136 Results Found

Ion concentration polarization (ICP) is a promising mechanism for concentrating and/or separating charged molecules. This work simulates the extraction of Li+ ions in a diluted high Mg2+/Li+ ratio salt lake brines based on free flow ICP focusing (FF-...

Brine with a high magnesium-to-lithium ratio was separated by electrodialysis equipped with a monovalent cation exchange membrane under differing operational parameters. The ionic concentration variations, separation coefficients, lithium recovery ra...

The separation of lithium and magnesium from salt-lake brines with high Mg2+/Li+ ratios is a main challenge for lithium extraction. In this work, novel polymer inclusion membranes (PIMs) were developed by incorporating 2-ethylhexyl phosphonic acid mo...

In this study, the electrochemical performance and discharge behavior of Mg-Li-Zn-Gd alloys with α-Mg and β-Li-based anode material are investigated, with the aim to improve the anode performance of Mg-air batteries. The experimental anode...

The difficult separation of magnesium–lithium has always been a problem that impedes the comprehensive utilization of salt lake brine resources. In this paper, a method for the separation of magnesium and lithium based on the crystallization of...

Lithium extraction from salt lake brine with a high mass ratio of Mg/Li by counter-current method using TBP-DIBK extraction system was investigated in this study. In the extraction process, TBP and DIBK acted as extractant, kerosene was used as dilue...

Aqueous sources like salt lake brines and seawater are the most abundant source for lithium ions and might contribute to the growing demand for lithium for energy storage. By coupling with the increasingly relevant reverse osmosis systems, nanofiltra...

The extraction of lithium and potassium from salt lakes has led to the generation of substantial amounts of magnesium-rich waste streams. These by-products, with their high magnesium content, have contributed to severe environmental degradation in sa...

In previous studies, complex hydrides LiBH4 and Mg2FeH6 have been reported to undergo simultaneous dehydrogenation when ball-milled as composite materials (1 − x)LiBH4 + xMg2FeH6. The simultaneous hydrogen release led to a decrease of the dehydrogena...

As a most promising material for hydrogen generation by hydrolysis, magnesium hydride (MgH2) is also trapped by its yielded byproduct Mg(OH)2 whose dense passivated layers prevent the further contact of intimal MgH2 with water. In this work, LiH, as...

The preparation of Li2CO3 from brine with a high mass ratio of Mg/Li is a worldwide technology problem. Membrane separation is considered as a green and efficient method. In this paper, a comprehensive Li2CO3 preparation process, which involves elect...

In order to recover lithium from brine with a high Mg2+/Li+ ratio, a positively charged nanofiltration (NF) membrane was prepared by depositing polydopamine (PDA)-coated graphitic carbon nitride (g-C3N4) as the interlayer (PDA-g-C3N4) and the interfa...

Ion-sieves are a class of green adsorbent for extraction Li+ from salt lakes. Here, we propose a facile synthesis of hexagonal spinel LiMn2O4 (LMO) precursor under mild condition which was first prepared via a modified one-pot reduction hydrothermal...

In this work, molybdena-promoted Li/MgO is studied as a catalyst for the oxidative conversion of n-hexane. The structure of the catalysts is investigated with X-ray Diffraction (XRD) and Raman spectroscopy. The MoO3/Li/MgO catalyst contains three typ...

Adding a secondary complex metal hydride can either kinetically or thermodynamically facilitate dehydrogenation reactions. Adding Mg2FeH6 to LiBH4 is energetically favoured, since FeB and MgB2 are formed as stable intermediate compounds during dehydr...

Lithium borohydride (LiBH4) and sodium borohydride (NaBH4) were synthesized via mechanical milling of LiBO2, and NaBO2 with Mg–Al-based waste under controlled gaseous atmosphere conditions. Following this approach, the results herein presented...

Although body-centered cubic (BCC) structural magnesium–lithium (Mg-Li) alloys have lower density and better formability than common hexagonal close-packed (HCP) Mg alloys, their applications remain limited due to their low strength. The purpos...

4LiF-MM’2O4 composites were synthesized via the mechanical milling of LiF and MM’2O4 (M = Mn, Mg, Zn; M’ = Mn Fe) for 72 h. In the obtained composites, the XRD peak broadened because of the milling, and the composites possessed a ro...

A liquid electrolyte lithium/sulfur (Li/S) cell is a liquid electrochemical system. In discharge, sulfur is first reduced to highly soluble Li2S8, which dissolves into the organic electrolyte and serves as the liquid cathode. In solution, lithium pol...

As global demand for renewable energy and electric vehicles increases, the need for lithium has surged significantly. Extracting lithium from salt lake brine has become a cutting-edge technology in lithium resource production. In this study, two-dime...

Determining the influence of subduction input on back-arc basin magmatism is important for understanding material transfer and circulation in subduction zones. Although the mantle source of Okinawa Trough (OT) magmas is widely accepted to be modified...

The microstructural evolution and properties of an Al-Cu-Li alloy with Mg and Zn microalloying (Al-3.5Cu-1.5Li-0.5Mg-0.4Zn-0.3Mn-0.12Zr-0.06Ti) ingot subjected to homogenization (second-step annealing at 500 °C for 24 h following first-step annea...

The effects of lithium doping on the sintering and grain growth of non-stoichiometric nano-sized magnesium aluminate spinel were studied using a spark plasma sintering (SPS) apparatus. Li-doped nano-MgO·nAl2O3 spinel (n = 1.06 and 1.21) powders conta...

LiNH2 and a pre-processed nanoMgH2 with 1:1 and 2:1 molar ratios were mechano-chemically milled in a high-energy planetary ball mill under inert atmosphere, and at room temperature and atmospheric pressure. Based on the thermogravimetric analysis (TG...

This research introduces a completely new environmental benign synthesis route for obtaining two kinds of inter-mediate and high temperature CO2 sorbents, Mg-Al layered double hydroxide (LDH) and Li4SiO4, from vermiculite. The mineral vermiculite was...

The Weilasituo Li–polymetallic deposit, located on the western slope of the southern Great Xing’an Range in the eastern Central Asian Orogenic Belt, is hosted by quartz porphyry with crypto-explosive breccia-type Li mineralisation atop an...

Nanofiltration application for the separation of Mg2+-Li+ from salt-lake brines was attempted in the present work. Four different nanofiltration membranes identified in the manuscript as DL, DK, NF-270, and NF-90 were used to treat salt brine with a...

Potential natural resources of lithium in Indonesia from brine water and bittern generally have low lithium and high magnesium levels, which need to be separated before further extraction. This research investigates the separation process of magnesiu...

The dehydriding process and hydrogen–deuterium exchange (H–D exchange) of xLiBH4 + (1 − x)Mg2FeD6 (x = 0.25, 0.75) composites has been studied in detail. For the composition with x = 0.25, only one overlapping mass peak of all hydrogen and deuterium...

The extensive use of lithium (Li) ion-based batteries has increased the contamination of soil and water systems due to widespread dispersal of Li products in the environment. In the current study, the influence of Li application on soil fertility and...

Salt lakes on the Qinghai-Tibetan Plateau (QTP) are remarkable for Li-rich brines. Along with the surging demand of Li, the Li-rich brines in salt lakes on the QTP are of great importance for China’s Li supply. Previous studies reported the geologica...

A nonlinear optical double-doped single-crystal LiNbO3:Gd:Mg (Gd concentration is 0.003, Mg—0.65 wt % in the crystal) has been researched by several optical methods: laser conoscopy, photoinduced light scattering (PILS), optical spectroscopy, a...

Catalytic conversion of biomass-derived feedstock to high-value chemicals is of remarkable significance for alleviating dependence on fossil energy resources. MgAl spinel-supported Pt catalysts were prepared and used in furfuryl alcohol conversion. T...

To develop plasma-resistant glass materials suitable for semiconductor etching processes, we introduced alkaline earth oxides (ROs) into a Li2O–Al2O3–SiO2 (LAS) glass. Analysis of glass properties with respect to the additives revealed th...

Various synthesis and rehydrogenation processes of lithium hydride (LiH) and magnesium amide (Mg(NH2)2) system with 8:3 molar ratio are investigated to understand the kinetic factors and effectively utilize the essential hydrogen desorption propertie...

The objective of this study was to apply three-dimensional x-ray microtomographic imaging to understanding morphologies in the diphasic destabilized hydride system: MgH2 and LiBH4. Each of the single phase hydrides as well as two-phase mixtures at Li...

Lithium–sulfur batteries (LSBs) have received great attention as promising candidates for next-generation energy-storage systems due to their high theoretical energy density. However, their practical energy density is limited by a large electro...

Mg, Fe co-doped near-stoichiometric lithium tantalite (SLT) single crystals were grown by employing the zone-leveling Czochralski (ZLCz) technique. The optical properties, holographic parameters, as well as the composition of the grown crystals were...

Nanofiltration is well suited to separate monovalent ions from multivalent ions, such as the separation of Li+ and Mg2+ from seawater, a potential lithium source for the production of lithium-ion batteries. To the best of our knowledge, there is no e...

Germanium, a promising electrode material for high-capacity lithium ion batteries (LIBs) anodes, attracted much attention because of its large capacity and remarkably fast charge/discharge kinetics. Multivalent-ion batteries are of interest as potent...

Relatively few discharging playas in western United States extensional basins have high concentrations of lithium (Li) and calcium (Ca) in the basin-center brines. However, the source of both these ions is not well understood, and it is not clear why...

Lithium-sulfur (Li-S) batteries are deemed to be one of the most optimal solutions for the next generation of high-energy-density and low-cost energy storage systems. However, the low volumetric energy density and short cycle life are a bottleneck fo...

The adsorption of lithium ions(Li+) and the separation of lithium isotopes have attracted interests due to their important role in energy storage and nuclear energy, respectively. However, it is still challenging to separate the Li+ and its isotopes...

The lithium market has been expanding due to the high demand for lithium-ion batteries, which are essential for electric and hybrid vehicles as well as portable devices. This has driven the search for new lithium ore deposits and the development of m...

H1.6Mn1.6O4 lithium-ion screen adsorbents were synthesized by soft chemical synthesis and solid phase calcination and then applied to the recovery of metal Li and Co from waste cathode materials of a lithium cobalt oxide-based battery. The leaching e...

With the depletion of solid lithium ore, extracting lithium from salt lake brine has become a critical focus for future endeavors. A four-step method was used to synthesize high-purity H1.6Mn1.6O4 for extracting Li+. Porous cubic Mn2O3 was hydrotherm...

This study addresses the persistent challenge of polysulfide dissolution in lithium–sulfur (Li–S) batteries by introducing magnesium oxide (MgO) nanoparticles as a novel additive. MgO was integrated with sulfur using a scalable process in...

In this article, organic–inorganic hybrid materials with different functional groups were used to form organic–inorganic hybrid dense membranes for selective separation of mono/divalent ions by blending these materials and polyvinylidene...

The mineral content of the antlers reflects the nutritional status and specific stage of bone growth in cervid males. Therefore, this research aimed to analyze the concentration of Ca, P, Mg, K, Na, Li, V, Cr, Mn, Co, Cu, Zn, Se and Mo in three chara...

The shuttling effect of soluble lithium polysulfides (LiPSs) and the sluggish conversion kinetics of polysulfides into insoluble Li2S2/Li2S severely hinders the practical application of Li-S batteries. Advanced catalysts can capture and accelerate th...