This work used a rotating disc electrode and quasi-steady state polarization curves to investigate the sodium borohydride electrooxidation of ordered intermetallic PtSn/C in alkaline solution. Under similar experimental conditions, PtSn/C proved to b...
PtSn/C-type catalysts modified with Ta and Ru were prepared by the thermal decomposition of polymeric precursors with the following nominal compositions: Pt70Sn10Ta20/C, Pt70Sn10Ta15Ru5/C, Pt70Sn10Ta10Ru10/C and Pt70Sn10Ta5Ru15/C. The physicochemical...
In the present work, we studied the catalytic performance (activity and selectivity) of Pt supported on carbon systems and Pt modified with tin in the glycerol oxidation with H2O2 as the oxidising agent at atmospheric pressure, 60 °C, and base-fr...
PtSn-based catalysts are one of the most active materials toward that contribute ethanol oxidation reaction (EOR). In order to gain a better understanding of the Sn influence on the carbon monoxide (principal catalyst poison) and ethanol oxidation re...
Sn-doped TiO2–carbon composites were identified as promising multifunctional supports for Pt electrocatalysts, in which the oxide component enhances resistance against corrosion and strong metal–support interactions at the Pt-oxide bounda...
Nanosized bimetallic PtMo, PtFe and trimetallic PtMoSn catalysts deposited on highly dispersed carbon black Vulcan XC-72 were synthesized from the cluster complex compounds PtCl(P(C6H5)3)(C3H2N2(CH3)2)Mo(C5H4CH3)(CO)3, Pt(P(C6H5)3)(C3N2H2(CH3)2)Fe(CO...
The composites of transition metal-doped titania and carbon have emerged as promising supports for Pt electrocatalysts in PEM fuel cells. In these multifunctional supports, the oxide component stabilizes the Pt particles, while the dopant provides a...
Pt/C and Pt/SnOx/C catalysts were synthesized using the polyol method. Their structure, morphology and chemical composition were studied using a scanning electron microscope equipped with an energy dispersive X-ray spectrometer, transition electron m...
This study explores the development of core–shell electrocatalysts for efficient glycerol oxidation in alkaline media. Carbon-supported M@Pt/C (M = Co, Ni, Sn) catalysts with a 1:1 atomic ratio of metal (M) to platinum (Pt) were synthesized usi...
Ethylene glycol oxidation (EGOR) transforms waste plastic-derived chemicals into high-value products, representing an upcycling strategy that enhances resource efficiency. Pt-based electrocatalysts have shown promise for oxidizing ethylene glycol (EG...
Pt/C, PtMOn/C (M = Ni, Sn, Ti, and PtX/C (X = Rh, Ir) catalyst systems were prepared by using the pulse alternating current (PAC) technique. Physical and electrochemical parameters of samples were carried out by x-ray powder diffraction (XRD), transm...
Real-time monitoring of volatile organic compounds (VOCs) is crucial for both industrial production and daily life. However, the non-reactive nature of VOCs and their low concentrations pose a significant challenge for developing sensors. In this stu...
A detailed study of the structure, morphology and electrochemical properties of Pt/C and Pt/x-SnO2/C catalysts synthesized using a polyol method has been provided. A series of catalysts supported on the SnO2-modified carbon was synthesized and studie...
Electrooxidation of methanol, ethanol, and formic acid was studied on three platinum-containing electrocatalysts: PtCu/C, Pt/(SnO2/C), and Pt/C, Pt content being about 20 wt%. In all reactions, the integral specific activity of the catalysts, estimat...
An anion exchange-assisted technique was used for the synthesis of platinum-decorated SnO2 supports, providing nanocatalysts with enhanced activity for the reduction of 4-nitrophenol (4-NP) to 4-aminophenol (4-AP). In this study, a series of SnO2 sup...
Proton-exchange-membrane hydrogen fuel cells (PEMFCs) are an important energy device for achieving a sustainable hydrogen society. Carbon-based catalysts used in PEMFCs’ cathode can degrade significantly during operation-voltage shifts due to the car...
Pt-SnO2@C-ordered flake array was developed on carbon paper (CP) as an integrated cathode for proton exchange membrane fuel cell through a facile hydrothermal method. In the integrated cathode, Pt nanoparticles were deposited uniformly with a small p...
In this work, we studied the influence of cross-interference effects between VOCs and NO on the performance of SnO2 and Pt-SnO2-based gas sensors. Sensing films were fabricated by screen printing. The results show that the response of the SnO2 sensor...
Tin(IV) oxide (SnO2) was deposited onto acid-washed multiwalled carbon nanotubes (MWCNTs) to be used as a support for platinum nanoparticles (PtNPs). The effect of the SnO2–CNT support on the electrocatalytic activity of the PtNPs for the oxyge...
In this study, Pt1Sn1 intermetallic nanoparticles (NPs) on SiO2/CeO2@SiO2 composites were located either on SiO2 or on CeO2@SiO2, thereby varying the average distance (intimacy) between metal sites and CeOx sites from “closest” to “...
In this study, we present a new approach for the synthesis of Pt/SnO2 catalysts using microwave radiation. Pt(IV) and Sn(IV) inorganic precursors (H2PtCl6 and SnCl4) and ammonia were used, which allowed the controlled formation of platinum particles...
Acetone is a biomarker found in the expired air of patients suffering from diabetes. Therefore, early and accurate detection of its concentration in the breath of such patients is extremely important. We prepared Tin(IV) oxide (SnO2) nanospheres via...
The dehydrogenation of n-butane to butenes is a crucial process for producing valuable petrochemical intermediates. This study explores the role of oxyphilic metal promoters (Sn, Zn, and Ga) in enhancing the performance and stability of Pt@MFI cataly...
Planar tetracoordinate silicon, germanium, tin, and lead (ptSi/Ge/Sn/Pb) species are scarce and exotic. Here, we report a series of penta-atomic ptSi/Ge/Sn/Pb XB2Bi2 (X = Si, Ge, Sn, Pb) clusters with 20 valence electrons (VEs). Ternary XB2Bi2 (X = S...
Increased demand for ethylene has motivated direct ethane dehydrogenation over Pt-based catalysts. PtSn/γ-Al2O3 and PtSnZnCa/γ-Al2O3 catalysts were investigated with the aim of understanding the effect of the pretreatment environment on t...
Pt/C and Pt/x-SnO2/C catalysts (where x is mass content of SnO2) were synthesized using a polyol method. Their kinetic properties towards oxygen reduction reaction were studied by a rotating disk electrode (RDE) technique in a temperature range from...
This work highlights the potential for the synthesis of new PtSnZn catalysts with enhanced efficiency and durability for methanol oxidation reaction (MOR) in low-temperature fuel cells. In this research, PtZn and PtSnZn nanoparticles deposited on hig...
As one of the important probes of chemical bonding, planar tetracoordinate carbon (ptC) compounds have been receiving much attention. Compared with ptC clusters, the heavier planar tetracoordinate silicon, germanium, tin, lead (ptSi/Ge/Sn/Pb) systems...
An effective approach for increasing the Noble metal-utilization by decorating the atomic Pt clusters (1 wt.%) on the CoO2@SnPd2 nanoparticle (denoted as CSPP) for oxygen reduction reaction (ORR) is demonstrated in this study. For the optimum case wh...
Pt–Sn/Al2O3 catalysts were prepared by the direct reduction method at temperatures from 450 to 900 °C, denoted as an SR series (SR450 to SR900 according to reduction temperature). Direct reduction was performed immediately after catalyst dr...
Fuel cells are expected to bring change to the whole human race when commercialized, however, the sluggish kinetics of oxygen reduction reaction (ORR) severely hampers their commercial viability. Thus far, platinum (Pt) based catalysts are nearly ine...
The ball-milling (BM) method benefits the stabilization and dispersion of metallic particles for the preparation of the PtSnK–Mo/ZSM-5 catalyst. Based on the TPR, H2-TPD, XPS, and CO-FTIR results, the Pt–SnOx and MoOx species were formed...
In this work we analyze the effectiveness of decoration of nanocrystalline SnO2/TiO2 composites with gold nanoparticles (Au NPs) and platinum nanoparticles (Pt NPs) in enhancing gas sensor properties in low-temperature HCHO detection. Nanocrystalline...
Pt-nanoparticle (NP)-alloyed Sn-58Bi solders were reacted with electroless nickel-immersion gold (ENIG) and electroless nickel-electroless palladium-immersion gold (ENEPIG) surface finishes. We investigated formation of intermetallic compounds (IMCs)...
A complex study of the structure, morphology, and electrochemical properties of the Pt20/SnO210/RGO electrocatalyst is presented. The advantage of the chemical synthesis of reduced graphene oxide (c-RGO) compared to thermal methods (t-RGO) is due to...
In this study, a PtSn/Al2O3 catalyst with bimetallic uniform distribution in the sphere was synthesized. The PDH performance and characterization analyses, such as with FTIR, XPS, and NH3-TPD, were investigated. The effects of acid on the PDH perform...
We prepared monodisperse Pt2Ru3 nanoparticles supported on carbon black and Sb-doped SnO2 (denoted as Pt2Ru3/CB and Pt2Ru3/Sb-SnO2) with identical alloy composition and particle size distribution by the nanocapsule method. The activities for the hydr...
The type of metal oxide affects the activity and selectivity of Fe2O3–SiO2–MeO2–Pt (Me = Ti, Sn, Ce) catalysts on the hydrogenation of cinnamaldehyde. The double shell structure design is thought to protect the magnetic Fe2O3 cores,...
In this article, Pt-SnxOy hybrid nanoparticles encaged in porous silica nanospheres (Pt-SnxOy@PSNs) were prepared by using 1-dodecanethiol (C12-SH) as a coordination agent to confine Pt and Sn ions in a microemulsion system, which is formed by cetylt...
The oxidative dehydrogenation of propane with CO2 (CO2-ODP) has been extensively investigated as a promising green technology for the efficient production of propylene, but the lack of a high-performance catalyst is still one of the main challenges f...
The CO sensing properties of a micro thermoelectric gas sensor (micro-TGS) with a double AuPtPd/SnO2 and Pt/α-Al2O3 catalyst were investigated. While several nanometer sized Pt and Pd particles were uniformly dispersed on SnO2, the Au particles were...
We describe a potentially new species of a platinum cupride–stannide mineral (PCSM) of composition Pt(Cu0.67Sn0.33). It occurs in a placer deposit in the River Bolshoy Khailyk, southern Krasnoyarskiy kray, Russia. A synthetic equivalent of PCSM was o...
Microsomal fractions from yeast Δale1 cells harbouring the empty plasmid pYES2/CT and from yeast cells overexpressing PtATS2a (Phatr3_J11916) or PtATS2b (Phatr3_J43099) were used in the studies. When sn-1-18:1-LPA and [14C]16:0-CoA were used as...
Many low-dimensional nanostructured metal oxides (MOXs) with impressive room-temperature gas-sensing characteristics have been synthesized, yet transforming them into relatively robust bulk materials has been quite neglected. Pt-decorated SnO2 nanopa...
SnO2-based semiconductor gas-sensing materials are regarded as some of the most crucial sensing materials, owing to their extremely high electron mobility, high sensitivity, and excellent stability. To bridge the gap between laboratory-scale SnO2 and...
Soluble noble metal salts are widely used for loading noble metals as nano-catalysts in many applications. In this paper, Pt-SnO2 composite nanoceramics were prepared from SnO2 nanoparticles and H2PtCl6 using two Pt loading methods separately: for th...
The electrochemical production of silicon from SiO2 in molten salts can reduce energy consumption and mitigate carbon emissions associated with the conventional carbothermic process. In this study, we compare the anodic behaviour of platinum, graphit...
To obtain a nanocrystalline SnO2 matrix and mono- and bimetallic nanocomposites SnO2/Pd, SnO2/Pt, and SnO2/PtPd, a flame spray pyrolysis with subsequent impregnation was used. The materials were characterized using X-ray diffraction (XRD), a single-p...
We have developed IrOx/M-SnO2 (M = Nb, Ta, and Sb) anode catalysts, IrOx nanoparticles uniformly dispersed on M-SnO2 supports with fused-aggregate structures, which make it possible to evolve oxygen efficiently, even with a reduced amount of noble me...
In the propane dehydrogenation process, the structure and catalytic performance stability of the catalyst are determined by its regeneration process, which includes oxidation of coke and oxychlorination to redisperse the supported metal particles. A...
of 2