The use of high surface monolithic carbon as support for catalysts offers important advantage, such as elimination of the ohmic drop originated in the interparticle contact and improved mass transport by ad-hoc pore design. Moreover, the approach dis...
In this work, PtPd hybrid cathodic catalysts were prepared for a proton exchange membrane fuel cell (PEMFC) application by two different strategies. The first strategy was the physical mixing of bimetallic PtPd onto partially reduced graphene oxide (...
CeO2-ZrO2-La2O3 supported Pt-Pd bimetallic three-way catalysts (0.6Pt-0.4Pd/CZL) were synthesized through the conventional impregnation method and then subjected to severe thermal aging. Reactivating treatments under different temperatures were then...
Mono and bimetallic catalysts based on Pt and Pd were prepared by a co-precipitation method. They were tested in liquid phase hydrogenation reactions of glucose and furfural at low temperature and pressure. The bimetallic PtPd/TiO2 catalyst proved to...
Pt is widely used as the catalyst for methanol oxidation reaction (MOR) in direct methanol fuel cells (DMFC). However, the high cost and limited supply of pure Pt limit the commercialization of DMFC. Herein, MOR catalyzed by variously designed Pd-dop...
The oxygen reduction reaction (ORR) is one of the key catalytic reactions for hydrogen fuel cells, biofuel cells and metal–air cells. However, due to the complex four-electron catalytic process, the kinetics of the oxygen reduction reaction are...
Pt,Pd,Ni/MgO, Pt,Pd,Ni/Mg0.97La3+0.03O, Pt,Pd,Ni/Mg0.93La3+0.07O, and Pt,Pd,Ni/Mg0.85La3+0.15O (1% of each of the Ni, Pd, and Pt) catalysts were prepared by a surfactant-assisted co-precipitation method. Samples were characterized by the XRD, XPS, XR...
Previously tested 2 wt % palladium-platinum catalysts supported on Norit activated carbon preheated to 1600 °C have been reinvestigated in CHFCl2 hydrodechlorination. An additionally adopted catalyst oxidation at 350–400 °C produced nearly an order o...
The importance and challenges of ethylene detection based on combustion-type low-cost commercial sensors for agricultural and industrial applications are well-established. This work summarizes the significant progress in ethylene detection based on a...
This work emphasizes the development of a green synthetic approach for growing ultrathin film PtxPd(1-x) alloy catalysts for formic acid oxidation (FAO) by surface limited redox replacement of underpotentially deposited H sacrificial layer. Up to thr...
Pt-Pd-based noble metal catalysts are widely used in engine exhaust aftertreatment because of their better carbon soot oxidation performance. At present, the synergistic effect of Pt and Pd in CDPFs, which is the most widely used and common doping me...
Declining natural resources make the recovery of metals from waste solutions a promising alternative. Moreover, processing waste into a finished product has its economic justification and benefits. Thus, the aim of this research was developing a Wast...
By combining scanning transmission electron microscopy, CO chemisorption, and energy dispersive X-ray spectroscopy with CO and NO oxidation light-off measurements we investigated deactivation phenomena of Pt/Al2O3, Pd/Al2O3, and Pt-Pd/Al2O3 model die...
In this study, mono- and bimetallic platinum (Pt), palladium (Pd) and Pt-Pd nanoparticles were synthesized using the wet sol–gel method, employing a carbon-based XC72R as catalytic carrier. The overall metal content was set at 40 wt.% at varyin...
Electric heating is frequently employed to treat volatile organic compounds (VOCs) through catalytic combustion. However, it is associated with problems such as slow heating, high energy consumption, and low efficiency. This study explores PdPt/Al2O3...
A promising route for the energetic valorisation of the main by-product of the biodiesel industry is the steam reforming of glycerol, as it can theoretically produce seven moles of H2 for every mole of C3H8O3. In the work presented herein, CeO2&ndash...
This paper presents the results of studying the characteristics of hydrogen sensors based on thin In2O3 films modified with tin and dysprosium with dispersed double Pt/Pd catalysts deposited on the surface. To control the content of Sn and Dy in the...
Bimetallic platinum-containing catalysts are deemed promising for electrolyzers and proton-exchange membrane fuel cells (PEMFCs). A significant number of laboratory studies and commercial offers are related to PtNi/C and PtCo/C electrocatalysts. The...
We report here, a strategy to prepare Pt/Pd nanoparticles decorated with Co-N-C materials, where Co-N-C was obtained via pyrolysis of ZIF-67 directly. As-prepared Pt/Pd/Co-N-C catalysts showed excellent ORR performance, offered with a higher limit cu...
Herein, α-MnO2-supported Pt-Pd bimetal (xPd-yPt/α-MnO2; x and y are the weight loadings (wt%) of Pd and Pt, respectively; x = 0, 0.23, 0.47, 0.93, and 0.92 wt%; and y = 0.91, 0.21, 0.46, 0.89, and 0 wt%) catalysts were prepared using the...
This investigation addresses the enhancement of ammonia fuel cell performance using Pd (palladium)- and Co (cobalt)-doped cathode catalysts. Initially, the performance of the Ag/C cathode catalyst in ammonia fuel cells yielded a baseline power densit...
The net oxidising atmosphere of lean burn engines requires a special after-treatment catalyst for NOx removal from the exhaust gas. Lean NOx traps (LNT) are such kind of catalysts. To increase the efficiency of LNTs at low temperatures platinised per...
This article presents the prospect of using the process of deep hydrodesulfurization and hydrodearomatization of secondary gas oils using highly active NiMo catalysts to obtain hydrocarbon bases for drilling fluids. Catalysts were synthesized using P...
Fatty acid methyl ester (FAME) biodiesel contains some trace amounts of Na, K, P, Ca, and Mg. Our objective was to investigate whether the presence of such elements can poison a diesel oxidation catalyst that has been used for an entire regulatory li...
In this paper, a PtPd NC catalyst with a network structure of nanochains was prepared with KBr as a structure-directing agent, NaBH4 as a reducing agent, and modified multi-walled carbon nanotubes (MWCNTs) as a support. The experimental results show...
The CO sensing properties of a micro thermoelectric gas sensor (micro-TGS) with a double AuPtPd/SnO2 and Pt/α-Al2O3 catalyst were investigated. While several nanometer sized Pt and Pd particles were uniformly dispersed on SnO2, the Au particles were...
A series of methane oxidation catalysts were prepared by doping Santa Barbara Amorphous-15 (SBA-15), a highly mesoporous silica sieve, with varying amounts of Zr (5, 10, and 15 wt%) and loading with 2 wt% Pd and 4 wt% Pt. The catalysts were character...
In this study, 3%Pd/Al2O3, 3%Pt/Al2O3 and bimetallic (1%Pd + 2%Pt)/Al2O3 catalysts were examined in the total oxidation of methane in a temperature range of 150–400 °C. The evolution of the active component under the reaction conditions was...
In the present work, the magnetron sputtering technique was used to prepare new catalysts of formic acid electrooxidation based on TiO2 nanotubes decorated with Pt (platinum), Pd (palladium) or Pd + Pt nanoparticles. TiO2 nanotubes (TiO2 NTs) with st...
Commercial activated carbon, pretreated in helium at 1600 °C and largely free of micropores, was used as a support for two series of 2 wt.% Pd–Pt catalysts, prepared by impregnating the support with metal acetylacetonates or metal chlorides...
A PtPd/Al2O3 catalyst developed for the complete oxidation of methane from the ventilation air of underground coal mines is compared against a model PdO/Al2O3 catalyst. Although the PtPd/Al2O3 catalyst is substantially more active and stable than the...
Hierarchical AlSBA-15–zeolite materials were utilized as a supports for preparing hydroisomerization catalysts. Detailed consideration was given to: (i) the effect of the zeolite type introduced into AlSBA-15–zeolite composites (where zeolite is β, m...
Alloys are beneficial in numerous applications since they combine the desirable properties of different metals. In this regard, Pt/Pd alloys have been investigated as a replacement for Pt, which is the standard catalyst used in various catalytic proc...
A series of bimetallic Pd/Pt truncated nanocube catalysts with similar morphologies and particle sizes but different platinum contents were successfully synthesized using a colloidal method without using any capping agents. Their hydrogenation proper...
Cellulose grains were carbonized and applied as catalyst supports for nickel- and magnetite-promoted bimetallic palladium- and platinum-containing catalysts. The bimetallic spherical aggregates of Pd and Pt particles were created to enhance the syner...
Platinum (Pt) and palladium (Pd) are crucial in hydrogen energy technologies, especially in fuel cells, due to their high catalytic activity and chemical stability. Pt-Pd nanoparticles, produced through various methods, enhance catalytic performance...
Furfural (FF) has a high potential to become a major renewable platform molecule to produce biofuels and bio-based chemicals. The catalytic performances of AuxPty and AuxPdy bimetallic nanoparticulate systems supported on TiO2 were studied in a base-...
Developing highly active and durable Pt-based electrocatalysts is crucial for polymer electrolyte membrane fuel cells. This study focuses on the performance of oxygen reduction reaction (ORR) electrocatalysts composed of Pt-Pd alloy nanoparticles on...
Pt-Pd catalyst supported on nitrogen-doped carbon nanofiber (N-CNF) was prepared and evaluated as a cathode electrode of the direct methanol fuel cell (DMFC). The N-CNF, which was directly synthesized by the catalytic chemical vapor deposition from a...
Palladium (Pd) and platinum (Pt) are extensively used as catalysts in the petrochemical and automotive industries, and due to high demand for them on the market, their recycling from spent supported catalysts is clearly needed. To assess the content...
PtPd nanoparticles are among the most widely studied nanoscale systems, mainly because of their applications as catalysts in chemical reactions. In this work, a combined experimental-theoretical study is presented about the dependence of growth shape...
Pt-based bimetallic nanostructures have attracted a great deal of attention due to their unique nanostructures and excellent catalytic properties. In this study, we prepared porous Pt–Pd nanoparticles using an efficient, one-pot co-reduction process...
The ethanol oxidation reaction (EOR) has drawn increasing interest in electrocatalysis and fuel cells by considering that ethanol as a biomass fuel has advantages of low toxicity, renewability, and a high theoretical energy density compared to methan...
Catalysts Ni/Mg1−xCex4+O and Ni,Pd,Pt/Mg1−xCex4+O were developed using the co-precipitation–impregnation methods. Catalyst characterization took place using XRD, H2-TPR, XRF, XPS, Brunauer–Emmett–Teller (BET), TGA TEM, a...
Pt, Pd, and Rh platinum group metals (PGMs) are utilized in automotive catalytic converters to reduce the level of harmful gas emissions. To evaluate the separation efficiencies of PGMs from the leach liquors of automotive catalysts, their extractabi...
The study of methanol steam reforming (MSR) over a Pt-Rh/TiO2-In2O3 catalyst was carried out in traditional and membrane reactors using Pd-Cu foil treated by various methods. This catalyst showed the highest catalytic activity in a conventional react...
The direct alcohol fuel cell is a kind of power generation device that directly converts the chemical energy of small molecule alcohols into electric energy. In this paper, the electro-oxidation behaviors of some typical alcohols (methanol, ethanol,...
A series of Pt-based catalysts were synthesised and investigated for ambient temperature CO oxidation with the aim to increase catalytic activity and improve moisture resistance through support modification. Initially, bimetallic PtPd catalysts suppo...
Fuel cells are expected to bring change to the whole human race when commercialized, however, the sluggish kinetics of oxygen reduction reaction (ORR) severely hampers their commercial viability. Thus far, platinum (Pt) based catalysts are nearly ine...
In the present work, a series of different materials was investigated in order to enhance the understanding of the role of modern lean NOx trap (LNT) components on the sulfur poisoning and regeneration characteristics. Nine different types of model c...
of 6