This paper presents a design of a triangular slot-loaded planar rectangular antenna array for wideband millimeter-wave (mm-wave) 5G communication systems. The proposed array realizes an overall size of 35.5 × 14.85 mm2. To excite the array elements,...
The design of a circularly slotted triangular patch radiator with a full-ground structure for 5.8 GHz ISM band applications is the basis for this research. The working band of the suggested miniaturized patch radiator may be adjusted by adjusting the...
Among other CubeSat subsystems, Antenna is one of the most important CubeSat components as its design determines all the telecommunication subsystems’ performances. This paper presents a coplanar wave-guide (CPW)-fed equilateral triangular slot...
High-pressure fluctuation and flow ripple may cause unexpected vibration and noise when the piston pump works under severe conditions, and eventually lead to hydraulic transmission failure. The geometry of the valve plate has a great influence on the...
In this article, two distinct kinds of metamaterial (MTM) antennas are proposed for fifth-generation (5G) indoor distributed antenna systems (IDAS). Both antennas operate in the sub-6 GHz 5G band, i.e., 3.5 GHz. The antenna’s radiating structur...
We conducted a numerical study of the effects of a vortex generator (VG) on the combustion characteristics and physical fluid flow of LPG on a porous bluff-body slot burner (PBSB) model, validating the numerical and experimental results of the temper...
The design and modeling of a highly sensitive sensor based on a slot photonic crystal waveguide (slot-PCWG) is presented. The structure consists of cylindrical air rods drilled in a dielectric slab on a triangular lattice, which are filled with SiO2....
A compact triple-band operation ultra-wideband (UWB) antenna with dual-notch band characteristics is presented in this paper. By inserting three metamaterial (MTM) square split-ring resonators (MTM-SSRRs) and a triangular slot on the radiating patch,...
In the present study, the hydraulic operation of flow through transverse bottom racks screens with conventional triangular wedge wire and alternative circular section wire is experimentally and numerically analyzed. A laboratory prototype is built fo...
This study deals with the improvement in drying process performances and the quality of the final product for industrial equipment in the food industry. Designers need to optimize the design parameters of devices to create synergies between the great...
This paper proposes a small-size broadband triangular monopole chip antenna for millimeter wave band applications. Process using 0.18 μm CMOS process and antenna design using Met-al_6. Triangular patch design and feed line length analysis to achie...
Directed energy deposition (DED) has been widely used for component repair. In the repair process, the surface defects are machined to a groove or slot and then refilled. The sidewall inclination angle of the groove geometry has been recognized to ha...
There are many technologies to implement sand control in sand-prone wells, drilled in either weakly or nonconsolidated sandstones. Technologies that are used to prevent sanding can be divided into the following groups: screens (wire-wrapped screens,...
This paper presents the design and realization of a compact size multimode frequency reconfigurable antenna. The antenna consists of a triangular-shaped monopole radiator, originally inspired from a rectangular monopole antenna. Slots were utilized t...
This paper presents a novel low-profile microstrip antenna with an omnidirectional radiation pattern for an artillery-launched observation round. The proposed antenna consists of one centered hexagonal patch for a feeding network and six periodic arr...
In this paper, a slotted conical patch connected to a small triangular patch multiband antenna for both microwave and millimeter-wave applications is presented. The designed antenna has three characteristics. The proposed antenna is a multiband, havi...
Microwave ablation is commonly used in soft tissue tumors, but its application in bone tumors has been barely analyzed. Antennas to treat bone tissue (~3 cm2), has been lately designed. Bone tumors at pathological stage T1 can reach 8 cm wide. An ant...
This article reports an experimental investigation of the efficacy of self-flushing in the Electrical Discharge Machining (EDM) process in terms of tool wear rate (TWR), hole taper angle and material removal rate (MRR). In addition to a plain cylindr...
In this paper, we present the design of a millimeter-wave 1 × 4 linear MIMO array antenna that operates across multiple resonance frequency bands: 26.28–27.36 GHz, 27.94–28.62 GHz, 32.33–33.08 GHz, and 37.59–39.47 GHz, f...
This paper presents the design and development of a new semicircular inverted triangular shaped antenna for 5G millimeter-wave wireless applications. An alternate-mixed approach based on cavity, slots and loaded stubs is employed in the designed ante...
In urban environments, the highly complex communication environment often leads to blockages in the link between ground users (GUs) and unmanned aerial vehicles (UAVs), resulting in poor communication quality. Although traditional reconfigurable inte...
A piezoelectric actuator (PEA) has the characteristics of high control precision and no electromagnetic interference. To improve the degree of freedom (DOF) to adapt to more working scenes, a piezoelectric–electromagnetic hybrid-driven two-DOF...
The European Standard ISO 16122-2:2015 requires that the coefficient of variation for sprayed liquid fall should not exceed 10%. Field sprayers generate a stream of liquid sprayed at an angle that depends on the design of the nozzles. Among field boo...
In this manuscript, a compact in size yet geometrically simple Ultra-Wideband (UWB) antenna is demonstrated. The flexible-by-nature substrate ROGERS 5880, having a thickness of 0.254 mm, is utilized to design the proposed work. The antenna configurat...
Near-perfect resonant absorption is attained in a single-polarization single-mode photonic crystal fiber (SPSM PCF) within the long-wave infrared (LWIR) range from 10 to 11
This paper proposes a standard applications of Radio Frequency Identification (RFID) system to manage vehicles at electronic toll gate system without compromising the vehicle speed. The existing electronic toll gate system has low latency as each car...
A compact quad-band multiple-input multiple-output (MIMO) antenna for terahertz communications is presented in this work. The proposed antenna consists of a truncated square patch with inverted-U-shaped and C-shaped slots. The operating frequencies o...
This paper presents a novel broadband circularly polarized optically transparent monopole antenna using indium tin oxide (ITO) and PMMA. The proposed design successfully integrates ultra-wideband circular polarization characteristics with exceptional...
A novel compact fractal loaded two- and eight-element multiple input multiple output (MIMO) with strong diversity is designed for 5G Sub 6 GHz and WLAN applications. The suggested antenna is designed and manufactured on inexpensive FR4 dielectric mat...
Micro-channel heat sink (MCHS) has been extensively used in various electronic cooling fields. Double-layered MCHS, or DL-MCHS, is regarded as one effective technique for high-heat-flux transfer and is expected to meet the ever-increasing heat load r...
Hydrodynamic cavitation usually occurs in marine and ocean engineering and hydraulic systems and may lead to destructive effects such as an enhanced drag force, noise, vibration, surface damage, and reduced efficiency. Previous studies employed sever...
Mg-NiTi-based metal matrix composites are appropriate solutions for the two most important goals of material engineers in the present day, i.e., imparting functional behaviour and the light weighting of metallic structures. In recent years, due to it...