Single-atom catalysts anchored to oxide or carbonaceous substances are typically tightly coordinated by oxygen or heteroatoms, which certainly impact their electronic structure and coordination environment, thereby affecting their catalytic activity....
CO-selective methanation (CO-SMET) is an efficient hydrogen-rich (H2-rich) gas purification technology for proton exchange membrane fuel cells. It is vital to develop suitable catalysts with good low-temperature activity for CO-SMET reactions. In thi...
Privileged structures is a term that is used in drug design to indicate a fragment that is popular in the population of drugs or drug candidates that are in the application or investigation phases, respectively. Privileged structures are popular moti...
The reductive catalytic fractionation of flax shives in the presence of bimetallic NiRu catalysts supported on oxidized carbon materials (CM) such as mesoporous Sibunit and carbon mesostructured by KAIST (CMK-3) was studied. The catalysts based on CM...
Samarium oxide (Sm2O3) is a versatile surface for CO2 and H2 interaction and conversion. Samarium oxide-supported Ni, samarium oxide-supported Co-Ni, and samarium oxide-supported Ru-Ni catalysts were tested for CO2 methanation and were characterized...
CO selective methanation is regarded as an efficient technological solution for hydrogen-rich gas purification in fuel cells. In this study, a series of bimetallic catalysts (Ru-Ni/xTiO2-MgAl2O4) were synthesized by impregnation method after surface...
In this study, a Ru-doped Ni pellet-type catalyst was prepared to produce hydrogen via steam methane reforming (SMR). A small amount of Ru addition on the Ni catalyst improved Ni dispersion, thus affording a higher catalytic activity than that of the...
CO selective methanation (CO-SMET) is a promising method for deep CO removal from H2-rich gases. In this study, a series of RuNi/MMO catalysts are prepared using the support MMO-N derived from NiAl-NO3-LDHs, which was prepared from NiAl-CO3-LDHs via...
Hydrogenolysis via targeted depolymerization of C–O linkages is a techno-economic beneficial process for converting lignin into highly valuable chemicals and clean fuels. In this work, a macroporous silicalite-1 (S-1) array-supported Ru-Ni meta...
Doping of Ru has been used to enhance the performance of LiNi0.5Mn1.5O4 cathode materials. However, the effects of Ru doping on the two types of LiNi0.5Mn1.5O4 are rarely studied. In this study, Ru4+ with a stoichiometric ratio of 0.05 is introduced...
This work presents, for the first time, the comparative physicochemical and reactivity studies of a range of bimetallic Pt-Ni, Pd-Ni, Ru-Ni, and Ag-Ni catalysts in the oxy-steam reforming (OSR) of liquefied natural gas (LNG) reaction towards hydrogen...
This study proposes a combination system consisting of a biogas dry reforming reactor and a solid oxide fuel cell (SOFC). Since biogas dry reforming is an endothermic reaction, this study adopted a membrane reactor operated due to the non-equilibrium...
CO2 emissions in the atmosphere have been increasing rapidly in recent years, causing global warming. CO2 methanation reaction is deemed to be a way to combat these emissions by converting CO2 into synthetic natural gas, i.e., CH4. NiRu/CeAl and NiRu...
This piece of work dealt with the concept of ‘biogas upgrading’ or enrichment of the CH4 contained in a sweetened biogas to proportions and features comparable to those of synthetic natural gas (SNG). For this, the behavior of three lab m...
Lignin obtained by hydrogenolysis of lignocellulose biomass is a prospective source of valuable green fuels and chemicals such as monophenols. One of the key factors in the chemical decomposition of lignin to monophenols is an efficient catalyst. Ine...
Ruthenium addition inhibits the formation of the topologically close-packed phases in Ni-based superalloys and improves the solid solution strength of Ni–Ti shape memory alloys. Therefore, the Ni–Ti–Ru phase stability is a very valu...
Ru and Ni on alumina catalysts have been promoted with a 10 wt% of alkali metal (K or Na) or alkaline earth metal (Ba) and tested in CO2 methanation. For the catalyst consisting of Ni and Ba, the variation of Ba loading while keeping Ni loading const...
The aim of the present study was to clarify the influence of the thickness of the Pd/Cu membrane on the characteristics of biogas dry reforming (BDR) with aNi/Cr/Ru catalyst. We also clarified the impact of the reaction temperature, the molar ratio o...
CO2 methanation is recognized as one of the best technologies for storing intermittent renewable energy in the form of CH4. In this study, CO2 methanation performance is investigated using Ni/Al2O3, Ru/Al2O3, and Ru-Ni/Al2O3 as the catalysts under co...
In this study, we investigated the catalytic performance of Ru nanoparticles (NPs) supported on Ni-nanowires for the first time. This appears to be a highly efficient catalyst for low-temperature methanation, e.g., ca. 100% conversion and 100% of CH4...
Pt(Ni)/C and PtRu(Ni)/C catalysts were synthesized by electroless deposition of Ni on a carbon dispersion followed by sequenced Pt deposition and spontaneous deposition of Ru species. The structural analyses of the catalysts with 88:12 and 98:2 Pt:Ni...
The development of highly conductive structured catalysts with enhanced mass- and heat-transfer features is required for the intensification of the strongly exothermic catalytic hydrogenation of CO2 in which large temperature gradients should be avoi...
Nickel–ruthenium–phosphorus, Ni–Ru–P, alloy coatings were fabricated by magnetron dual-gun co-sputtering from Ni–P alloy and Ru source targets. The composition variation and related microstructure evolution of the coatin...
In order to reduce greenhouse gas emissions, which are reaching alarming levels in the atmosphere, capture, recovery, and transformation of carbon dioxide emitted to methane is considered a potentially profitable process. This transformation, known a...
NiFe2O4 material is grown on carbon paper (CP) with the hydrothermal method for use as electrocatalysts in an alkaline electrolyzer. NiFe2O4 material is used as the anode and cathode catalysts (named NiFe(+)/NiFe(−) hereafter). The results are...
Tuning the chemical and structural environment of Ru-based nanomaterials is a major challenge for achieving active and stable hydrogen evolution reaction (HER) electrocatalysis. Here, we anchored ultrafine Ru nanoparticles (with a size of ~4.2 nm) on...
The paper introduces spatially stable Ni-supported bimetallic catalysts for CO2 methanation. The catalysts are a combination of sintered nickel mesh or wool fibers and nanometal particles, such as Au, Pd, Re, or Ru. The preparation involves the nicke...
The current work focused on the sunlight-driven thermo-photocatalytic reduction of carbon dioxide (CO2), the primary greenhouse gas, by ethane (C2H6), the second most abundant element in shale gas, aiming at the generation of ethanol (EtOH), a renewa...
Pyrrhotite (or Cu-poor) massive ores of the Skalisty mine located in Siberia, Russia, are unique in terms of their geochemical features. These ores are Ni-rich with Ni/Cu ratios in the range 1.3–1.9 and contain up to 12.25 ppm Ir + Rh + Ru in b...
A simple method is presented for incorporating various catalytic metals into the pores of SBA-15 using vapor-phase infiltration. The precursors used in Atomic Layer Deposition (ALD) for Pt, Pd, Rh, Ru, and Ni were exposed to an evacuated SBA-15, resu...
With the development and wide application of nickel-based single-crystal superalloys, the effect of Ru on the microstructure stability and high-temperature properties of superalloys is becoming increasingly important. In this study, the effect of Ru...
Mono-, and bimetallic Ni-, Ru-, and Pt-modified nanosized Beta zeolite catalysts were prepared by the post synthesis method and characterized by powder X-ray diffraction (XRD), nitrogen physisorption, HRTEM microscopy, temperature-programmed reductio...
Fluidizable catalysts based on Ni/Al2O3 with added Ru were used for the gasification of a lignin surrogate (2-methoxy-4-methylphenol) in a fluidized CREC Riser Simulator reactor. This was done in order to quantify lignin surrogate conversion and li...
Boron presents an important role in chemistry, biology, and materials science. Diatomic transition-metal borides (MBs) are the building blocks of many complexes and materials, and they present unique electronic structures with interesting and peculia...
The sulfur-iodine (SI) cycle holds great promise as an alternative large-scale process for converting water into hydrogen without CO2 emissions. A major issue regarding the long-term stability and activity of the catalysts is their poor sulfur deacti...
Using anthropogenic carbon dioxide (CO2) as a feedstock for the production of synthetic fuel has gained significant attention in recent years. Among the various CO2 conversion pathways, the production of synthetic natural gas via CO2 methanation hold...
Designing efficient and cost-effective electrocatalysts is crucial for the large-scale development of sustainable hydrogen energy. Amorphous catalysts hold great promise for application due to their structural flexibility and high exposure of active...
Mono- and bimetallic Ni- and Ru-modified micro-mesoporous ZSM-5 catalysts were prepared by wet impregnation. The influence of the Ni content, the addition of Ru and the sequence of the modification by two metals on the physicochemical properties of t...
The propane steam reforming (PSR) reaction was investigated over catalysts derived from LaNiO3 (LN), La0.8Sr0.2NiO3 (LSN), and noble metal-substituted LNMx and LSNMx (M = Ru, Rh; x = 0.01, 0.1) perovskites. The incorporation of foreign cations in the...
In view of a possible use as anode materials in acidic direct alcohol fuel cells, the electro-catalytic activity of Pt-Ni and Pt-M-Ni (M = Ru, Sn) catalysts for methanol and ethanol oxidation has been widely investigated. An overview of literature da...
Developing a novel ammonia synthesis process from N2 and H2 is of interest to the catalysis and hydrogen research communities. γ-Alumina-supported nickel was determined capable of serving as an efficient catalyst for ammonia synthesis using non...
Hydrogen is an energy vector with a great potential due its ample range of applications and clean combustion cycle. Hydrogen can be produced through biomass steam gasification, with novel catalysts being of significant value to implement this process...
Experiments on the preparation of the new mixed cations XeF5M(AF6)3 (M = Cu, Ni; A = Cr, Nb, Ta, Ru, Rh, Re, Os, Ir, Pt, Au, As), XeF5M(SbF6)3 (M = Sn, Pb), and XeF5M(BF4)x(SbF6)3-x (x = 1, 2, 3; M = Co, Mn, Ni, Zn) salts were successful only in the...
PtM/C (M = Co, Ni, Cu, Ru) catalysts were prepared by wet-synthesis methods. The composition and structure of the synthesized materials were estimated by TXRF, XRD, TEM, HAADF-STEM, EDX, and TGA/DSC methods. According to the CV and LSV methods, the P...
To enhance the tribological properties of the coatings and to inhibit cracking, sandwich-structured composite coatings were fabricated, consisting of a Ni60CuMo/IN718 transition layer and a Ni60CuMo/Ni-coated Cu wear-resistant layer with four differe...
By testing the creep properties of a Re/Ru-containing single-crystal alloy specimen and examining the microstructural evolution of the allow at different stages of creep using scanning electron microscopy (SEM) and transmission electron microscopy (T...
Bipyridyl Ruthenium-decorated Ni-MOFs on multi-walled carbon nanotubes (MWCNT-RuBpy@Ni-MOF) were synthesized. In an alkaline solution, the glucose was electrocatalytically oxidized at +0.5 V vs. Ag/AgCl at the composite interface of MWCNT-RuBpy@Ni-MO...
A CuNiCe-O nanocomposite was fabricated on the Cu40Ni20Al10Ce26Pt3Ru1 metallic glass (MG) ribbon surface by dealloying. The influences of Ni and dealloying time on the morphology and EOR performance were analyzed. The results suggest that the catalyt...
20 April 2022
Background: Aging increases the risk of chronic diseases, which can challenge the ability to work and thereby push senior workers out of the labour market. This study investigates the association between non-communicable diseases (NCDs) and work abil...
Bulbophyllum abangjoei is a new one-flowered orchid species described from Lanjak Entimau Wildlife Sanctuary, Katibas and Anap-Muput, Tatau, Sarawak. The taxonomic treatment is accompanied by taxonomic notes, information on the species’ affinit...
of 5