April 2020 - 125 articles
Highly Ti-doped ZnO films have been produced by a spin-casting sol-gel process. The spin-casted films show high in plane homogeneity and optical quality. However, when inspected in depth, the surface composition is Ti rich. We show that two possible...
As graphene oxide-based oligonucleotide biosensors improve, there is a growing need to explore their ability to retain high sensitivity for low target concentrations in the context of biological fluids. Therefore, we innovatively combined assay milie...
The magnitude of shear stress at the ciliated wall is considered as the measure of efficiency of cilia beatings as it describes the momentum transfer between the medium and the cilia. Under high shear rate, some non-Newtonian fluids behave as visco-i...
(CrTaTiVZr)N coatings were prepared on Si substrates through the reactive magnetron sputtering system to investigate the oxidation behaviors and structural evolution of the coatings at different annealing temperatures in air. The (CrTaTiVZr)N coating...
Extreme high-speed laser material deposition, known by its German acronym EHLA, is a new variant of laser material deposition (LMD) with powdered additives. This variant’s process control is unlike that of LMD, where the powder melts as it cont...
Aluminum nitride nanoparticles (AlN-NPs) were fabricated by a RF magnetron sputtering and inert gas condensation technique. By keeping the source parameters and sputtering time of 4 h fixed, it was possible to produce AlN-NPs with a size in the range...
The iron doped tungsten-oxide (Fe and WO3) thin film with different morphology and crystalline structures were obtained for different substrate temperatures at the oxygen pressure of 14.66 Pa. The Fe-doped WO3 films were deposited by pulsed laser dep...
A polyurethane (PU)-based powder coating reinforced with vinyltrimethoxysilane (VTMS)-functionalized ZrO2 nanoparticles (V-ZrO2) for thermal stability was developed. Chemical structure, microstructure and thermal degradation kinetics of the prepared...
The operation of numerous safety-critical components in industries around the world relies on protective coatings. These coatings often allow process equipment to be purposeful in environments well beyond the operational limit of the uncoated compone...
SiC coatings were successfully synthesized on NextelTM440 fibers by chemical vapor deposition (CVD) using methyltrichlorosilane as the original SiC source at 1373 K. After deposited, the fibers were fully surrounded by uniform coatings with some bulg...
of 13
Get Alerted
Add your email address to receive forthcoming issues of this journal.
