The sensitive detection of n-butanol is of high scientific and practical importance for ensuring safety in industrial production. In this study, hollow Cu2O@CuS core–shell nanocubic heterostructures were fabricated via a multistep templating me...
Photocatalytic water splitting for hydrogen production has been widely recognized as a promising strategy for relieving the pressure from energy crisis and environmental pollution. However, current efficiency for photocatalytic hydrogen generation ha...
Niobium-doped titanium dioxide (Ti1−xNbxO2) films were grown on p-type Si substrates at low temperature (170 °C) using an atomic layer deposition technique. The as-deposited films were amorphous and showed low electrical conductivity. The f...
Cu2O is a p-type direct bandgap semiconductor with a band gap of 2~2.2 eV, which has excellent visible light absorption and utilization. However, slow charge transfer and poor stability hinder its practical application. In this paper, a facile electr...
A 1.2 kV SiC MOSFET with an integrated heterojunction diode and p-shield region (IHP-MOSFET) was proposed and compared to a conventional SiC MOSFET (C-MOSFET) using numerical TCAD simulation. Due to the heterojunction diode (HJD) located at the mesa...
Layered perovskite-type semiconductor La2Ti2O7 has attracted lots of attention in photocatalytic hydrogen evolution, due to the suitable energy band position for water splitting, high specific surface area, and excellent physicochemical stability. Ho...
In this paper, a superior-quality InN/p-GaN interface grown using pulsed metalorganic vapor-phase epitaxy (MOVPE) is demonstrated. The InN/p-GaN heterojunction interface based on high-quality InN (electron concentration 5.19 × 1018 cm−3 a...
Two-dimensional transition metal dichalcogenides (2D-TMDs) possess appropriate bandgaps and interact via van der Waals (vdW) forces between layers, effectively overcoming lattice compatibility challenges inherent in traditional heterojunctions. This...
Despite the increasing trend of n-type silicon wafer utilization in the manufacturing of high-efficiency heterojunction solar cells due to the superior advantages over p-type counterparts, its high manufacturing cost remains to be one of the most cru...
Self-powered ultraviolet (UV) photodetectors have attracted considerable attention in recent years because of their vast applications in the military and civil fields. Among them, self-powered UV photodetectors based on p-n heterojunction low-dimensi...
Using a p-n heterojunction is one of the efficient methods to increase charge transfer in photocatalysis applications. So, herein, p-type UiO-66 (NH2) and n-type CuFe2O4 (CFO) are used to form an effective p-n heterojunction. Due to their poor charge...
Two-dimensional (2D) n-MoS2 nanosheets (NSs) synthesized via the sol–gel method were deposited onto p-type heavily boron-doped diamond (BDD) film to form a n-MoS2/p-degenerated BDD (DBDD) heterojunction device. The PL emission results for the h...
Out-of-plane p-n heterojunctions based on two-dimensional layered materials (2DLMs) with unusual physical characteristics are attracting extensive research attention for their application as photodetectors. However, the present fabrication method bas...
Environmental remediation in the presence of robust semiconductor photocatalysts by utilizing renewable energy sources is of keen interest among researchers. In this study, we synthesize a BiVO4/P-g-C3N4 semiconductor heterojunction photocatalytic sy...
The vertical heterojunction Ga2O3 MOSFET (Metal-Oxide-Semiconductor Field-Effect Transistor) with the p-type oxide as the current-blocking layer (CBL) is investigated for the first time using SILVACO simulation software. The results show that the thr...
Titanium dioxide (TiO2), a widely used semiconductor in photocatalysis owing to its adequate potential for water hydrolysis, chemical stability, low toxicity, and low cost. However, its efficiency is limited by fast charge-carrier recombination and p...
Exploiting excellent photocatalytic activity and stable heterostructure composites are of critical importance for environmental sustainability. The spherical Bi2WO6/Bi2S3/MoS2 n-p heterojunction is first prepared via an in situ hydrothermal method us...
In this study, a Z-Scheme WO3/CoO p-n heterojunction with a 0D/3D structure was designed and prepared via a simple solvothermal approach to remove the combined pollution of tetracycline and heavy metal Cr(VI) in water. The 0D WO3 nanoparticles adhere...
The S-scheme photocatalyst system has become increasingly popular in recent years for its ability to efficiently degrade various pollutants, including organic dyes, pesticides, and other harmful substances. This system uses two semiconductor photocat...
Through the selection of N-type organic semiconductor molecules and the method of supramolecular self-assembly at the solvent phase interface, a perylene tetracarboxylic diimide (PTCDIs) nanofiber film with loose and porous morphology was constructed...
In this study, we proposed a rectifying drain electrode that was embedded in a p-GaN gate AlGaN/GaN heterojunction field-effect transistor to achieve the unidirectional switching characteristics, without the need for a separate reverse blocking devic...
Gallium nitride (GaN) is a superior candidate material for fabricating ultraviolet (UV) photodetectors (PDs) by taking advantage of its attractive wide bandgap (3.4 eV) and stable chemical and physical properties. However, the performance of availabl...
In the renewable energy conversion system, water electrolysis technology is widely regarded as the core means to achieve clean hydrogen production. However, the anodic oxygen evolution reaction (OER) has become a key bottleneck limiting the overall w...
The aim of this work was to investigate a new, simple, one-pot combustion synthesis technique for creating sulphur-based CuS/ZnS p-n heterojunction nanocomposite photocatalysts. This study examined the photocatalytic activity and reusability of these...
Nanocrystalline TiO2 is a perspective semiconductor gas-sensing material due to its long-term stability of performance, but it is limited in application because of high electrical resistance. In this paper, a gas-sensing nanocomposite material with p...
For the first time, the deposition of CuCrO2 thin films was carried out using a dual-target RF magnetron sputtering technique using Cu2O and Cr2O3 targets. The deposited films were subsequently annealed in N2 ambiance from 600–900 °C. This...
Noble metal-free electrocatalysts have received widespread attention in a hydrogen evolution reaction (HER) due to the importance of renewable energy development. Herein, a Co2P/CoP heterojunction embedded on an N-doped carbon (Co2P/CoP/NC) electroca...
p-BiOI nanosheets/n-TiO2 nanofibers (p-BiOI/n-TiO2 NFs) have been facilely prepared via the electrospinning technique combining successive ionic layer adsorption and reaction (SILAR). Dense BiOI nanosheets with good crystalline and width about 500 nm...
Photocatalysts derived from semiconductor heterojunctions for water splitting have bright prospects in solar energy conversion. Here, a Co3O4@ZIS p-n heterojunction was successfully created by developing two-dimensional ZnIn2S4 on ZIF-67-derived holl...
Due to the possible applications, materials with a wide energy gap are becoming objects of interest for researchers and engineers. In this context, the polycrystalline diamond layers grown by CVD methods on silicon substrates seem to be a promising m...
Cu3N with a cubic crystal structure is obtained in this paper by the sputtering of Cu under N2 followed by annealing under NH3: H2 at 400 °C, after which it was doped with iodine at room temperature resulting into p-type Cu3N with hole densities...
The undoped polycrystalline diamond films (PDFs) have been deposited on n-type silicon (Si) by Hot Filament Chemical Vapor Deposition (HF CVD) technique. The reaction gases are a mixture of methane and hydrogen. The obtained PDFs were characterized b...
Novel heterojunction photocatalysts with remarkable photocatalytic capabilities and durability for degrading recalcitrant contaminants are extremely desired; however, their development still remains quite challenging. In this study, a series of flowe...
With the intensification of the energy crisis and the growing concern over environmental pollution, particularly the discharge of organic dye pollutants in industrial wastewater, photocatalytic degradation of these contaminants using solar energy has...
The band gaps of bismuth vanadate (BiVO4) and bismuth sulfide (Bi2S3) are about 2.40 eV and 1.30 eV, respectively. Although both BiVO4 and Bi2S3 are capable of strong visible light absorption, electron–hole recombination occurs easily. To solve this...
The n-type Ce:ZnO (NL) grown using a hydrothermal method was deposited on a p-type boron-doped nanoleaf diamond (BDD) film to fabricate an n-Ce:ZnO NL/p-BDD heterojunction. It shows a significant enhancement in photoluminescence (PL) intensity and a...
Equipped with staggered gap p-n heterojunctions, a new paradigm of photocatalysts based on hierarchically structured nano-match-shaped heterojunctions (NMSHs) Cu2S quantum dots (QDs)@ZnO nanoneedles (NNs) are successfully developed via engineering th...
Developing efficient and durable electrocatalysts for the alkaline hydrogen evolution reaction (HER) is crucial for sustainable hydrogen production. Herein, we report a novel RuP2/Mn2P2O7 heterojunction anchored on a three-dimensional nitrogen and ph...
The chemical bonding of bandgap adjustable organic semiconductors with inorganic semiconducting materials is effective in constructing a high-performance heterogeneous photoanode. In this study, a new asymmetric perylene diimide derivative molecule (...
Here we suggest a simple and novel method for the preparation of a high-performance self-humidifying fuel cell membrane operating at high temperature (>100 °C) and low humidity conditions (<30% RH). A self-humidifying membrane was effectively p...
Photodetectors are of great interest in several technological applications thanks to their capability to convert an optical signal into an electrical one through light–matter interactions. In particular, broadband photodetectors based on graphe...
The hydrothermal approach has been used to fabricate a heterojunction of n-aluminum-doped ZnO nanorods/p-B-doped diamond (n-Al:ZnO NRs/p-BDD). It exhibits a significant increase in photoluminescence (PL) intensity and a blue shift of the UV emission...
This work demonstrates an enhancement mode heterojunction bipolar p-FET (HEB-PFET) structure with a AlGaN/GaN heterojunction bipolar transistor (HBT) integrated on the drain side. Such device design notably contributes to the ultra-high output curren...
We report on the microelectronic characteristics of a novel hybrid heterojunction device based on a solution processable semiconducting polymer poly(9,9-dioctylfluorenyl-2,7-diyl)- co-(N,N0-diphenyl)-N,N′di(p-butyl-oxy-pheyl)-1,4-diamino-benzen...
Diamond holds promise for optoelectronic devices working in high-frequency, high-power and high-temperature environments, for example in some aspect of nuclear energetics industry processing and aerospace due to its wide bandgap (5.5 eV), ultimate th...
A p–n heterojunction film consisting of p-type CuFe2O4 and n-type ZnFe2O4 was fabricated in this study. The n-type ZnFe2O4 film was deposited on a stainless steel substrate using the spray pyrolysis method, after which a top layer of p-type CuF...
This review is mainly focused on the optoelectronic properties of diamond-based one-dimensional-metal-oxide heterojunction. First, we briefly introduce the research progress on one-dimensional (1D)-metal-oxide heterojunctions and the features of the...
Two-dimensional (2D) materials, such as molybdenum disulfide (MoS2) of the transition metal dichalcogenides family, are widely investigated because of their outstanding electrical and optical properties. However, not much of the 2D materials research...
Organic photodetectors (OPDs) offer considerable promise for low-power, solution-processable biosensing and imaging applications; however, their performance remains limited by spectral mismatch and interfacial trap states. In this study, a highly sen...
A novel Silicon-Carbide heterojunction U-MOSFET embedded a P-type pillar buried in the drift layer (BP-TMOS) is proposed and simulated in this study. When functioning in the on state, the merged heterojunction structure will control the parasitic bod...
of 12