The integration of renewable energy sources, including photovoltaic (PV) and fuel cell (FC) systems, into AC grids has attracted immense research interest in recent times. Furthermore, incorporating these renewable sources of energy into medium-volta...
Due to their many advantages over their counterparts, such as Z-source inverters (ZSIs), split-source inverters (SSIs) have recently received much attention as single-stage boost inverters. This paper discusses a multiphase version of the SSI topolog...
In transformerless grid-connected photovoltaic (PV) systems, leakage currents should be properly addressed. The voltage fluctuations between the neutral point of the grid and the PV array, i.e., common-mode voltage (CMV), will affect the value of the...
The existing solutions for reducing total harmonic distortion (THD) using different control algorithms in shunt active power filters (SAPFs) are complex. This work proposes a split source inverter (SSI)-based SAPF for improving the power quality in a...
This paper presents a multi-input Ćuk-derived Buck-Boost voltage source inverter (CBBVSI) for Photovoltaic (PV) systems. The proposed topology consists of a single-stage DC-AC inverter that combines both DC-DC and DC-AC stages. The DC-DC stage is use...
Three-phase, four-wire split capacitor inverters are currently employed in many applications, such as photovoltaic systems, battery chargers for electric vehicles, active power filters, and, in general, in all grid-tied applications that deal with po...
Novel energy generation technologies, such as high-permeability wind power and photovoltaic systems, exhibit inherent intermittency, randomness, and volatility. During periods of energy production from these sources, the impedance of the electrical g...
To reduce the burden of electric vehicle (EV) charging power requirements, photovoltaic (PV) infrastructure EV charging has grown in recent years. The Z-Source Inverter (ZSI) allows tapping the boosted DC and AC by adjusting the switching shoot-throu...
Regarding the problems of resonance and direct current (DC) components when the Z-source inverter (ZSI) without an isolation transformer is connected to the grid through an LCL filter, this paper proposes a novel DC component suppression strategy for...
To address the challenge of accurately inverting cloud base height (CBH) from passive remote sensing, this study proposes Hetero-CBHNet, a heterogeneous stacked integrated network framework for CBH inversion. The framework uses random forest (RF), co...
This paper proposes a model predictive direct power control scheme for nonredundant fault tolerant grid-connected bidirectional voltage source converter (BVSC) with balanced dc-link split capacitor voltage and high reliability. Based on the operation...
In this work, an advanced pulse width modulation (PWM) technique was developed to provide the auto-balancing of the capacitors voltages of the five-level split-packed U-Cells (SPUC5) single-phase inverter, and then, the latter was applied to a photov...
In this paper, a photovoltaic (PV) module-level Cascaded H-Bridge (CHB) inverter with an integrated Battery Energy Storage System (BESS) is proposed. The advantages and drawbacks of the CHB circuit architecture in distributed PV generation systems ar...
Dual Maximum Power Point Tracking (MPPT) inverters are essential in residential and small commercial solar power systems, optimizing power extraction from two independent solar panel arrays to enhance efficiency and energy harvesting. On the other ha...
The voltage ride through capability of the major auxiliary variable-frequency drive (VFD) in large thermal power plants is the key technical issue of power grid and source coordination. In order to test the high voltage ride through (HVRT) and low vo...
In this paper, a comprehensive double-vector approach is proposed to alleviate the common-mode voltage of voltage-source inverters based on a model predictive control scheme. Only six active vectors are selected to alleviate the common-mode voltage....
This article presents the experimental validation of a model-based predictive control (MPC) strategy for the safe interconnection of voltage source inverters (VSI) with output LC filters for the grid connection of DC energy resources. The MPC is form...
Recently, energy costs have increased significantly, and energy savings have become more important, leading to the use of different patterns to align with the characteristics of demand-side load. This paper focused on the energy management of low-ris...
A piezoelectric cantilever with a longitudinal slit splits one bending resonance into two closely spaced peaks. This is attractive for two-frequency sources. However, existing models fit, rather than predict, the resonances. We develop a predictive b...
This paper presents a non-iterative technique that generates reference current to manage operation of a three-phase four-wire shunt active power filter which employs a three-leg split capacitor voltage source inverter (VSI) topology. The proposed tec...
Machine learning intrusion detection for unmanned aerial vehicles (UAVs) reports extremely high accuracy on public benchmarks, but such figures depend critically on how models are evaluated, and they are often inflated by identifier leakage or collec...
The ubiquity of sound synthesizers has reshaped modern music production, and novel music genres are now sometimes even entirely defined by their use. However, the increasing complexity and number of parameters in modern synthesizers make them extreme...
Land Surface Temperature (LST) is an important measurement in studies related to the Earth surface’s processes. The Advanced Space-borne Thermal Emission and Reflection Radiometer (ASTER) instrument onboard the Terra spacecraft is the currently avail...
Multiphase systems provides benefits compared to three-phase systems, such as improved torque per ampere, high power density, better fault tolerance, lower current per phase (due to power-splitting among a higher number of phases), and lower torque r...
Nowadays, the integration of renewable energy sources such as solar, wind, etc. into the grid is recommended to reduce losses and meet demands. The application of power electronics devices (PED) to control non-linear, unbalanced loads leads to power...