1,391 Results Found

The use of ammonia as a hydrogen carrier requires efficient cracking technology. A promising solution is the use of a membrane reactor (MR), which enables both ammonia decomposition and hydrogen separation to take place within the same device, provid...

In this study, a novel strategy to enhance the performance of palladium (Pd)-based catalysts by doping with metal oxides (Mn3O4, MoO3, and SnO) has been developed in order to overcome the limitations of its low activity and high cost in the catalytic...

The electronic structure and spin polarization properties of pentagonal structure PdSe2 doped with transition metal atoms are studied through first- principles calculations. The theoretical investigations show that the band gap of the PdSe2 monolayer...

Polybrominated diphenyl ethers (PBDEs), a type of brominated flame retardant, are of global concern due to their environmental persistence, bioaccumulation, toxicity, and resistance to conventional remediation methods. In this study, the electrochemi...

In this study, a PdAl (20 nm)/Au (30 nm) metal stack scheme is used for forming low-ohmic-resistance contact on Mg-doped (1.5 × 1017 cm−3) p-type AlGaN at various annealing temperatures. Using a circular-transmission line model, the speci...

We present a comparative study of the tribological properties of Pd-, Pt-, and Zr-based bulk metallic glasses (BMG-Pd, BMG-Pt, and BMG-Zr, respectively) under unlubricated conditions. In particular, micro-tribometry is utilized with a 52,100 steel ba...

The relativistic effects of the values of the shielding constants of 1H, 13C, 15N, 57Fe, 59Co, 61Ni, 105Pd, and 195Pt nuclei were studied at the four-component relativistic level and were compared to the results of non-relativistic calculations perfo...

Bulk metallic glasses (BMGs) deform irreversibly through shear banding manifested as serrated-flow behavior during compressive tests. The strain-rate-dependent plasticity under uniaxial compression at the strain rates of 2 × 10−2, 2 × 10−3, and 2 × 1...

In today’s age of resource scarcity, the low-cost development and utilization of renewable energy, e.g., hydrogen energy, have attracted much attention in the world. In this work, cheap natural halloysite nanotubes (HNTs) were modified with &ga...

Electroless noble metal deposition on the conducting substrate is widely used to obtain the desired film or coating on the substrate of interest. Wire-gauge-based Pt/Pd/Pt-Pd (individually, sequentially, and simultaneously deposited) catalysts have b...

The Pd component in the automotive three way catalyst (TWC) experiences deactivation during fuel shutoff, a process employed by automobile companies for enhancing fuel economy when the vehicle is coasting downhill. The process exposes the TWC to a se...

In this article, we present density functional theory (DFT) calculations for Zn(1−x)MxO, where M represents one of the following substitutional metallic impurities: Ga, Cd, Cu, Pd, Ag, In, or Sn. Our study is based on the wurtzite structure of...

A novel metal oxide catalyst, PdOx/CuO-ST, was prepared by calcining a Pd-embedded CuBTC precursor and compared with a PdOx/CuO-SG catalyst synthesized via a sol–gel method. Characterization results indicated that in both catalysts, Pd species...

A series of Pd-TiO2/Pd-Ce/TiO2 catalysts were prepared by an equal volume impregnation method. The effects of different Pd loadings on the catalytic activity of chlorobenzene (CB) were investigated, and the results showed that the activity of the 0.2...

This study systematically investigates the effect of substituting Copper (Cu) with Nickel (Ni) on the glass-forming ability (GFA) and corrosion resistance of a Pt-based bulk metallic glass (BMG). We demonstrate that a minor substitution of 5 at.% Ni...

A non-solvent synthesis of alkali metal-doped PdCu-Pd-Cu@C is presented that needs no mechanical grinding and utilizes heat treatment under an N2 gas flow. Pluronic® F127 is used to generate pores and a high surface area, and tannic acid is used as a...

Three methods were used to fabricate ZnO-based room temperature liquid petroleum gas (LPG) sensors having interdigitated metal-semiconductor-metal (MSM) structures. Specifically, devices with Pd Schottky contacts were fabricated with: (1) un-doped Zn...

The mild hydrotreatment of a model mixture of tar-type compounds (i.e., naphthalene, 1-methylnaphthalene, acenaphthylene, and phenanthrene) to produce partially hydrogenated products in the range of C9–C15 was studied over Pd supported on TiO2 posses...

Aimed to clarify the correlation characteristics between the internal partial discharge (PD) in negative direct current (DC) gas insulated system (GIS) and gas pressure initiated by two typical defects (i.e., free-metal particles and metal protrusion...

Palladium nanoparticles (Pd NPs) synthesized by the metal vapor synthesis technique were supported on poly(4-vinylpyridine) 2% cross-linked with divinylbenzene (Pd/PVPy). Transmission electron microscopy revealed the presence of small metal nanoparti...

Electrochemical CO2 reduction to produce formate ions has studied for the sustainable carbon cycle. Mercury in the liquid state is known to be an active metallic component to selectively convert CO2 to formate ions, but it is not scalable to use as a...

A simple method is presented for incorporating various catalytic metals into the pores of SBA-15 using vapor-phase infiltration. The precursors used in Atomic Layer Deposition (ALD) for Pt, Pd, Rh, Ru, and Ni were exposed to an evacuated SBA-15, resu...

Direct urea fuel cells (DUFCs) have recently drawn increased attention as sustainable power generation devices because of their considerable advantages. Nonetheless, the kinetics of the oxidation-reduction reaction, particularly the electrochemical o...

Cryogels from noble metal NPs have proven to be highly efficient catalysts due to their high specific surface area which increases the mass transfer channels and catalytic active sites. By using metal oxides as co-catalysts, the costs of the material...

A laminated Pd-Cu alloy/C/Nafion multilayer was prepared to sense O2 atmosphere in a metal-air structure. As a matrix, palladium was doped with various amounts of copper to conduct a preliminary test with optimum response, and four compositions, Pd,...

The catalytic oxidation of silanes to produce silanols using water as an oxidant at mild temperatures is a major challenge in Si-H activation. Highly efficient and easy-to-recycle catalysts based on Pd nanoparticles are in high demand. In this study,...

SnO2-based semiconductor gas-sensing materials are regarded as some of the most crucial sensing materials, owing to their extremely high electron mobility, high sensitivity, and excellent stability. To bridge the gap between laboratory-scale SnO2 and...

The interaction of hydrogen with Pt-group metals and alloys is at the center of research in the fields of electrochemistry, electrocatalysis, hydrogen technologies and fuel cells developed under the Hydrogen Economy. In this work, the material under...

Cerium oxide (CeO2) can exhibit good photocatalytic and photoantibacterial activities. However, its light-harvesting property is rather limited due to its large band gap. In order to boost these properties, doping with metal ions can improve light ab...

Pollution of the aquatic environment by halogen derivatives widely used as antiseptic compounds, as well as chemicals for various industrial purposes, is significant. Existing systems of bioremediation poorly solve the problem of eliminating pollutio...

The present study reports the sono-chemical synthesis of novel nanosized Cr(III), Mn(II), and Pd(II) complexes incorporating the chloro-2-(quinolin-8-yliminomethyl)-phenol imine ligand. The synthesized complexes were characterized using various spect...

This paper presents a process for efficiently recovering palladium (Pd) from spent Pd/Al2O3 catalysts used for hydrogenation reactions, using ultrasound-assisted leaching (UAL). A system composed of H2SO4 and NaCl was investigated under ultrasound-en...

The main aim of our research was to investigate antiadhesive and antibiofilm properties of nanocrystalline apatites doped and co-doped with noble metal ions (Ag+, Au+, and Pd2+) against selected drug-resistant strains of Enterococcus faecalis and Sta...

CeO2-ZrO2-La2O3 supported Pt-Pd bimetallic three-way catalysts (0.6Pt-0.4Pd/CZL) were synthesized through the conventional impregnation method and then subjected to severe thermal aging. Reactivating treatments under different temperatures were then...

Pd2Spm is a dinuclear palladium(II)-spermine chelate with promising anticancer properties against triple-negative breast cancer (TNBC), a breast carcinoma subset with poor prognosis and limited treatment options. The present study evaluated the in vi...

Research and catalytic testing of platinum group transition metal carbides have been extremely limited due to a lack of reliable, simple synthetic approaches. Powder samples have been reported to phase separately above 1%, and only thin-film samples...

2D field-effect transistors (FETs) fabricated with transition metal dichalcogenide (TMD) materials are a potential replacement for the silicon-based CMOS. However, the lack of advancement in p-type contact is also a key factor hindering TMD-based CMO...

Highly atypical mineralization involving Pd-Pt, Au-Ag, REE, Y, Zr, U, Th, and Cl-F-enriched minerals is found in zones with base metal sulfides (BMS; ~5 vol.% to 20 vol.%) in the eastern portion of the Oktyabrsky deposit in the Norilsk complex (Russi...

Cr (VI) has been considered to be a harmful environmental pollutant due to its toxicity, mobility and strong oxidation. It has become challenging to remove Cr (VI) from wastewater. In this work, a series of supported palladium-based catalysts were sy...

Platinum- and/or palladium-containing silica-based supports were applied for the selective catalytic reduction of NOx with hydrogen (H2-SCR-DeNOx). To obtain enhanced activity and N2 selectivity below 150 °C, we varied the type and loading of nob...

PdAg/ZrO2 alloy catalysts calcined at different temperatures were employed to elucidate the effect of support-metal interaction (SMI) on methane combustion. Combustion activity was depressed when the sample was calcined at an elevated temperature fro...

Boron presents an important role in chemistry, biology, and materials science. Diatomic transition-metal borides (MBs) are the building blocks of many complexes and materials, and they present unique electronic structures with interesting and peculia...

Optical hydrogen sensors offer high sensitivity, high accuracy, and non-invasive sensing capabilities, making them promising devices in various fields, including the construction of hydrogen fuel cells, storage and transportation, and aerospace. Howe...

Palladium nanoparticles were supported on unusual mixtures of anatase, TiO2 (II) and rutile titania phases by wet impregnation, obtaining catalysts with metal contents of ca. 0.25 wt % labeled Pd/Ti5, Pd/Ti45, and Pd/Ti120. Crystalline structures wer...

Metal–oxide interfaces play a prominent role in heterogeneous catalysis. Tailoring the metal–oxide interfaces effectively enhance the catalytic activities and thermal stability of noble metal catalysts. In this work, polyvinyl alcohol-pro...

In this work, the metal content of Pd85Ni10Bi5/C catalysts for the alkaline ethanol-oxidation reaction was reduced from 40 wt.% (PdNiBi/C (40/60)) to 30 wt.% (PdNiBi/C (30/70)), 20 wt.% (PdNiBi/C (20/80)) and 10 wt.% (PdNiBi/C (10/90)), while increas...

We report an investigation of the effects of different metal systems and surface treatment on the contact performance of GaN lasers. We found that multi-element metal alloy and surface chemical treatment are the keys to achieve good ohmic behavior co...

The Jinbaoshan Pt-Pd deposit is China’s largest independent PGM deposit. However, the deposit has not been utilized until now because of the low grade of precious metals, the complex mineral composition, and, notably, the presence of precious m...

This paper presents the results of research on the selective separation of palladium, platinum, and rhodium from waste solutions using commercial organic extractants such as Mextral 63H and trioctylamine. The research was carried out on a real waste...

Defects in GIS can be effectively detected by detecting the partial discharge (PD). The common methods of detecting partial discharge are pulse current, ultrasonic and UHF (ultra-high frequency). However, the results of different methods may be diffe...