Activated carbon fiber was prepared from liquefied wood by chemical activation with ZnCl2 (Z-LWACF) at different impregnation ratios, with a particular focus on its adsorption property, kinetic and isotherm. The characterization and properties of Z-L...
Ferric chloride (FeCl3) modified reed straw-based biochar was synthesized to remove nitrate from aqueous solutions and achieve waste recycling. The adsorption of nitrate onto Fe-RBC-600 adsorbents could be described by the pseudo-second-order kinetic...
Carbon dioxide (CO2) has been used to replace coal seam gas for recovery enhancement and carbon sequestration. To better understand the alternations of coal seam in response to CO2 sequestration, the properties of four different coals before and afte...
Silica nanoparticles were directly coated with cobalt hydroxide by homogeneous precipitation of slowly decomposing urea in cobalt nitrate solution. The cobalt hydroxide was amorphous, and its morphology was nanoflower-like. The BET (Brunauer-Emmett-T...
The precise estimation of influential parameters in adsorption is a key point in conducting simulations for the sensitivity analysis and optimal design of cooling systems. This study explores the critical role of a new type of granular activated carb...
Adsorption of hydrocarbons may significantly affect hydrocarbon migration in unconventional reservoirs. Clay minerals form the primary adsorbent surfaces for hydrocarbons adsorbed in mudstone/shale. To study the adsorption properties of hydrocarbons...
In view of the good adsorption properties of graphene and carbon foam, they were combined to achieve the optimal matching of microstructures. Taking mesophase pitch as a raw material, pitch-based carbon foam was prepared by the self-foaming method. G...
22 December 2017
To elucidate the adsorption property and the mechanism of plant residues to reduce oxytetracycline (OTC), the adsorption of OTC onto raw willow roots (WR-R), stems (WS-R), leaves (WL-R), and adsorption onto desugared willow roots (WR-D), stems (WS-D)...
When rockbursts and coal and gas outbursts simultaneously occur in a coal mine, changes in gas adsorption (concentration of ambient methane) and displacement of coal and rock must occur. The co-associated minerals in coal reservoirs can affect the me...
19 December 2021
Paddy soils are globally distributed and saturated with water long term, which is different from most terrestrial ecosystems. To better understand the environmental risks of antibiotics in paddy soils, this study chose sulfadiazine (SDZ) as a typical...
Alum sludge is an inevitable by-product from the water purification process, which had been applied as substrates in some constructed wetlands with good performance, especially for phosphorus (P) adsorption. The raw alum sludge is similar to a clay l...
Hyper-crosslinked (HCL) polystyrenes show outstanding properties, such as high specific surface area and adsorption capability. Several researches have been recently focused on tailoring their performance for specific applications, such as gas adsorp...
Sorption is the most important process influencing the amount of herbicide retained in soils. The special properties of biochar could influence the soil retention of pollutants through adsorption. However, the detailed sorption mechanisms as influenc...
During the development of the disposal concept in a crystalline massif of the Russian Federation, a question arose regarding the selection of the most suitable types of bentonite for a buffer layer. Data on the composition, structure, surface, and ad...
Interaction between the water adsorption ability of aluminium-oxide-based sorbents and their chemical composition, acid-base properties of the surface, and textural characteristics has been analysed. Alumina desiccants were synthesized with the centr...
This study aimed to design a new composite with promising antimicrobial and antioxidant properties by a simple modification process of natural bentonite (B) with polysaccharide chitosan isolated from edible mushrooms Agaricus bisporus—ChM (samp...
Carbon reactivation is a strategy to reduce waste and cost in many industrial processes, for example, effluent treatment, food industry, and hydrometallurgy. In this work, the effect of physical and chemical reactivation of granular activated carbon...
The chemical content, mechanical capability, and dimensional stability of bamboo fibers (BFs) are all directly related to the hygroscopic behavior, which is crucial for industrial applications. To support the utilization of BFs, the structural and ch...
A major goal of biomimetics is the development of chemical compositions and structures that simulate the extracellular matrix. In this study, gelatin-based electrospun composite fibrous membranes were prepared by electrospinning to generate bone scaf...
The design of advanced functional materials from polymers involving 2-octyl acrylate and isobornyl acrylate monomers is crucial for applications such as biofouling resistance, coatings, UV-curable films, and use in marine environments. In this study,...
We investigated H2O molecule adsorption that had an effect on the luminescence properties of the CsI(Na) crystal using experiments and first-principle calculations. We measured the emission spectra of the CsI(Na) crystal at different exposure times u...
The physical properties of porous silica nanofibers are an important factor that impacts their performance in various applications. In this study, porous silica nanofibers were produced via solution blow spinning (SBS) from a silica precursor/polymer...
In light of the escalating environmental concerns regarding pesticide accumulation, it is imperative to devise efficient strategies for their removal. Among the various options, activated carbons have emerged as promising candidates for adsorptive pe...
In the last two decades, significant efforts have been particularly invested in two-dimensional (2D) hexagonal boron carbon nitride h-BxCyNz because of its unique physical and chemical characteristics. The presence of the carbon atoms lowers the larg...
Structural and electronic properties of Si termination, O-middle termination, and O-rich terminations of a quartz (001) surface as well as water molecule adsorption on it were simulated by means of density functional theory (DFT). Calculated results...
Poly(2,5-dimercapto-1,3,4-thiadiazole) (PBT) nanosheets were synthesized by chemical oxidative synthesis under mild conditions. The media, oxidant species, monomer concentrations, oxidant/monomer molar ratio, and temperature were optimized to achieve...
Over the past several decades, the value of drinking water treatment residuals (WTRs), a byproduct of the coagulation process during water purification, has been recognized in various environmental applications, including sustainable remediation of p...
Experimental and theoretical studies were applied to investigate the adsorption properties of testagen (KEDG) peptide on copper surfaces in sodium chloride solution and, implicitly, its inhibition efficiency (IE) on metal corrosion. The tetrapeptide...
The adsorption of petroleum hydrocarbons by soils in the unsaturated zone determines the amount that goes into the groundwater. However, the intricate behavior of petroleum hydrocarbon adsorption in soil media under the influence of freeze–thaw...
Under the concept of green and low-carbon development, efficient and environmentally friendly biochar preparation methods have attracted much attention. This study assessed a novel sodium carbonate activator combined with acid modification for sludge...
This study aims to develop and characterize innovative geopolymer composites by incorporating activated carbon into a geopolymer matrix to create a novel, effective sorption material suitable for non-dusty or medium-temperature environmental applicat...
Given the current importance of using biochar for water treatment, it is important to study the physical–chemical properties to predict the behavior of the biochar adsorbent in contact with adsorbates. In the present research, the physical and...
The petrophysical properties of coal will vary during coalification, and thus affect the methane adsorption capacity. In order to clarify the variation rule and its controlling effect on methane adsorption, various petrophysical tests including proxi...
Two-dimensional (2D) hexagonal boron carbon nitride (h-BxCyNz) has garnered a lot of interest in the last two decades because of its remarkable physical and chemical characteristics. Because of the carbon atoms, it has a smaller gap than its cousin,...
Radioactive iodine-capturing materials are urgently needed for the emerging challenges in nuclear waste disposal. The various pore structures of covalent organic frameworks (COFs) render them promising candidates for efficient iodine adsorption. Howe...
This study aims to produce mortar through the addition of oil palm shells (OPS)-activated charcoal and oil palm empty fruit bunch (OPEFB) hydrochar, which has high mechanical properties, self-healing crack capabilities, and pollutant adsorption abili...
This study focuses on the preparation of activated carbon using a petroleum-residue-based pitch, as well as the HCl gas adsorption properties of the resulting activated carbon pellets relative to their specific surface area and pore structure. Activa...
Medium-chain triglycerides (MCTs) have been known to have multiple health benefits in treating metabolic disorders and reducing the incidence of obesity. In the present study, the partial replacement of lard with MCTs assisted by ultrasound treatment...
Despite extensive studies of deposited carbon in Fischer–Tropsch synthesis (FTS), an atomic-level comprehension of the effect of carbon on the morphology of cobalt-based FTS catalysts remains elusive. The adsorption configurations of carbon ato...
Dialdehyde crosslinked poly aspartate/alginate hydrogel beads were synthesized by covalently introducing poly aspartate into the alginate network via dialdehyde-mediated crosslinking, and the resulting effects on swelling and adsorption behavior were...
To realize the selective separation of L-tyrosine (L-Tyr) and avoid the drawbacks of traditional thermal polymerization, electron beam irradiation polymerization was developed for the fabrication of L-Tyr molecularly imprinted polymers (MIPs). Firstl...
The remediation of mercury (Hg) contaminated soil and water requires the continuous development of efficient pollutant removal technologies. To solve this problem, a biochar–bentonite composite (CB) was prepared from local millet straw and bentonite...
This work is devoted to the study of magnetic Fe3O4 nanoparticles doubly coated with carbon. First, Fe3O4@C nanoparticles were synthesized by thermal decomposition. Then these synthesized nanoparticles, 20–30 nm in size were processed in a solu...
Our current study deals with the dye adsorption and electrical property of a partially carbonized composite fiber containing transition metal oxides including, iron oxide, nickel oxide, and titanium oxide. The fiber was made by electrospinning, carbo...
In this work, the cocoa pod husk (CPH) was converted into biochar products at higher carbonization temperatures (i.e., 400–800 °C). The pore and chemical properties of the resulting biochars and its post-leaching biochars by acid washing, i...
A polyampholytic superabsorbent polymer (PASAP), sodium alginate-g-(polyacrylic acid-co-allyltrimethylammonium chloride) (SA-g-(PAA-co-PTM)), was prepared by free-radical graft copolymerization and characterized. The polymer exhibited pH-dependent sw...
Graphene’s incorporation into polymers has enabled the development of advanced polymer/graphene nanocomposites with superior properties. This study focuses on the use of a microcellular foamed polystyrene (PS)/graphene (GP) nanocomposite (3 wt%...
In this study, polyacrylic acid hydrogels were prepared by modulating the cross-linking agent mass ratio using UV and heat curing methods. The structures and properties of the hydrogels were characterized and analyzed using Fourier transform infrared...
This work focused on a mutual comparison and characterization of the physicochemical properties of three-component polymer composites. Binary polyaniline–chitosan (PANI–CHT) composites were synthesized by in situ polymerization of PANI on...
World orange production is estimated at 60 million tons per annum, while the annual production of orange peel waste is 32 million tons. According to available data, the adsorption capacity of orange peel ranges from 3 mg/g to 5 mg/g, while their wate...
of 137