68 Results Found

A simple, low cost, and “green” method of hydrothermal synthesis, based on the addition of l-ascorbic acid (l-AA) as a reducing agent, is presented in order to obtain reduced graphene oxide (rGO) and hybrid rGO-MoO2 aerogels for the fabri...

We present the polarization-dependent highly absorptive in Ka-band composition of conventional polyurethane foam filled with in situ synthesized aerogel coated by reduced graphene oxide (rGO). The rGO-based aerogel was in situ prepared into the open-...

High-porosity monolithic composite aerogels of syndiotactic polystyrene (sPS) and poly(2,6-dimethyl-1,4-phenylene oxide) (PPO) containing reduced graphene oxide (r-GO) were prepared and characterized. The composite aerogels obtained by supercritical...

UV-benzotriazoles have been identified as water micropollutants that cause serious problems for human health and the environment. Their low concentration in water bodies complicates their detection by direct water analysis, slowing the corrective act...

This paper reports on the preparation of cellulose/reduced graphene oxide (rGO) aerogels for use as chemical vapour sensors. Cellulose/rGO composite aerogels were prepared by dissolving cellulose and dispersing graphene oxide (GO) in aqueous NaOH/ure...

Surface modified reduced graphene oxide (rGO) aerogels were synthesized using the hydrothermal method. Ethylene diamine (EDA) and α-cyclodextrin (CD) were used to functionalize the surface of the graphene oxide layers. The oxygen reduction and...

A graphene oxide aerogel (GOA) was formed inside a melamine sponge (MS) framework. After reduction with hydrazine at 60 °C, the electrical conductive nitrogen-enriched rGOA-MS composite material with a specific density of 20.1 mg/cm3 was used to...

Flexible wearable pressure sensors have received extensive attention in recent years because of the promising application potentials in health management, humanoid robots, and human machine interfaces. Among the many sensory performances, the high se...

To expand the applications of graphene-based materials to biogas purification, a series of reduced graphene oxide aerogels (rGOAs) were prepared from industrial grade graphene oxide using a simple hydrothermal method. The influences of the hydrotherm...

In this study, β-cyclodextrin-modified reduced graphene oxide aerogels (β-CD-rGOAs) were synthesized via a one-step hydrothermal method and were used to remove hexamethyldisiloxane (L2) from biogas. The β-CD-rGOAs were characterized by the Brunner–Em...

A promising α-FeOOH-reduced graphene oxide aerogel (FeOOH-GA) has been prepared for the assembly of an enzyme electrode. The α-FeOOH-reduced graphene oxide aerogel was characterized by X-ray powder diffraction, field emission scanning ele...

Within this work, new aerogels based on graphene oxide are proposed to adsorb salicylic acid (SA) and herbicide 2,4-Dichlorophenoxyacetic acid (2,4-D) from aqueous media. Graphene oxide aerogel (GOA) and reduced graphene oxide aerogel (rGOA) were obt...

A novel three-dimensional carboxymethyl cellulose (CMC)/reduced graphene oxide (rGO) composite aerogel crosslinked by poly (methyl vinyl ether-co-maleic acid)/poly (ethylene glycol) system via a directional freezing technique exhibits high structure...

SnO2 aerogel/reduced graphene oxide (rGO) nanocomposites were synthesized using the sol–gel method. A homogeneous dispersion of graphene oxide (GO) flakes in a tin precursor solution was captured in a three-dimensional network SnO2 aerogel matr...

Aiming at the removal of refractory organic pollutants in aqueous solution, self-assembled nano-Fe3C embedded in reduced graphene oxide (nano-Fe3C@RGO) aerogel was prepared by hydrothermal synthesis and high temperature treatment, and characterized b...

Developing lightweight, highly active surfaces with a high level of performance and great stability is crucial for ensuring the dependability of energy harvesting and conversion devices. Aerogel-based electrocatalysts are an efficient option for elec...

Zn-air batteries (ZABs) with neutral electrolytes offer a significantly longer lifespan and better recyclability than alkaline ones. However, low-performance bifunctional catalytic activities for oxygen reduction or evolution reaction (i.e., ORR/OER)...

Graphene-based composite aerogel (GCA) refers to a solid porous substance formed by graphene or its derivatives, graphene oxide (GO) and reduced graphene oxide (rGO), with inorganic materials and polymers. Because GCA has super-high adsorption, separ...

Ensuring clean water sources is pivotal for sustainable development and the well-being of communities worldwide. This study represents a pioneering effort in water purification, exploring an innovative approach utilizing modified reduced graphene oxi...

A simple and effective method was developed to obtain the electrode for lithium/sulfur (Li/S) batteries with high specific capacity and cycling durability via adopting an interconnected sulfur/activated carbon/graphene (reduced graphene oxide) aeroge...

A peculiar 3D graphene-based architecture, i.e., partial reduced-Graphene Oxide Aerogel Microspheres (prGOAM), having a dandelion-like morphology with divergent microchannels to implement innovative electrocatalysts for the hydrogen evolution reactio...

Volatile methyl siloxanes (VMS), which are considered to be the most troublesome impurities in current biogas-cleaning technologies, need to be removed. In this study, we fabricated a series of Fe3O4–urea-modified reduced graphene-oxide aerogel...

Volatile methyl siloxanes (VMSs) as a trace impurity in biogas decreases its energy utilization, and thus need to be removed. In this paper, a one-step hydrothermal reduction was performed to produce three-dimensional reduced graphene oxide aerogels...

Ruthenium active species containing Ruthenium Sulphide (RuS2) is synthesized together with a self-assembled reduced graphene oxide (RGO) aerogel by a one-pot hydrothermal synthesis. Ruthenium Chloride and L-Cysteine are used as reactants. The hydroth...

Carbon nanotubes (CNTs), graphene aerogels (GAs), and their hybrid (CNT-GA) prepared by hydrothermal treatment were tested in the electrocatalytic oxygen reduction reaction (ORR). The importance of porous structure derived from the combination of mes...

Preparation of pure three-dimensional graphene (3DG) with high rate performance for supercapacitors is critical for fast rate charge/discharge. Here, 3DG was prepared via thermal annealing of freeze-dried reduced graphene oxide (RGO) hydrogel under i...

A special technique has been developed for producing a composite aerogel which consists of graphene oxide and soy wax (GO/wax). The reduction of graphene oxide was carried out by the stepwise heating of this aerogel to 250 °C. The aerogel obtaine...

Currently, efforts to address the energy needs of large-scale power applications have expedited the development of sodium–ion (Na–ion) batteries. Transition-metal oxides, including Mn2O3, are promising for low-cost, eco-friendly energy st...

Owing to their high theoretical capacity, transition-metal oxides have received a considerable amount of attention as potential anode materials in sodium-ion (Na-ion) batteries. Among them, Mn3O4 has gained interest due to the low cost of raw materia...

This short review provides a focused overview of recent advances in catalytic systems for water purification, with particular attention to photocatalysis, Fenton-like processes, and biocatalysis. While not intended as a comprehensive survey, this rev...

Hydrogen gas (H2) is being intensively proposed as a next-generation clean energy owing to the depletion of fossil fuels. Electrochemical water splitting is one of the most promising processes for hydrogen production. Furthermore, many efforts focusi...

Dispersing graphene nanosheets in polymer-derived ceramics (PDCs) has become a promising route to produce exceptional mechanical and functional properties. To reveal the complex nanodomain structures of graphene–PDC composites, a novel reduced...

The performance of synergetic hybrid aerogel materials of vanadia and graphene as electrode materials in supercapacitors was evaluated. The hybrid materials were synthesized by two methods. In Method I, premade graphene oxide (GO) hydrogel was first...

Graphene based aerogel has become one of the most likely functional adsorption materials that is applicable to purify various contaminated water sources, such as dye wastewater, because of its high porosity, structural stability, large specific surfa...

Graphene aerogels have many advantages, such as low density, high elasticity and strong adsorption. They are considered to be widely applicable in many fields. At present, the most valuable research area aims to find a convenient and effective way to...

Natural biomaterials with hierarchical structures that enable extraordinary capability of detecting chemicals have inspired the interest in producing materials that can mimic these natural structures. This study reports the fabrication of hierarchica...

The vast demand for petroleum industry products led to the increased production of oily wastewaters and has led to many possible separation technologies. In addition to production-related oily wastewater, direct oil spills are associated with detrime...

Graphene aerogel (GA) is a lightweight, porous, environmentally friendly, 3D structured material with interesting properties, such as electrical conductivity, a high surface area, and chemical stability, which make it a powerful tool in energy storag...

Phase change materials (PCMs) can be thermally enhanced by reduced graphene oxide (rGO)/expanded graphite (EG) aerogel with anisotropic microstructure. An rGO/EG aerogel with anisotropic microstructure was prepared by directionally freezing aqueous s...

Lignin graphene oxide was oxidized after Kraft lignin was graphitized by thermal catalytic conversion. The reduced lignin graphene oxide was derived from lignin graphene oxide through thermal reduction treatment. These Kraft lignin, lignin graphite,...

This article presents novel poly(amidoamine) (PAMAM) dendrimer-modified with partially-reduced graphene oxide (rGO) aerogels, obtained using the combined solvothermal synthesis-freeze-casting approach. The properties of modified aerogels are investig...

For expanding applications of spongy graphene aerogels (GAs) cost-effectively, we report a marriage of the two-step hydrothermal reduction and atmospheric drying method to fabricate a spongy CNC-graphene aerogel (CNG) with oil/water selectivity and t...

Constructing three-dimensional (3D) current collectors is an effective strategy to solve the hindrance of the development of lithium metal anodes (LMAs). However, the excessive mass of the metallic scaffold structure leads to a decrease in energy den...

New techniques were developed for the synthesis of monolithic highly porous composite aerogels (hydrogels) from reduced graphene oxide and carbon nanotubes, as well as graphene-containing composites based on mesoporous activated carbon. Simple operat...

In this study, anisotropic graphene/graphene oxide (GO) aerogels (AGAs) were obtained by freeze-drying after direct participation of pristine graphene in the self-assembly of anisotropic gel by the heat flow method. After vacuum microwave treatment,...

With the intensification of human activities, a large amount of oil and organic solvent waste has been created, resulting in serious ecological and environmental pollution. Therefore, how to balance environmental benefits and economic benefits contro...

Graphene and graphene oxide (GO) structures and their reduced forms, e.g., GO paper and partially or fully reduced three-dimensional (3D) aerogels, are at the forefront of materials design for extensive biomedical applications that allow for the prol...

In this work, samples of reduced graphene oxide (rGO) were prepared by treating graphite oxide (GrO) with thiourea (TU) and ascorbic acid (AA). Aerogels rGO-TU and rGO-AA were prepared using the freeze-drying method and were analyzed using X-ray diff...

Ultra-light eco-friendly graphene oxide (GO)-based aerogels are reported by simple one-step solvothermal self-assembly. The effect of varying parameters such as C/O ratio of GO; reducing agent amount; temperature; and duration on the properties of th...

The incorporation of graphene oxide (GO) into a polymeric drug carrier can not only enhance the loading efficiency but also reduce the initial burst and consequently improve the controllability of drug release. Firstly, 5-fluorouracil (5-Fu)-loaded h...