The interleaved buck converter with an extended duty cycle is analyzed in terms of unexplored parasitic switching states that diminish the switch utilization and its safety due to high-magnitude charging and discharging currents. The analysis explain...
This study analyzed the efficiency impact of a MOSFET output parasitic capacitance (Coss) on a full-bridge LLC DC/DC converter. The core of the converter was the control chip for a half-bridge LLC DC/DC converter, and the output signal of the chip co...
This article presents the results of computer analysis of selected switching networks. In these analyses, the influence of selected parasitic components of electronic switches on the total and active power losses in these switches is considered. Anal...
This paper proposes the influence analysis of silicon carbide (SiC) MOSFET’s parasitic output capacitance on a dual active bridge (DAB) converter. Power converters are required for DC grids and energy storage. Because SiC metal-oxide-semiconduc...
This paper presents a novel combo-reconfigurable architecture for the frequency and radiation patterning of a novel antenna system for future fifth-generation (5G) millimeter-wave mobile communication. The tuning system independently controls the fre...
High frequency and high voltage switching converters utilizing wide bandgap semiconductors are gaining popularity thanks to their compactness and improved efficiency. However, the faster switching requirements gives rise to new challenges. A key issu...
This paper presents a new average behavioral model, named a resistor-network (RN) model, that accurately predicts the electrical characteristics of the Dickson charge pump (DCP) circuit in the slow-switching limit and the fast-switching limit regions...
This study investigates the parasitic biodiversity of the fish species Astyanax bimaculatus and Psalidodon fasciatus in a stream located in the Chapada do Araripe Environmental Protection Area (APA), state of Ceará, Brazil, contributing to the...
In this paper, we present an extremely compact eleven-state microwave filter with four concentric split-ring resonators (SRRs). Reconfigurability is achieved by switching off either single or multiple SRRs, thereby obtaining different triple-band, du...
This paper presents three new and improved non-isolated topologies of quadratic boost converters (QBC). Reduced voltage stress across switching devices and high voltage gain with single switch operation are the main advantages of the proposed topolog...
The research on reconfigurable antennas has some disadvantages such as low working frequency and large size. This paper presents a Ka-band patch antenna with pattern reconfigurability using RF MEMS switches. The antenna contains one main patch, two s...
Based on the 0.5 μm GaAs enhancement/depletion (E/D) Pseudomorphic High Electron Mobility Transistor (pHEMT) process, a 7.5–9 GHz two-channel amplitude phase control multi-function chip (MFC) was developed successfully. The chip was integrat...
A SiC MOSFET is a suitable replacement for a Si MOSFET due to its lower on-state resistance, faster switching speed, and higher breakdown voltage. However, due to the parasitic parameters and the low damping in the circuit, the turn-on overcurrent an...
Due to its low conduction loss, hence high current ratings, as well as low cost, Silicon Insulated Gate Bipolar Transistor (Si IGBT) is widely used in high power applications. However, its switching frequency is generally low because of relatively la...
This paper proposes a novel, degradation-sensitive, adaptive SST controller for cascode GaN-FETs. Unlike in traditional transformers, a semiconductor switch’s degradation and failure can compromise its robustness and integrity. It is vital to c...
While birds-of-paradise (Passeriformes: Paradisaeidae) are a well-known group of birds, our understanding of their parasites is still limited. This study reports on parasitic quill mites of the subfamily Picobiinae (Acariformes: Syringophilidae), whi...
To achieve high efficiency and power density, silicon carbide (SiC)-based Inductor-Inductor-Capacitor (LLC) resonant converters are applied to the DC/DC converter stage of a solid-state transformer (SST). However, because the input voltage of an SST...
Remora Optimization Algorithm (ROA) is a metaheuristic optimization algorithm, proposed in 2021, which simulates the parasitic attachment, experiential attack, and host feeding behavior of remora in the ocean. However, the performance of ROA is not v...
Different from the static (power-off) nonvolatile property of a memristor, the history erase effect of a memristor is a dynamic characteristic, which means that under the excitation of switching or different signals, the memristor can forget its init...
Vertical-cavity surface-emitting lasers (VCSELs) are commonly used in high-speed optical communication and 3D sensing applications. Both of these applications require high switching frequency and a short rise time of the VCSEL current. The parasitic...
This paper presents an improved investigation into the effects of temperature-dependent parasitic elements on the silicon carbide (SiC) MOSFET power losses. Based on the physical knowledge of MOSFET, a circuit-level loss analytical model is proposed,...
Nonlinear effects in the radio front-end can degrade communication quality and system performance. In this paper we present a new design technique for reconfigurable antennas that minimizes the nonlinear distortion and maximizes power efficiency thro...
To prevent short-circuits between the upper and lower switches of power converters from over-current protection, the dead time is mandatory in the switching gating signal for voltage source converters. However, this results in many negative effects o...
This paper investigates and characterizes a tunable inductor structure based on coupled-line configurations, referred to as a coupled-line tunable inductor (CLTI). By integrating switches along the coupled-line paths, the mutual inductance can be sel...
This paper presents a radio frequency (RF) triple pole triple throw 3P3T cross antenna switch for cellular mobile devices. The negative biasing scheme was applied to improve the power-handling capability and linearity of the switch by increasing the...
This paper presents a wide-range and low phase noise mm-Wave Voltage Controlled Oscillator (VCO) based on the transconductance linearization technique. The proposed technique eliminates the deep triode region of the active part of the VCO, and lowers...
In this study, the resistive switching phenomenon in Al/SiO2/n++-Si structures is observed and studied by means of DC, small-signal admittance, and complex impedance spectroscopy measurements. Possible transport mechanisms in the high and low resista...
A novel Silicon-Carbide heterojunction U-MOSFET embedded a P-type pillar buried in the drift layer (BP-TMOS) is proposed and simulated in this study. When functioning in the on state, the merged heterojunction structure will control the parasitic bod...
Electrostatic precipitators (ESPs) are devices used in industry to eliminate polluting particles in gases. In order to supply them, an interface must be included between the three-phase main line and the required high DC voltage of tens of kilovolts....
Silicon Carbide (SiC)-based Bi-Directional Switches (BDS) have great potential in the construction of several power electronic circuits including multi-level converters, solid-state breakers, matrix converters, HERIC (high efficient and reliable inve...
In 1971, Chua defined an ideal memristor that links magnetic flux φ and electric charge q. In a magnetic lump with a current-carrying conductor, we found that the direct interaction between physical magnetic flux φ and physical electric charg...
A low insertion loss, wideband 6-bit digital step attenuator is implemented in the 0.25-μm GaAs pHEMT process. Modified π- or T-type attenuator structures are adopted to expand the operation frequency bandwidth and reduce the insertion phase vi...
This paper proposes an optimized predictive control strategy to mitigate the potential leakage current of grid-tied photovoltaic (PV) systems to improve the lifespans of PV modules. In this work, the PV system is controlled with an optimized predicti...
This paper demonstrates the feasibility of the printed copper (Cu) paste interconnects for applications in power semiconductor modules and switching converters. Copper sinter paste interconnects denoted as “Sinterconnects” have been recen...
The rectifier module is the key part of a permanent magnet synchronous generator integrated DC output system (PMSG-IDOS) with low-voltage and high-current. The high-speed switching device of the rectifier module is the main source of electromagnetic...
In this paper, a simple design for a triple-band circularly polarized (CP) antenna with the capability of switching its polarization between dual-sense CPs is presented. The proposed antenna is comprised of a monopole loop antenna as a primary radiat...
This work proposes a low-profile, printed antenna that offers pattern and frequency reconfiguration functionalities printed on FR-4 substrate with a size of 46 × 32 × 1.6 mm3. The proposed antenna can operate in five different frequency bands, each o...
This paper presents the closed-loop control of a single-switch high-gain multicell boost DC-DC converter working in a continuous conduction mode (CCM). This converter is particularly designed for applications in photovoltaic systems. One of the main...
Due to having a number of advantages, Marx generators are still the most widely used devices for generating high-voltage pulses in many fields of science and technology. To ensure their proper operation, especially when the generation of many frequen...
Grid-connected inverters (GCI) are commonly used in PV system applications to generate a regulated AC current to feed into the grid. Transformerless inverters are the most advanced inverters that are used in industry, which provide efficiency with sm...
A bias-free antenna tuning technique that eliminates conventional DC biasing networks is presented. The tuning mechanism is based on a Light-Dependent Resistor (LDR) embedded within the antenna structure. Optical illumination is used to modulate the...
This work proposes an automated reconfiguration system to manage two types of faults in any position inside the solar arrays. The faults studied are the short-circuit to ground and the open wires in the string. These faults were selected because they...
In self-powered microsystems, a power management is essential to extract, transfer and regulate power from energy harvesting sources to loads such as sensors. The challenge is to consider all of the different structures and components available and b...
The growing demand for improved interruption performance characteristics in emerging aircraft high-voltage direct current (HVDC) electrical networks motivates the rapid development of solid-state power controllers (SSPCs). This article presents a com...
Wide bandgap (WBG) power semiconductor devices are increasingly replacing silicon IGBTs in high-power and high-voltage power electronics applications. However, there is a significant gap in the literature regarding efficient testing methodologies for...
Magnetically levitated (ML) systems that incorporate PCB coils represent a growing trend in precision machining, valued for their controllable current flow and high fill factor. The size of modern power devices is decreasing to enhance power density,...
An optically activated, enhancement mode heterostructure field effect transistor is proposed and analytically studied. A particular feature of this device is its gate region, which is made of a photovoltaic GaN/AlN-based superlattice detector for a w...
The demand for high-intensity lasers has grown ever since the invention of lasers in 1960, owing to their applications in the fields of inertial confinement fusion, plasma-based relativistic particle accelerators, complex X-ray and gamma-ray sources,...