Skip to Content

19 Results Found

  • Article
  • Open Access
12 Citations
4,195 Views
21 Pages

10 July 2021

Municipal incinerator bottom ash (MIBA) and sewage sludge ash (SSA) are secondary wastes produced from municipal incinerators. Landfills, disposal at sea, and agricultural use have been the major outlets for these secondary wastes. As global emphasis...

(This article belongs to the Special Issue Concrete and Construction Materials)
  • Article
  • Open Access
6 Citations
4,974 Views
14 Pages

Sorted and aged bottom ash from Waste-to-Energy plants, i.e., MIBA (the Mineral fraction of Incinerator Bottom Ash) are potential source of metals that could be utilized to meet the increased demand from society. In this work, sunflowers (Helianthus ...

(This article belongs to the Special Issue Assessment and Remediation of Soils Contaminated by Potentially Toxic Elements (PTE))
  • Article
  • Open Access
10 Citations
4,359 Views
14 Pages

10 February 2021

In high speed, high load fluid-film bearings, the laminar-turbulent flow transition can lead to a considerable reduction of the maximum bearing temperatures, due to a homogenization of the fluid-film temperature in radial direction. Since this phenom...

(This article belongs to the Special Issue Advances in Lubricated Bearings)
  • Article
  • Open Access
31 Citations
5,283 Views
20 Pages

30 March 2022

This study presents the results of an experimental campaign on the use of municipal solid waste incinerator bottom ash (MIBA) and fly ash (FA) as precursors for the production of alkali-activated materials. MIBA was subjected to a pre-treatment stage...

(This article belongs to the Section Civil Engineering)
  • Article
  • Open Access
18 Citations
3,310 Views
17 Pages

24 December 2020

This study aims to evaluate the potential of incorporating fly ash (FA) and municipal solid waste incinerator bottom ash (MIBA) as a partial substitute of cement in the production of self-compacting concrete mixes through an experimental campaign in...

(This article belongs to the Section Materials Science and Engineering)
  • Article
  • Open Access
13 Citations
2,854 Views
17 Pages

27 June 2022

The objective of this study was to examine the optimal mixing ratio of municipal incinerated bottom ash (MIBA) and PET pellets used as a partial replacement of fine aggregates in the manufacture of cement mortars. As a partial replacement for sand, 1...

(This article belongs to the Special Issue Microplastics Degradation and Characterization)
  • Article
  • Open Access
16 Citations
5,004 Views
18 Pages

11 July 2021

With the objective of establishing a viable alternative to the use of cement, the main objective of this study is to verify the possibility of using municipal solid waste incinerator bottom ash (MIBA) as a partial cement replacement, thereby reducing...

(This article belongs to the Section Materials Science and Engineering)
  • Review
  • Open Access
47 Citations
7,099 Views
24 Pages

3 August 2020

In the light of one of the most common waste management issues in urban areas, namely the elimination of municipal solid waste (MSW; about 486 kg of the waste per capita were generated in the EU in 2017), this study discusses one technique as an outl...

(This article belongs to the Special Issue Low Carbon Cements)
  • Article
  • Open Access
2,263 Views
14 Pages

Compositional Diversity of Early Mesozoic Granites in South Qinling: Derivation from Heterogenous Basement Rocks in the Orogenic Belt

  • Risheng Ye,
  • Weiyong Li,
  • Dongyang Huo,
  • Jingxin Zhao and ,
  • Xiguang Huang,
  • Jun He and
  • Fukun Chen
  • + 2 authors+ 0 author

Granitic rocks forming in the syn- to post-orogenic stages can trace the compositional and structural complexity of the crust beneath an orogenic belt. The Qinling orogenic belt undertook multiple stages of tectonics and magmatism, resulting in the m...

  • Article
  • Open Access
4 Citations
5,866 Views
13 Pages

Reconstruction of Electrochemical Impedance Spectroscopy from Time-Domain Pulses of a 3.7 kWh Lithium-Ion Battery Module

  • Manuel Kasper,
  • Manuel Moertelmaier,
  • Hartmut Popp,
  • Ferry Kienberger and
  • Nawfal Al-Zubaidi R-Smith

We demonstrate the reconstruction of battery electrochemical impedance spectroscopy (EIS) curves from time-domain pulse testing and the distribution of relaxation times (DRT) analysis. In the proposed approach, the DRT directly utilizes measured curr...

  • Communication
  • Open Access
9 Citations
6,953 Views
11 Pages

17 January 2017

Mechanically robust photocatalytic titanium oxide coatings can be deposited using reactive magnetron sputtering. In this article, we investigate the effect of doping on the activity of reactively sputtered TiO2. Silver, copper and stainless steel tar...

  • Article
  • Open Access
2 Citations
4,764 Views
24 Pages

In this second part of the paper series, parameter investigations of the tribological system chain pin/bush contact, carried out on a specifically developed pin on bush plate model test technique, are presented. Both the pin material and the lubrican...

(This article belongs to the Special Issue Tribology in Mobility, Volume II)
  • Article
  • Open Access
6 Citations
4,676 Views
20 Pages

16 February 2023

The present work deals with the tribological characterization of the bush-pin contact in timing chains, with a particular focus on the pin wear processes and the development of a model testing technique suitable for this purpose. With the presented t...

(This article belongs to the Special Issue Tribology in Mobility, Volume II)
  • Article
  • Open Access
30 Citations
6,180 Views
21 Pages

Data-Driven Sliding Bearing Temperature Model for Condition Monitoring in Internal Combustion Engines

  • Christian Laubichler,
  • Constantin Kiesling,
  • Matheus Marques da Silva,
  • Andreas Wimmer and
  • Gunther Hager

Condition monitoring of components in internal combustion engines is an essential tool for increasing engine durability and avoiding critical engine operation. If lubrication at the crankshaft main bearings is insufficient, metal-to-metal contacts be...

(This article belongs to the Special Issue Tribology in Mobility)
  • Article
  • Open Access
49 Citations
27,206 Views
16 Pages

20 August 2017

Residual stresses of physical vapor deposition (PVD) hard coatings can be measured using X-ray diffraction (XRD) methods under either conventional d-sin2 ψ mode or glancing incident (GIXRD) mode, in which substantial uncertainties exist depending on...

(This article belongs to the Special Issue Mechanical Behavior of Coatings and Engineered Surfaces)
  • Feature Paper
  • Article
  • Open Access
6 Citations
3,238 Views
21 Pages

Microstructure-Based Lifetime Assessment of Austenitic Steel AISI 347 in View of Fatigue, Environmental Conditions and NDT

  • Ruth Acosta,
  • Klaus Heckmann,
  • Jürgen Sievers,
  • Tim Schopf and ,
  • Tobias Bill,
  • Peter Starke,
  • Kai Donnerbauer,
  • Lukas Lücker,
  • Frank Walther and
  • Christian Boller
  • + 5 authors+ 0 author

25 November 2021

The assessment of metallic materials used in power plants’ piping represents a big challenge due to the thermal transients and the environmental conditions to which they are exposed. At present, a lack of information related to degradation mech...

(This article belongs to the Section Mechanical Engineering)
  • Article
  • Open Access
19 Citations
9,630 Views
17 Pages

Photocatalytic TiO2 and Doped TiO2 Coatings to Improve the Hygiene of Surfaces Used in Food and Beverage Processing—A Study of the Physical and Chemical Resistance of the Coatings

  • Parnia Navabpour,
  • Soheyla Ostovarpour,
  • Carin Tattershall,
  • Kevin Cooke and ,
  • Peter Kelly,
  • Joanna Verran,
  • Kathryn Whitehead,
  • Claire Hill,
  • Mari Raulio and
  • Outi Priha
  • + 5 authors+ 0 author

15 July 2014

TiO2 coatings deposited using reactive magnetron sputtering and spray coating methods, as well as Ag- and Mo-doped TiO2 coatings were investigated as self-cleaning surfaces for beverage processing. The mechanical resistance and retention of the photo...

(This article belongs to the Special Issue Photocalytic Coatings for Air-Purifying, Self-Cleaning and Antimicrobial Properties)
  • Article
  • Open Access
14 Citations
4,228 Views
15 Pages

Spent Coffee Grounds Alter Bacterial Communities in Latxa Dairy Ewes

  • Idoia Goiri,
  • Xabier Díaz de Otálora,
  • Roberto Ruiz,
  • Jagoba Rey and ,
  • Raquel Atxaerandio,
  • Jose Luis Lavín,
  • David San Martin,
  • Mikel Orive,
  • Bruno Iñarra and
  • Aser García-Rodríguez
  • + 7 authors+ 2 authors

Antimicrobial and antioxidant properties of spent coffee grounds (SCG) make them a potential ingredient in a diet for ruminants. This study investigated the effects of SCG on rumen microbiota. For 51 days, 36 dairy ewes were assigned to the experimen...

(This article belongs to the Special Issue Microbiomes for the Sustainable Production of Safe and Secure Foods)
  • Article
  • Open Access
7 Citations
2,242 Views
12 Pages

Deformation Induced Structure and Property Changes in a Nanostructured Multiphase CrMnFeCoNi High-Entropy Alloy

  • Benjamin Schuh,
  • Inas Issa,
  • Timo Müller,
  • Thomas Kremmer and ,
  • Christoph Gammer,
  • Reinhard Pippan and
  • Anton Hohenwarter
  • + 2 authors+ 0 author

A nanocrystalline CrMnFeCoNi high-entropy alloy produced using severe plastic deformation using high-pressure torsion was annealed at selected temperatures and times (450 °C for 1 h and 15 h and at 600 °C for 1 h), causing a phase decompositi...

(This article belongs to the Section Synthesis, Interfaces and Nanostructures)