Geostrophic turbulent eddies play a crucial role in the oceans, mixing properties such as heat, salt, and geochemical tracers. A useful reduced model for geostrophic turbulence is barotropic (2D) turbulence. The focus of this study is on 2D β -p...
β-Ga2O3 thin films grown on widely available c-plane sapphire substrates typically exhibit structural defects due to significant lattice and thermal expansion mismatch, which hinder the use of such films in electronic devices. In this work, we s...
In this paper, we demonstrate the direct epitaxial growth of c-plane GaN on a preheated (−2 0 1) β-Ga2O3 single-crystal substrate with no interlayer or pre-patterning processes by using the atmospheric pressure metalorganic chemical vapor deposition...
Aiming at the yaw stability problem of a four-wheel independent-drive electric vehicle (EV) during steering, this paper proposes an adaptive sliding mode control strategy (ASMC) for yaw stability based on the phase plane. The control strategy adopts...
This study performs a sensitivity analysis of strong cyclone track deflection over isolated topography, exploring the impacts of vortex impinging direction and strength. A dynamic model investigates track adjustments of cyclonic vortices on a β-...
This paper presents a mathematical model that describes the propagation of internal inertia–gravity waves in a stratified atmosphere under the approximations of an incompressible fluid and a traditional β-plane. It demonstrates that, in th...
The release of available potential energy by growing baroclinic instability requires the slope of the eddy fluxes to be shallower than that of mean density surfaces, where the amount of energy released depends on both the flux angle and the distance...
Research findings suggest that water (hydrological) cycle of the earth intensifies in response to climate change, since the amount of water that evaporates from the ocean and land to the atmosphere and the total water content in the air will increase...
The magnetic properties of 1 nm thick in-plane anisotropic Co ultrathin film on ZnO(0001) were investigated through successive 500 eV nitrogen-ion sputtering. Magneto-optical Faraday effects were used to observe the evolution of the ion-irradiated s...
The progressive collapse behavior and energy release of columnar jointed basalts (CJBs) can be greatly influenced by different joint distance ratios. By adopting the digital image correlation, a series of heterogeneous CJB models are established. The...
The hybrid manufacturing method of laser cladding deposition (LCD) additive manufacturing and electrochemical machining (ECM) is a promising approach to advanced manufacturing technology for difficult machined materials. The anisotropic electrochemic...
Titanium alloys are characterized by insufficient ductility. One of the parameters affecting their ductility is their crystal structure and texture. The present study characterizes the changes in the crystallographic texture of the Ti-3Al-8V-6Cr-4Zr-...
In this work, boron particles with β-rhombohedral structure were prepared in Cu-4B alloy. The morphology and growth mechanism of β-B and pentagonal twins were analyzed. Results show that boron crystals possessed an approximate octahedral st...
Strain engineering is a promising and fascinating approach to tailoring the electrical and optical properties of 2D materials, which is of great importance for fabricating excellent nano-devices. Although previous theoretical works have proved that t...
Multi-scale assessment of shear behavior in the tunnel carbonaceous slate is critical for evaluating the stability of the surrounding rock. In this study, direct shear tests were conducted on carbonaceous slates from the Muzhailing Tunnel, considerin...
The vibration excited by gas-liquid multiphase flow endangers the structural instability and fatigue life of subsea jumpers due to the cyclic behavior. In this paper, the multiphase flow-induced vibration (MFIV) of an M-shaped jumper is numerically i...
An accurate understanding of the tensile mechanical behavior of shale rock is essential for optimizing shale gas drilling and hydraulic fracturing operations. However, the mechanical behavior of shale is significantly influenced by its anisotropy. Th...
We present results on thin Ti-Nb-based films containing Hf at various concentrations grown by magnetron sputtering. The films exhibit α” patterns at Hf concentrations up to 11 at.%, while at 16 at.% Hf, the β-phase emerges as a stabl...
Phase transformations that take place in nanocrystalline Ag2S silver sulfide have been systematically studied at temperatures from 298 to 893 K. The crystal structures of the polymorphic modifications α-Ag2S, β-Ag2S, and γ-Ag2S of na...
A simple and inexpensive thermal oxidation process is used to grow β-Ga2O3 oxide (β-Ga2O3) thin films/nanorods on a c-plane (0001) sapphire substrate using Ag/Au catalysts. The effect of these catalysts on the growth mechanism of Ga2O3 was...
A high aluminum (Al) content β-(AlxGa1−x)2O3 film was synthesized on c-plane sapphire substrate using the gallium (Ga) diffusion method. The obtained β-(AlxGa1−x)2O3 film had an average thickness of 750 nm and a surface roughnes...
This review paper addresses the recent and past advancements in investigating the anisotropic behavior of foliated metamorphic rock strength subjected to uniaxial or triaxial compression loading, direct or indirect tensile loading, and shear loading....
Ferroelectric materials have received great attention in the field of data storage, benefiting from their exotic transport properties. Among these materials, the two-dimensional (2D) In2Se3 has been of particular interest because of its ability to ex...
Bismuth films with thicknesses between 6 and ∼30 nm were grown on Si (111) substrate by molecular beam epitaxy (MBE). Two main phases of bismuth — α-Bi and β-Bi — were identified from high-resolution X-ray diffraction (XRD)...
With the exploitation of shale gas booming all over the world, more and more studies are focused on the core technology, hydraulic fracturing, to improve commercial exploitation. Shale gas resources in China are enormous. In this research, a series o...
A high-performance Mg-10Gd-4Dy-1.5Ag-1Zn-0.5Zr (wt.%, EQ142X) alloy was designed by multi-element composite addition in this work, obtaining a high yield strength (~396 MPa) and ultimate tensile strength (~451 MPa) after hot extrusion and ageing. The...
Background: Graf’s method is currently the most commonly used ultrasound-based technique for the diagnosis of developmental dysplasia of the hip (DDH). However, the efficiency and accuracy of diagnosis are highly affected by the sonographers&rs...
A mesoscopic mechanical model based on the Mori-Tanaka method and Eshelby’s inclusion theory was presented to investigate the uniform elastic deformation behavior of Ti6Al4V with β-Ti and α-Ti phases. In particular, elastic mechanics...
With the increase in PV system installations, the available free land and rooftops for these systems may become scarcer, and therefore sloped fields facing the north may be utilized for that purpose. In deployments of PV collectors in multiple rows,...
The ability of the lumbar extensor muscles to accurately control static and dynamic forces is important during daily activities such as lifting. Lumbar extensor force control is impaired in low-back pain patients and may therefore explain the varianc...
The Fermi surface structure of a layered organic superconductor β″-(BEDT-TTF)2SF5CH2CF2SO3 was determined by angular-dependent magnetoresistance oscillations measurements and band-structure calculations. This salt was found to have two sma...
Objectives: This study aimed to determine the impacts of upper and lower limb (UL and LL) spasticity and impairment on spinal alignment in chronic post-stroke patients. Methods: A total of 45 consecutive chronic post-stroke patients, 18 women and 27...
We have analyzed the distribution of early-type galaxies (ETGs) in the effective surface intensity vs. effective radius (Ie−Re) plane and in the total luminosity vs. central stellar velocity dispersion (L−σ) diagram, with the aim of studying the phys...
Ball-end cutters are widely used for machining the parts of Ti-6Al-4V, which have the problem of poor machined surface quality due to the low cutting speed near the tool tip. In this paper, through the experiments of inclined surface machining in dif...
Real-time structural changes in Na-β″-alumina were observed in situ using transmission electron microscopy (TEM) with electron beam irradiation. Na-β″-alumina has been widely investigated as a solid electrolyte material for sodi...
In this work, it is taken into account that in nature, due to pressure and temperature, water drops in general are either spherical or ellipsoidal. Thus, starting from a more general structure, a 3D elliptical surface (oblate spheroid) is constructed...
In this work, we have achieved synthesizing large-area high-density β-Ga2O3 nanowires on c-plane sapphire substrate by metal–organic chemical vapor deposition assisted with Au nanocrystal seeds as catalysts. These nanowires exhibit one-dim...
The ability of PLLA, either amorphous or semicrystalline, to plastic deformation to large strain was investigated in a wide temperature range (Td = 70–140 °C). Active deformation mechanisms have been identified and compared for two differen...
This paper presents a study on the seismic performance of rectangular hollow section (RHS) X-joints subjected to in-plane bending moment (IPBM). The study began by testing two RHS joint specimens with varying brace-to-chord width ratios (β) unde...
Dislocation slips, twinning, shear banding (SBs), strain localization, and martensite formation are a few deformation modes that are activated in BCC metals and alloys. Strain, strain rate, and deformation temperature are other parameters that determ...
The amyloid structures and their wild type forms, available in the PDB database, provide the basis for comparative analyses. Globular proteins are characterised by a 3D spatial structure, while a chain in any amyloid fibril has a 2D structure. Anothe...
The structure of µ-oxobis(phthalocyaninato)gallium(III) (PcGaOGaPc) and the structure of a second modification of chloro(phthalocyaninato)gallium(III) (ClGaPc) has been determined by single-crystal X-ray analysis. Sublimation of the respective...
Centroid-based clustering is a widely used technique within unsupervised learning algorithms in many research fields. The success of any centroid-based clustering relies on the choice of the similarity measure under use. In recent years, most studies...
We consider a quantum charged particle moving in the x y plane under the action of a time-dependent magnetic field described by means of the linear vector potential of the form A = B ( t ) − y ( 1 + β ) , x ( 1 − &beta...
To obtain high-quality n-type doped β-Ga2O3 films, silane was used as an n-type dopant to grow Si-doped β-Ga2O3 films on (100) β-Ga2O3 substrates by metal-organic chemical vapor deposition (MOCVD). The electron concentrations of the Si-doped β-Ga2O3...
We provide a theory for employing Förster resonance energy transfer (FRET) measurements to determine altered heteropentameric ion channel stoichiometries in intracellular compartments of living cells. We simulate FRET within nicotinic receptors (nACh...
Simultaneous measurements of wide-angle X-ray diffraction (WAXD) and differential scanning calorimetry (DSC) were carried out to investigate the phase transition and melting behaviors of poly(butylene adipate) (PBA). Thermal expansion changes along t...
The chiral crystal of enantiomeric (S)-N-3,5-di-tert-butylsalicylidene-1-phenylethylamine in the enol form [enol-(S)-1] undergoes a reversible single-crystal-to-single-crystal (SCSC) phase transition at Tc ≈ 3 °C from the room temperature α-form in o...
This study assessed arterial stiffness in head and neck cancer patients using speckle tracking carotid strain ultrasonography (STCS-US). It investigated the impacts of neck irradiation and neck dissection on the arterial stiffness of these patients b...
Gallium oxide (Ga2O3) is a semiconductor with a wide bandgap of ~5.0 eV and large breakdown voltages (>8 MV·cm−1). Among the crystal phases of Ga2O3, the monoclinic β-Ga2O3 is well known to be suitable for many device application...
of 5