A carbon solid acid with large surface area (CSALA) was prepared by partial carbonization of H3PO4 pre-treated peanut shells followed by sulfonation with concentrated H2SO4. The structure and acidity of CSALA were characterized by N2 adsorption–desor...
CeO2 is an outstanding support commonly used for the CuO-based CO oxidation catalysts due to its excellent redox property and oxygen storage–release property. However, the inherently small specific surface area of CeO2 support restricts the fur...
In recent years, high-quality surfaces with large areas and curvatures have been increasingly used in engineering, but the precision machining and inspection of such surfaces is a particular challenge. Surface machining equipment needs to have a larg...
Forest surface area is a fundamental input for forest-related research, such as carbon balance, biodiversity conservation, and ecosystem functioning and services. However, an accurate assessment of the area of forestland in China is not available bec...
Nanogap sensors have a wide range of applications as they can provide accurate direct detection of biomolecules through impedimetric or amperometric signals. Signal response from nanogap sensors is dependent on both the electrode spacing and surface...
10 September 2022
Local exhaust ventilation is an important method of contamination control, and the type of exhaust hood and the air distribution at the hood face have an important influence on the contamination control effect. When the hood face is large, it is diff...
Green and short preparation of CeO2 nanoparticles with large specific surface area from rare earth extraction (CeCl3) was successfully achieved by spray pyrolysis (SP). In this method, a precursor solution is first prepared by mixing CeCl3, C6H8O, an...
Wearable triboelectric nanogenerators (TENGs) have attracted interest in recent years, which demand highly flexible, scalable, and low-cost features. Here, we report an ultra-flexible, large-scale and textile-based TENG (T-TENG) for scavenging human...
Using multi-power supply units to power large-area electrothermal films can achieve high electrothermal power under low voltage. However, this method may result in poor contact between the electrodes and the electrothermal film, especially for films...
Adsorption is an economical and efficient method for wastewater treatment, and its advantages are closely related to adsorbents. Herein, the Abutilon theophrasti medicus calyx (AC) was used as the precursor for producing the porous carbon adsorbent (...
Despite intensive research activities in the field of laser-induced periodic surface structures (LIPSS), the large-area nanostructuring of glasses is still a challenging problem, which is mainly caused by the strongly non-linear absorption of the las...
Surface plasmon resonance (SPR) sensors based on a silver film suffer from signal degradation due to silver oxidation in aqueous sensing environments. To overcome this limitation, we fabricated the planar plasmonic substrate employing an atomic MoS2...
To get the maximum heat transfer in real applications, the surface area of the micro-features (micro-channels) needs to be large as possible. It can be achieved by producing a maximum number of micro-channels per unit area. Since each successive pair...
In this work, we have proposed and optimized a segmented cladding fiber (SCF) with a large mode area (LMA) consisting of a uniform core and a double cladding. The outer cladding of the SCF consisted of a periodic alternation of high- and low-refracti...
Sub-wavelength metallic nanostructures allow the squeezing of light within nanoscale regions, called plasmonic hotspots. Squeezed near-field light has been demonstrated to detect, modulate, and generate light in more effective ways. The enhanced elec...
Large-area remote sensing time-series offer unique features for the extensive investigation of our environment. Since various error sources in the acquisition chain of datasets exist, only properly validated results can be of value for research and d...
Here we report a low-cost synthetic approach for the direct fabrication of large-area Au nanourchin arrays on indium tin oxide (ITO) via a facile galvanic-cell-reaction-driven deposition in an aqueous solution of chloroauric acid and poly(vinyl pyrro...
The use of a cylindrical lens in femtosecond laser surface structuring is receiving attention to improve the processing efficiency. Here, we investigate the structures produced on a copper target, in air, by exploiting both spherical and cylindrical...
Data from the U.S. Defense Meteorological Satellite Program’s Operational Line-scan System are often used to map impervious surface area (ISA) distribution at regional and global scales, but its coarse spatial resolution and data saturation produce h...
Humidity sensors provide environmental conditions suitable for several applications. However, they suffer from a limited reliable range originating from the low electrical conductivity and low water-sensitive sites of humidity-sensing materials. In t...
A large-area spray coating process is introduced to efficiently apply a graphene/Cu/cellulose composite on a flexible glass substrate. The dispersion characteristics of nano-additives are measured and the Tyndall effect observed. The characteristics...
The ecological environment of Yellow River Delta High-efficiency Ecological Economic Zone (YRDHEEZ) is adjacent to the Bohai Sea. The unique geographical location makes it highly sensitive to anthropogenic disturbances. As an important land surface b...
The demand for synthetic diamonds and research on their use in next-generation semiconductor devices have recently increased. Microwave plasma chemical vapor deposition (MPCVD) is considered one of the most promising techniques for the mass productio...
Chalcogenide vitreous semiconductors (ChVSs) find application in rewritable optical memory storage and optically switchable infrared photonic devices due to the possibility of fast and reversible phase transitions, as well as high refractive index an...
Antibacterial surfaces inspired by biological micro- and nanostructures, such as those found on the wings of cicadas and dragonflies, have attracted interest due to their ability to inhibit bacterial adhesion and damage microbial membranes without re...
Micro- and nanopatterning is crucial for advanced photonic, electronic, and sensing devices. Yet achieving large-area periodic nanostructures with a 75 nm half-pitch on low-cost laboratory systems remains difficult, because conventional near-ultravio...
A porous carbon structure (PCS) is considered as an ideal electrode material for lithium–sulfur (Li–S) batteries, owing to its flexible texture, large surface area, and high electrical conductivity. In this work, we use food-grade yeast as the carbon...
Ferromagnetic films down to thicknesses of tens of nanometers and composed by polycrystalline Fe and Fe2O3 nanopillars are grown in large areas by glancing angle deposition with magnetron sputtering (MS-GLAD). The morphological features of these film...
Bio-inspired surfaces with superamphiphobic properties are well known as effective candidates for antifouling technology. However, the limitation of large-area mastering, patterning and pattern collapsing upon physical contact are the bottleneck for...
Electron–hole recombination and the narrow-range utilization of sunlight limit the photocatalytic efficiency of titanium oxide (TiO2). We synthesized carbon dots (CDs) and modified TiO2 nanoparticles (NPs) with a flower-like mesoporous structur...
Impacted by global warming, the global sea surface temperature (SST) has increased, exerting profound effects on local climate and marine ecosystems. So far, investigators have focused on the short-term forecast of a small or medium-sized area of the...
With the wide application of intense lasers, the protection of human eyes and detectors from laser damage is becoming more and more strict. In this paper, we study the nonlinear optical limiting (OL) properties of porous carbon with a super large spe...
Flexible and transparent surface-enhanced Raman scattering (SERS) substrates have attracted considerable attention for their ability to enable the direct in situ detection of analytes on curved surfaces. However, the curvature of an object can impact...
Ever increasing data volumes of satellite constellations call for multi-sensor analysis ready data (ARD) that relieve users from the burden of all costly preprocessing steps. This paper describes the scientific software FORCE (Framework for Operation...
This study evaluated the effects of photovoltaic (PV) arrays on critical surface parameters through analysis of observational data collected from a utility-scale PV power station located in Wujiaqu City, Xinjiang, in 2021. The results reveal that: (1...
In this study, one-dimensional porous silicon nanowire (1D–PSiNW) arrays were fabricated by one-step metal-assisted chemical etching (MACE) to etch phosphorus-doped silicon wafers. The as-prepared mesoporous 1D–PSiNW arrays here had especially high s...
A highly efficient adsorbent for methylene blue (MB) adsorption was developed by combination of carboxymethyl cellulose (CMC) and graphene oxide (GO) via a simple one-step hydrothermal method. The as-synthesized CMC/GO composite aerogel has a mesopor...
Most glaciers in China lie in high mountainous environments and have relatively large surface slopes. Common analyses consider glaciers’ projected areas (2D Area) in a two-dimensional plane, which are much smaller than glacier’s topographic surface e...
Background: Body surface area is a key determinant of cardiac morphology and function, but it is often underestimated in the interpretation of athlete’s cardiac phenotypes. Aims: This study aimed to assess the role of anthropometric characteris...
Tactile sensing is important for robots to perceive the world as it captures the physical surface properties of the object with which it is in contact and is robust to illumination and colour variances. However, due to the limited sensing area and th...
Interferometric synthetic aperture radar (InSAR) technology can obtain one-dimensional surface displacements in the radar line of sight (LOS). In the field of mining subsidence, large 3D movements often occur at the same time, and hence InSAR derived...
The global path planning system is one of the basic systems ensuring the autonomous operation of unmanned underwater vehicles (UUVs) and unmanned surface vehicles (USVs) in a complex aquatic environment. The A* path planning algorithm is one of the m...
Flexible sensors are highly advantageous for integration in portable and wearable devices. In this work, we propose and validate a simple strategy to achieve whole wafer-size flexible SERS substrate via a one-step metal-assisted chemical etching (MAC...
Adopting a comprehensive, basin-wide method for preventing flood disasters would be effective to deflect the climate-change-induced intensified water-related disasters. This study considers the land use and settlement patterns based on microtopograph...
Silicon-based anodes suffer from the loss of physical integrity due to large volume changes during alloying and de-alloying processes with electrolytes. By integrating electrochemically inert, physically strong, ductile nickel layers with a multi-lay...
We have performed large-eddy simulations (LES) to study the effect of complex land topography on the atmospheric boundary layer (ABL) in coastal areas. The areas under investigation are located at three beaches in Monterey Bay, CA, USA. The sharp-int...
Solid acid catalysts generally show the disadvantage of low acid amount and low recycling rate. To solve these problems, corn stalk-based solid acid catalysts were synthesized through carbonization and sulfonation processes in this work. The results...
Cell membrane receptors bind to extracellular ligands, triggering intracellular signal transduction pathways that result in specific cell function. Some receptors require to be associated forming clusters for effective signaling. Increasing evidences...
The semi-automated extraction of flat surface landforms was carried out, merging a GIS tools application and a geomorphic analysis. The study focuses on seven areas in southern Italy, characterized by different physical landscapes, using a 5 m resolu...
Graphene and its derivatives have many superior electrical, thermal, mechanical, chemical, and structural properties, and promise for many applications. One of the issues for scalable applications is the lack of a simple, reliable method that allows...
of 146