. In view of harsh reaction conditions, low selectivity of product, and easy deactiva...
Nanostructured catalysts of platinum (Pt) supported on commercial TiO2, as well as TiO2-CeO2 (1, 5 and 10 wt% CeO2), were synthesized through the Sol-Gel and impregnation method doped to 1 wt% of Platinum, in order to obtain a viable photocatalytic m...
The purpose of this study was to design a Pt/TiO2–ZrO2 catalytic-based treatment system to remove ethanol and oxygen (O2) from a gaseous feed stream. The ultimate target application was the conversion of ethanol and O2 to carbon dioxide (CO2) a...
Pt, as a common cocatalyst, has been widely used in photocatalytic H2 evolution. However, the specific role of Pt in photocatalytic H2 evolution has not been thoroughly studied. In this paper, by employing three Pt sources with different charges (pos...
Metal oxides are excellent candidates for the detection of various gases; however, the issues such as the limited operating temperature and selectivity are the most important ones requiring the comprehensive understanding of gas adsorption kinetics o...
Oriented TiO2 nanotubes, which are fabricated by anodic oxidation method, are prospective in photoelectrochemical analysis and sensors. In this work, Pt and IrO2 co-modified TiO2 nanotubes array was prepared via a two-step deposition process involvin...
Several TiO2 based semiconductors with different Pt loadings are prepared using incipient impregnation, wet impregnation and the sol-gel method. These photocatalysts are evaluated in the Photo-CREC-Water II Photoreactor for hydrogen production via wa...
Al2O3-TiO2 systems with Ti:Al 0.1, 0.5 and 1.0 molar ratio obtained by the sol–gel method have been used as a platinum support. As a precursor of alumina gel, aluminum isopropoxide has been chosen. Titanium tert-butoxylate was applied to obtain...
The influence of the semiconductor microstructure on the photocatalytic behavior of Pt-PtOx/TiO2 catalysts was studied by comparing the methanol-reforming performance of systems based on commercial P25 or TiO2 from sol–gel synthesis calcined at diffe...
Photocatalysts for water purification typically lack efficiency for practical applications. Here we present a multi-component (Pt:SiO2:TiO2(P25)) material that was designed using knowledge of reaction mechanisms of mono-modified catalysts (SiO2:TiO2,...
This work focuses on the production of methane through the photocatalytic reduction of carbon dioxide using Pt-doped CdS/TiO2 heterostructures. The photocatalysts were prepared using P25 commercial titania and CdS synthesized through a solvothermal m...
The control of catalytic performance using synthesis conditions is one of the main goals of catalytic research. Two series of Pt-Ti/SBA-15 catalysts with different TiO2 percentages (n = 1, 5, 10, 30 wt.%) were obtained from tetrabutylorthotitanate (T...
The large-scale implementation of direct methanol fuel cells (DMFCs) is significantly impeded by sluggish methanol oxidation reaction (MOR) kinetics, degradation of Pt electrocatalysts, and significant carbon support corrosion in commercial Pt/C. Her...
This study aimed at evaluating the visible light mediated antimicrobial and osteogenic applications of noble metal, such as gold (Au) and platinum (Pt) coated titania (TiO2) nanotubes (NTs). In this study, the Au and Pt nanoparticles (NPs) were depos...
Plasma catalysis has been utilized in many environmental applications for removal of various hydrocarbons including tars. The aim of this work was to study the tars removal process by atmospheric pressure DBD non-thermal plasma generated in combinati...
A kind of devices Pt/Ag/ZnO:Li/Pt/Ti with high resistive switching behaviors were prepared on a SiO2/Si substrate by using magnetron sputtering method and mask technology, composed of a bottom electrode (BE) of Pt/Ti, a resistive switching layer of Z...
Quantitative assessments of the geometric influence on catalytic activity are crucial for catalyst design and understanding reaction mechanisms. In this study, we synthesized a series of catalysts comprising TiO2-supported Pt nanoparticles with varyi...
The catalytic oxidation of VOCs is widely acknowledged as the most available technology to reduce air pollution. Among the catalysts for VOCs, 1 wt%-Pt/TiO2 catalysts using metal as a doping element have shown amazing potential in many fields. Howeve...
The increased production of biodiesel results in a corresponding rise in the production of glycerol (GLY) as a by-product. The selective oxidation of glycerol can yield relatively simple products under mild reaction conditions, offering high added va...
The 0.7Pb(Mg1/3Nb2/3)O3-0.3PbTiO3(0.7PMN-0.3PT) nanorods were obtained via hydrothermal method with high yield (over 78%). Then, new piezoelectric nanocomposites based on (1−x)Pb(Mg1/3Nb2/3)O3-xPbTiO3 (PMN-PT) nanorods were fabricated by dispersing t...
In this study, sol-immobilization was used to prepare gold nanoparticle (Au NP)-decorated titanium dioxide (TiO2) photocatalysts at different Au weight % (wt. %) loading (Aux/TiO2, where x is the Au wt. %) and Au–M NP-decorated TiO2 photocataly...
Evolution of pure hydrogen and oxygen by photocatalytic water splitting was attained from the opposite sides of a composite Pt/Ti/TiO2 photoelectrode. The TiO2 films were prepared by radio frequency (RF)-Magnetron Sputtering at different deposition t...
N-doped TiO2 nanotubes have been prepared as additives to improve the catalytic capability of Pt/graphene composites in methanol oxidation reactions. Electrochemical experiments show that the catalytic performance of Pt/graphene composites has been g...
The Pt-chitosan-TiO2 charge transfer (CT) complex was synthesized via the sol-gel and impregnation method. The synthesized photocatalysts were thoroughly characterized, and their photocatalytic activity were evaluated toward H2 production through wat...
In this work, catalysts based on TiO2 modified by fluorination and platinum addition were prepared and evaluated in glycerol oxidation. The materials were characterized by TEM, N2 physisorption, XRD, UV–Vis DRS, XRF and XPS. It was found that fluorin...
Hydrogen sensors play a crucial role in ensuring safety in various industrial applications. In this study, we demonstrated the use of a room-temperature hydrogen gas sensor based on Pt-nanoparticle-decorated TiO2 nanorods (TiO2 NRs/Pt NP). The TiO2 N...
Glycerol aqueous phase reforming (APR) produces hydrogen and interesting compounds at relatively mild temperatures. Among APR catalysts investigated in literature, little attention has been given to Pt supported on TiO2. Therefore, herein we propose...
Biotemplated strategies inspired by natural architecture have emerged as an effective strategy to improve the performance of photocatalytic materials. In this work, TiO2-based photocatalysts were synthesized using olive leaves as a biological templat...
The study of methanol steam reforming (MSR) over a Pt-Rh/TiO2-In2O3 catalyst was carried out in traditional and membrane reactors using Pd-Cu foil treated by various methods. This catalyst showed the highest catalytic activity in a conventional react...
The development of visible-light active titanium dioxide is one of the key challenges in photocatalysis that stimulates the development of TiO2-based composite materials and methods for their synthesis. Here, we report the use of pristine and Pt-modi...
TiO2-based mixed oxide–carbon composite supports have been suggested to provide enhanced stability for platinum (Pt) electrocatalysts in polymer electrolyte membrane (PEM) fuel cells. The addition of molybdenum (Mo) to the mixed oxide is known...
of 10