Skip to Content
  • 4.3
    Impact Factor
  • 5.7
    CiteScore
  • 19 days
    Submission to First Decision
  • 4 days
    Acceptance to Publication

Environments

Environments is an international, peer-reviewed, open access journal on environmental sciences published monthly online by MDPI.

Get Alerted

Add your email address to receive forthcoming issues of this journal.

All Articles (2,507)

  • Article
  • Open Access

Mangrove forests are carbon-rich, yet their dense canopies and intertidal setting hinder ground-based monitoring. Unmanned aerial vehicles (UAVs) offer an alternative but impose a trade-off: high-altitude flights cover larger areas, whereas low-altitude flights resolve individual crowns. This study proposes a field-based protocol for super-resolution of mangrove UAV imagery trained on image pairs acquired at two different flight altitudes. Images were acquired at 82 locations in the Ao Kung mangrove forest, Phuket, Thailand, at 80.3 m and 15.6 m to provide low-resolution inputs and high-resolution references, and 64 pairs were retained after registration. A very deep super-resolution (VDSR) network achieved a mean peak signal-to-noise ratio (PSNR) gain of 1.11 dB over bicubic interpolation on six held-out test pairs. In a five-fold spatially blocked cross-validation of all 64 pairs, VDSR outperformed bicubic interpolation on every pair, with a mean PSNR gain of 0.74 dB (95% CI [0.68, 0.80]). However, a brightness and contrast correction of the bicubic image, fitted on the training pairs, reached the same mean PSNR, so the gain of VDSR arose from radiometric correction rather than from recovered canopy detail. The protocol therefore provides real paired-altitude data on which super-resolution models can be trained and tested, and models that tolerate residual misalignment between the paired images should be evaluated in future work.

Environments

18 November 2026

The proposed protocol: (1) paired-altitude image acquisition, in which spatially co-located images of the same mangrove canopy are captured at high altitude, providing the LR input, and at low altitude, providing the high-resolution (HR) reference; (2) data preprocessing; (3) model development, with five-fold spatially blocked cross-validation (13 m buffer); and (4) model evaluation, comparing the model output with the HR reference, bicubic interpolation and a luminance-correction baseline.
  • Article
  • Open Access

TiO2/MnxOᵧ Nanostructured Mixed Oxides for Methanol Decomposition: Role of the Ti/Mn Ratio

  • Gloria Issa,
  • Momtchil Dimitrov and
  • Ivanka Stoycheva
  • + 5 authors

Titanium–manganese oxide materials have attracted considerable attention as multifunctional catalysts owing to their tunable redox properties and catalytic performance. In particular, these materials have shown promising potential for methanol decomposition, a reaction of interest for both environmental catalysis and processes related to synthesis gas production. The synthesized materials were characterized by low-temperature N2 physisorption, X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), and H2 temperature-programmed reduction (H2-TPR). Variation in the Ti/Mn ratio resulted in pronounced changes in the textural, structural, surface, and redox properties of the binary oxide materials, which were reflected in their catalytic activity and product selectivity during methanol decomposition. Among the mixed oxides, the 2Ti8Mn material exhibited the highest BET surface area-normalized specific activity, whereas the highest CO selectivity (87% at 700 K) was achieved over the 5Ti5Mn sample. The catalytic performance of 2Ti8Mn can be associated with the presence of manganese oxide phases with different crystallite sizes and oxidation states, together with their spatial association with TiO2-containing regions. The coexistence of different manganese oxidation states, reduced titanium species, and oxygen-deficient surface sites suggests that interactions between the two oxide components influence the surface redox properties and contribute to the observed catalytic behavior. Overall, the results demonstrate that the Ti/Mn ratio plays a key role in determining the catalytic activity and product selectivity of TiO2–MnxOᵧ mixed oxides.

Environments

17 November 2026

XRD patterns of titanium and manganese oxide materials. The symbols *, 0, and # indicate the diffraction peaks corresponding to TiO2, Mn2O3, and Mn5O8, respectively.
  • Article
  • Open Access

Delineating groundwater suitability zones across data-scarce sedimentary environments is critical for regional resource screening. This study presents an integrated geographic information system and analytic hierarchy process (GIS-AHP) modeling framework to map groundwater suitability corridors across a 2886.87 km2 catchment footprint in the Tolon and Kumbungu Districts of northern Ghana. An 8-layer operational multi-criteria directory was constructed, and matrix verification confirmed mathematical consistency with a principal eigenvalue of 8.1862, a Consistency Index of 0.0266, and a Consistency Ratio of 1.89%, resolving safely below the standard 10% inconsistency cutoff. Integrated spatial overlays delineated the catchment into three distinct suitability bands: Low Suitability comprising 34.00% (981.52 km2), mapped to tight mudstones of the undifferentiated Obosum Group; Moderate Suitability dominating 44.67% (1289.51 km2) across low-gradient Bimbila Formation shale plains; and High Suitability covering 21.33% (615.84 km2) constrained to highly fractured sandstone units. The spatial overlay model achieved a baseline geographic placement hit rate of 45.65%, locating 21 out of 46 field boreholes inside the upper prospective suitability bounds. A threshold-independent Receiver Operating Characteristic (ROC) analysis, utilizing a binary 600 mg/L total dissolved solids (TDS) solute threshold filter, achieved an Area Under the Curve (AUC) score of 0.6102. Hydrogeochemical cross-validation verified that the High-Suitability zone displays lower solute concentrations (Mean TDS = 326.56 mg/L) compared to the Moderate- (Mean TDS = 778.93 mg/L) and Low-suitability matrices (Mean TDS = 773.54 mg/L).

Environments

17 November 2026

Geographic location of the study area.
  • Article
  • Open Access

Ash and slag dumps (ASD) from thermal power plants are among the largest-scale sources of industrial impact on the environment. Their effective reclamation is constrained by a combination of unfavorable factors: extremely high alkalinity, absence of organic matter, and deficiency of mineral nutrients. This paper presents the results of a field plot experiment on the biological stabilization of the dusting surface of a decommissioned ASD of the Apatity Thermal Power Plant (Murmansk Region, Russia) using sewage sludge (SS) as an unconventional ameliorant. The experimental design included three treatments in five replicates: continuous application of SS in a layer of 2–2.5 cm, fragmentary application, and a control (without SS). A grass mixture of seven perennial species was sown on all plots; the seed composition was selected based on a preliminary vegetation survey of the adjacent territory. During the growing season, plant growth and development were monitored, CO2 emissions were measured, and Technosol samples were collected to determine their physicochemical properties (pH, moisture content), total and labile organic carbon and nitrogen contents, and total forms of potentially toxic metals (PTM). Continuous application of SS was found to provide the greatest effect: the height of cereals reached 33.6 cm (6.8 times higher than the control), aboveground biomass increased 5.3-fold, and the thickness of the root layer increased 1.6-fold. These differences were statistically significant (p < 0.05). The application of SS reduced pH from 9.43 to 8.90, increased organic carbon content tenfold and total nitrogen content sixfold, and substantially enriched the substrate with labile and hydrolyzable forms of carbon and nitrogen. CO2 emission from the experimental plots remained 5–6 times higher than the control throughout the season, confirming the overall activation of biological processes (microbial and root respiration) following the input of readily available organic matter. An increase in PTM content was recorded after the SS addition; however, PTM concentrations did not exceed values typical for technogenic substrates. Continuous application of SS is demonstrated to be the optimal method for biological stabilization dusting surfaces of ASD in the conditions of the Kola Subarctic.

Environments

15 November 2026

Schematic map of the location of the experimental site.

Featured Articles of Last Quarter

Levelised cost of hydrogen ranges for fossil-based routes and water electrolysis for the year 2023. Diamonds represent average values reported by the European Hydrogen Observatory [8].
Location of the wastewater treatment plants.
Methodological framework illustrating the different levels involved in the lifelong study of the environment–health–disease interplay.

Highly Accessed Articles

News & Conferences

Latest Issues

Open for Submission

Journal Sections

XFacebookLinkedIn
Environments - ISSN 2076-3298