Skip to Content

20 Results Found

  • Article
  • Open Access
32 Citations
8,910 Views
25 Pages

6 September 2021

This study aims to evaluate five different methodologies reported in the literature for developing fragility curves to assess the seismic performance of RC structures subjected to structural pounding. In this context, displacement-based and curvature...

(This article belongs to the Special Issue Seismic Assessment and Design of Structures)
  • Article
  • Open Access
752 Views
21 Pages

11 August 2026

Pre-stack depth migration can improve imaging shallow structures in fault zones, but its use is limited by the difficulty of defining a suitable starting velocity model. This problem is relevant in small intramontane basins, where strong lateral hete...

(This article belongs to the Section Earth Sciences)
  • Article
  • Open Access
4 Citations
1,696 Views
24 Pages

6 November 2025

Ocean-bottom seismic (OBS) surveys have been applied in marine oil and gas exploration. In the typical OBS observation geometry, the source and receiver are located on/near different datums, i.e., the sea surface and the seafloor. Besides the desired...

(This article belongs to the Special Issue Modeling and Waveform Inversion of Marine Seismic Data)
  • Article
  • Open Access
13 Citations
3,439 Views
19 Pages

8 August 2022

Probabilistic seismic demand analysis (PSDA) is known as one of the critical intermediate steps in the performance-based earthquake engineering (PBEE) design framework. Accuracy of the PSDA is influenced by various sources of uncertainties and mostly...

(This article belongs to the Section Building Structures)
  • Feature Paper
  • Article
  • Open Access
1 Citations
572 Views
16 Pages

23 January 2026

This research aims to assess and quantify the significance of incorporating the seismic performance of global and local engineering demand parameters (EDPs) within probabilistic frameworks when structural pounding of adjacent buildings occurs. For th...

(This article belongs to the Section Civil Engineering)
  • Article
  • Open Access
397 Views
21 Pages

1 August 2026

High-speed railways are expanding into seismic zones, where earthquakes severely threaten the safety of vehicles on bridges. Existing seismic studies of high-speed railway bridges mainly address the structural fragility of the overall bridge, piers,...

  • Article
  • Open Access
2 Citations
838 Views
21 Pages

This study presents a probabilistic seismic fragility assessment of a jointed rock slope by integrating field characterization, incremental dynamic analysis (IDA), and numerical modeling. Dominant joint sets are identified through field mapping, and...

(This article belongs to the Section Natural Hazards)
  • Article
  • Open Access
46 Citations
4,891 Views
23 Pages

Fragility Analyses of Bridge Structures Using the Logarithmic Piecewise Function-Based Probabilistic Seismic Demand Model

  • Yinghao Zhao,
  • Hesong Hu,
  • Lunhua Bai,
  • Mengxiong Tang and ,
  • Hang Chen and
  • Dingli Su
  • + 1 author+ 0 author

13 July 2021

Seismic fragility analysis is an efficient method to evaluate the structural failure probability during earthquake events. Among the existing fragility analysis methods, the probabilistic seismic demand model (PSDM) and the joint probabilistic seismi...

(This article belongs to the Special Issue Reliability and Optimization for Engineering Design)
  • Feature Paper
  • Article
  • Open Access
18 Citations
3,963 Views
18 Pages

20 August 2021

The purpose of this study is to evaluate the optimal earthquake intensity measures (IMs) for probabilistic seismic demand models (PSDMs) of the base-isolated nuclear power plant (NPP) structures. The numerical model of NPP structures is developed usi...

(This article belongs to the Section B4: Nuclear Energy)
  • Article
  • Open Access
1,339 Views
20 Pages

The Qiangtang Basin (Tibetan Plateau) poses significant geophysical challenges for seismic exploration due to near-surface widespread permafrost and steeply dipping Mesozoic strata induced by the Cenozoic Indo-Eurasian collision. These seismic geolog...

(This article belongs to the Section Geophysics)
  • Article
  • Open Access
3 Citations
4,110 Views
24 Pages

10 August 2021

Uncertainty in industrial processes is very common, but it is particularly high in the grinding process (GP), due to the set of interacting operating/design parameters. This uncertainty can be evaluated in different ways, but, without a doubt, one of...

(This article belongs to the Special Issue Modeling, Design and Optimization of Multiphase Systems in Minerals Processing, Volume II)
  • Article
  • Open Access
10 Citations
5,780 Views
16 Pages

19 July 2019

With the purpose of limiting the drastically increasing quantity of travel volumes and the sustainability of urban traffic systems, many cities have implemented urban traffic restriction (UTR) policies. However, insufficient stakeholder involvement i...

  • Article
  • Open Access
3 Citations
1,227 Views
33 Pages

17 September 2025

When the global navigation satellite systems (GNSSs) are unavailable, cellular signals of opportunity (SOPs) can be used to achieve positioning. However, in low observability environments where both GNSS signals and cellular SOPs are less than 2, the...

(This article belongs to the Section Navigation and Positioning)
  • Article
  • Open Access
12 Citations
2,937 Views
16 Pages

The effect of an intensity measure’s (IM’s) sufficiency property on the probabilistic assessment of reinforced concrete (RC) structures due to floor-to-floor structural pounding conditions is examined. In the first part of this investigat...

(This article belongs to the Special Issue Seismic Analysis of Multistoried Buildings)
  • Article
  • Open Access
473 Views
28 Pages

Joint Prestack Depth Migration of Surface Seismic and DAS-VSP Data in the OVT Domain

  • Yuanyuan Yan,
  • Juncheng Dai,
  • Yuchen Peng,
  • Zongyang Li and ,
  • Peidong Huang and
  • Jun Lu
  • + 1 author+ 0 author

17 June 2026

Surface seismic data often suffer from limited bandwidth and uneven illumination, which degrade PSDM (prestack depth migration) in deep and structurally complex settings. VSP (vertical seismic profiling), particularly DAS-VSP, provides a higher signa...

(This article belongs to the Section Earth Sciences)
  • Article
  • Open Access
17 Citations
3,472 Views
21 Pages

26 May 2021

The multi-cell composite T-shaped concrete-filled steel tubular (MT-CFST) element is an innovative structural form. It has great potential for construction applications because of favorable advantages over traditional composite elements. The flexural...

(This article belongs to the Special Issue Advanced Steel Composites in Construction Engineering)
  • Article
  • Open Access
7 Citations
4,136 Views
19 Pages

Fragility Analysis of Gantry Crane Subjected to Near-Field Ground Motions

  • Qihui Peng,
  • Wenming Cheng,
  • Hongyu Jia and
  • Peng Guo

19 June 2020

A gantry crane located in a near-field earthquake-prone area is selected in this paper as an example, and the nonlinear finite element (FE) model is used considering the material nonlinearity including plastic hinges and the second order (P &minus...

(This article belongs to the Section Mechanical Engineering)
  • Article
  • Open Access
1 Citations
1,861 Views
36 Pages

24 October 2025

In low to medium-seismicity countries, seismic design is often not mandatory. Furthermore, zoning is frequently adopted to justify simplified calculations based on force methods without capacity criteria. However, risk analysis should merge vulnerabi...

(This article belongs to the Special Issue Research on the Seismic Performance of Reinforced Concrete Structures)
  • Article
  • Open Access
478 Views
27 Pages

18 August 2026

This study investigates the time-dependent seismic fragility of reinforced concrete (RC) bridge piers exposed to the harsh saline–alkali environments of Northwest China. A comprehensive analytical framework was developed by integrating quasi-st...

(This article belongs to the Section Building Structures)
  • Article
  • Open Access
225 Views
24 Pages

DFANet: A Lightweight Dual-Branch Feature-Aggregation Network for Metal Surface Defect Detection

  • Hongshan Gou,
  • Yueji Wang,
  • Fujian Feng,
  • Fei Wang and ,
  • Mian Tan and
  • Weili Yang
  • + 1 author+ 0 author

26 October 2026

Object detection is pivotal for automated industrial surface defect detection. However, industrial imaging of metal surfaces is often hampered by adverse factors such as uneven illumination, strong specular reflection, low contrast, and blurring of t...

(This article belongs to the Topic Applied Computer Vision and Pattern Recognition: 3rd Edition)