61 Results Found

As an important detection tool in biochemistry, fluorescence detection has wide applications. Quantitative detection can be achieved by detecting fluorescence signals excited by excitation light at a specific wavelength range. Therefore, the key to f...

The failure mechanism of two commercial light-emitting diode (LED)-based spotlights with GU10 form factor is analyzed. Through component testing and comparison to nominal values as well as to simulations, it is found that the cause of both device fai...

Light emitted diode (LED) is becoming more popular in the illumination field, and the design of LED lighting is generally made to provide illumination at lower power usage, helping save energy. A power electronic converter is needed to provide the po...

Micro-LED is a new technology applied in the display field, which has the advantages of self-illumination, low power consumption, high brightness, long life and ultra-high resolution, and has broad application prospects. Using MOS devices to drive mi...

This study is about an improved high-quality light-emitting diode (LED) converter for a T8 LED tube. The converter is separated into the AC driving circuit and DC driving circuit. Also, the LED tube was applied with an output ripple eliminator for th...

With the global advocacy of green lighting and the urgent need for energy saving and carbon reduction, more and more street lighting applications have entered the era of being replaced by light-emitting diode (LED) lighting sources. This paper presen...

Traditional light-emitting diode (LED) drivers with pulse-width modulation (PWM)-type converters suffer the problem of hard switching, leading to low circuit efficiency and low reliability. LED drivers supplied by alternating current (AC) line source...

In order to reduce the cost and improve the reliability, real-time performance, and installation convenience of remote-controlled light-emitting diode (LED) lighting systems, a networked LED driving technology based on the direct current (DC) grid po...

This paper proposes a dimmable light-emitting diode (LED) driver featuring a high power factor and zero-voltage switching on (ZVS). The circuit is obtained by integrating a boost converter and a dc-dc converter with half-bridge topology. The high pow...

Three LED drivers which can be used for illumination, but whose main task is the transmission of information (data) via the light of the LEDs, are explored in this paper. The converter circuits need no capacitors for the energy transformation and avo...

The research proposed a novel LED driver with the functions of power-factor correction (PFC) and current balancing. A flyback converter and a Class-D series resonant converter were integrated by sharing an active switch to form a single-stage circuit...

This paper proposes a single-stage, high power-factor light-emitting diode (LED) driver with a self-excited control scheme for the power switches. The self-excited mechanism is accomplished by fetching the driving voltages from a center-tapped transf...

In this paper, a new LLC converter for series-connected, high-voltage LEDs is proposed. The proposed LLC converter consists of two stacked, single-ended rectifiers and one balancing capacitor, to compensate for the current deviation of two individual...

In this research, a step-down converter with a lossless snubber is proposed, and its output is floating; therefore, it can be applied to LED driving applications. Such a structure is a modification of the conventional buck converter by adding a reson...

Regulating LED current and voltage is critical to maintaining a constant luminous flux in AC- or DC-powered LED lighting circuits. Today, users require constant current drivers that can provide a wide range of output voltages to drive different numbe...

This paper presents the implementation of a two-stage light-emitting diode (LED) driver based on commercial integrated circuits (IC). The presented LED driver circuit topology, which is designed to drive a 150 W LED module, consists of two stages: AC...

This paper presents the design of a 40 × 40 micro-light-emitting (micro-LED) test array based on a 20 mm × 20 mm substrate. A study of the relationship between luminous brightness, driving current, and driving voltage revealed that the da...

With the application of stitching technology in large-pixel-array CMOS image sensors, the problem of non-synchronized output signals from pixel array bilateral driver circuits has become progressively more serious and has led to the DC perforation of...

With the advent of direct current (DC) loads such as LED lighting, IT equipment, electric vehicles, and DC powers generated from renewable energy sources, low voltage DC (LVDC) distribution system is becoming a hot issue. One of the hurdles in the LV...

In this study, to achieve the constant current drive and brightness control without a separate pulse width modulation (PWM) converter, a single converter is designed and verified by experiment under the condition of a multiple LED light load with di...

Micro-light-emitting diodes (micro-LEDs) are the key to next-generation display technology. However, since the driving circuits are typically composed of Si devices, numerous micro-LED pixels must be transferred from their GaN substrate to bond with...

More and more light-emitting diode lighting devices (LED) are being connected to modern power distribution lines. In addition to its many positive features, this poses problems in terms of reactive power compensation. The large number of LEDs interac...

Monolithic micro LED display arrays show potential for application in small-area display modules, such as augmented reality (AR) displays. Due to the short distance between micro LEDs and the monolithic transparent substrate, a light crosstalk phenom...

A photoplethysmography (PPG) sensor is a cost-effective and efficacious way of measuring health conditions such as heart rate, oxygen saturation, and respiration rate. In this work, we present a hybrid PPG sensor system working in a reflective mode w...

This study developed and implemented a driving power supply for light-emitting diode (LED) array streetlamps. The power stage was a quasi-resonant (QR)-flyback converter, its input power was the alternating-current power, and the LED array streetlamp...

Polymerase chain reaction (PCR) is a technique for nucleic acid amplification, which has been widely used in molecular biology. Owing to the limitations such as large size, high power consumption, and complicated operation, PCR is only used in hospit...

A novel interleaved DC-DC buck converter is proposed to drive high-brightness light-emitting diodes (LEDs). The circuit configuration mainly consists of two buck converters, which are connected in parallel and use interleaved operation. Through inter...

Recently, due to the miniaturization of electronic products, printed circuit boards (PCBs) have also become smaller. This trend has led to the need for high-precision electrical test equipment to check PCBs for disconnections and short circuits. The...

In this article, a three-leg interleaved boost Power Factor Corrector (IBPFC) converter for energy-efficient LED lighting systems connected to the main grid was discussed. This IBPFC circuit presented features 60 kHz of commutation frequency and up t...

In capturing high-quality photoplethysmographic signals, it is crucial to ensure that appropriate illumination intensities are used. The purpose of the study was to deliver controlled illumination intensities for a multi-wavelength opto-electronic pa...

Electronic skin that is deformable, self-healable, and self-powered has high competitiveness for next-generation energy/sense/robotic applications. Herein, we fabricated a stretchable, self-healable triboelectric nanogenerator (SH-TENG) as electronic...

The significant advantages of permanent magnet synchronous motors, such as very good dynamic properties, high efficiency and power density, have led to their frequent use in many drive systems today. However, like other types of electric motors, they...

In the current era marked by the growing adoption of renewable energy sources, the use of photovoltaic-powered LED streetlights, known for their enhanced efficiency and extended lifespan, is on the rise. This lighting solution encompasses essential c...

Recently, the triboelectric nanogenerator (TENG) for harvesting low-frequency energy has attracted the attention of academia. However, there are few studies on environmentally friendly triboelectric materials. Here, we propose a novel triboelectric n...

To apply visible light communication systems in different scenarios, this article utilizes an excellent temperature-adjustable light source mixed with RGB LEDs and applies it in a visible light communication system. It uses color division multiplexin...

Electrospinning techniques have been widely applied in diverse applications, such as biocompatible membranes, energy storage systems, and triboelectric nanogenerators (TENGs), with the capability to incorporate other functional materials to achieve s...

A novel four-in-one (4-in-series) MicroLED-in-Package (MiP4) architecture is demonstrated for the first time, integrating four sub-85 µm blue micro-LED (µ-LED) dies on a transparent glass substrate through a redistribution-layer (RDL) int...

Newly introduced Photovoltaic (PV) devices, featuring a built-in chip with an illuminating Light Emitting Diode (LED), have emerged in the commercial market. These devices are touted for their utility as both low- and high-side power switch drivers a...

The method for estimating the immunity of an AC/DC converter built in a commercial LED lamp to a 1.2/50 µs (8/20 µs) surge has been presented in this paper. A lamp with a direct drive LED inverter was selected to present the methodology f...

The increasing demand for electric vehicles (EVs) in the transportation industry, especially for efficient battery–electric trucks, has led to an increase in studies on the efficiency or energy consumption of commercial vehicles. In this paper,...

Triboelectric nanogenerators with the function of harvesting human motion energy have attracted wide attention. Here, we demonstrate a shared-electrode and nested-tube structure triboelectric nanogenerator (SNTN) for harvesting human motion energy. T...

Recent years, triboelectric nanogenerators (TENGs) have attracted increased attention from researchers worldwide. Owing to their conductivity and triboelectric characteristics, metal materials can be made as both triboelectric materials and conductiv...

Recently, natural material-based triboelectric nanogenerators (TENGs) have increasingly attracted attention in academic circles. In this work, we have developed an innovative triboelectric nanogenerator (BL-TENG) utilizing bamboo leaves to capture bi...

Metal–organic chemical vapor deposition (MOCVD) is a crystal growth technique used to achieve high-purity thin films, especially III–V materials, for fabricating semiconductor devices. It allows for thickness tunability, controlled doping...

Sharp GP2Y1010 dust sensors are increasingly being used within distributed sensing networks and for personal monitoring of exposure to particulate matter (PM) pollution. These dust sensors offer an easy-to-use solution at an excellent price point; ho...

Underwater robots have been widely used in ocean exploration, deep-sea observation, seabed operations, marine scientific research, and other fields. Underwater low-latency, efficient, and safe communication modes are key to realizing the application...

Carbon nanotube/polymer-based composites have led to studies that enable the realization of low-cost, high-sensitivity piezoresistive strain sensors. This study investigated the characteristics of piezoresistive multi-walled carbon nanotube (MWCNT)/e...

This paper describes a one-port mechanical resonance detection scheme utilized on a piezoelectric thin film driven silicon circular diaphragm resonator and discusses the limitations to such an approach in degenerate mode mass detection sensors. The s...

Soft robots with good deformability and adaptability have important prospects in the bionics and intelligence field. However, current research into soft robots is primarily limited to the study of actuators and ignores the integrated use of functiona...

A new technique to reduce flicker noise generated in light-fidelity (Li-Fi) transmission links based on the white light-emitting diode (LED) is proposed. Here, flicker noise with a frequency of 120 Hz, which is twice the frequency of AC power (60 Hz)...