Skip to Content

19 Results Found

  • Article
  • Open Access
1 Citations
3,573 Views
19 Pages

23 October 2024

In eccentrically braced frames (EBFs), inelastic behavior is only permitted in the links. All members, except for the links, are designed according to the capacity design concept by using the link overstrength factor, Ω, so that they remain ela...

(This article belongs to the Section Civil Engineering)
  • Article
  • Open Access
6 Citations
1,890 Views
21 Pages

Mechanical Properties and Influence Factors of Ordinary Shear Links

  • Shujun Hu,
  • Shangwen Liu,
  • Sizhi Zeng and
  • Tiefeng Shao

9 January 2024

The current specification requires the same limiting values of inelastic rotation and the overstrength factor for shear links with a length ratio less than 1.6. However, recent studies have shown that the mechanical properties of ordinary shear links...

(This article belongs to the Special Issue Advanced Studies on Steel Structures)
  • Article
  • Open Access
3 Citations
5,161 Views
19 Pages

Shaking Table Testing of a Low-Rise Reinforced Concrete Intermediate Moment Resisting Frame

  • Sida Hussain,
  • Hamna Shakeel,
  • Asif Ali,
  • Muhammad Rizwan and
  • Naveed Ahmad

1 December 2022

Multi-level shaking table tests were performed on a 1:3 reduced scale two-story reinforced concrete (RC) intermediate moment resisting frame (IMRF) conforming to the requirements given in the ACI-318-19. The exterior joints lacked shear reinforcement...

(This article belongs to the Special Issue Advanced Research and Prospect of Buildings Seismic Performance)
  • Article
  • Open Access
4,214 Views
17 Pages

26 October 2021

We explored the usage of a response modification factor and overstrength factor for analyzing brittle or ductile failure of anchor system. Parametric studies on the tension and shear behaviors of anchor systems were compared in terms of elastic and d...

(This article belongs to the Section Civil Engineering)
  • Article
  • Open Access
5 Citations
2,873 Views
23 Pages

24 May 2024

In 2007, the American Iron and Steel Institute (AISI) established a standard for cold-formed steel–special bolted moment frames (CFS-SBMFs). This structural system is designed to resist seismic forces. The CFS-SBMF system employs double-channel...

(This article belongs to the Special Issue Performance-Based Seismic Design)
  • Article
  • Open Access
2 Citations
2,903 Views
17 Pages

23 August 2022

The over-strength coefficient is one of the key factors for the seismic safety of a structure. For RC frames, the infill wall may improve the lateral bearing capacity, while the seismic demand increases as well, which leads to the unexpected seismic...

(This article belongs to the Special Issue Resilience-Based Structural Seismic Design and Evaluation)
  • Feature Paper
  • Article
  • Open Access
2 Citations
3,553 Views
19 Pages

Seismic Resilience and Design Factors of Inline Seismic Friction Dampers (ISFDs)

  • Ali Naghshineh,
  • Ashutosh Bagchi and
  • Fariborz M. Tehrani

18 July 2023

While damping devices can provide supplemental damping to mitigate building vibration due to wind or earthquake effects, integrating them into the design is more complex. For example, the Canadian code does not provide building designs with inline fr...

(This article belongs to the Special Issue Advances in Structural Analysis and Rehabilitation for Existing Structures)
  • Article
  • Open Access
590 Views
26 Pages

Configuration-Sensitive Decomposition of the Response Modification Factor in Reinforced Concrete Moment Frames

  • Betzabeth Suquillo,
  • Stefanía Villavicencio,
  • Christian D. Medina and
  • Brian Cagua

10 July 2026

The response modification factor R is a fundamental parameter in seismic design, linking the elastic demand expected under strong ground motion to the reduced forces used in practice. It reflects the capacity of well-detailed structures to dissipate...

(This article belongs to the Section Building Structures)
  • Article
  • Open Access
13 Citations
6,724 Views
24 Pages

Investigation of the Earthquake Performance Adequacy of Low-Rise RC Structures Designed According to the Simplified Design Rules in TBEC-2019

  • Nur Seda Yel,
  • Musa Hakan Arslan,
  • Ceyhun Aksoylu,
  • İbrahim Hakkı Erkan and ,
  • Hatice Derya Arslan and
  • Ercan Işık
  • + 1 author+ 0 author

18 October 2022

In this study, earthquake performance of the structures was tested which were modeled according to the minimum criteria of simplified analysis approach proposed in TBEC-2019. For this purpose, 144 reinforced-concrete building models were designed acc...

(This article belongs to the Collection Building's Vulnerability Assessment against Natural Hazards by Using Modern Computational Techniques)
  • Article
  • Open Access
1 Citations
2,535 Views
14 Pages

Effective Stiffness and Seismic Response Modification Models Recommended for Cantilever Circular Columns of RC Bridges, First Part: Serviceability Limit State

  • Sergio Márquez-Domínguez,
  • José E. Barradas-Hernández,
  • Franco Carpio,
  • Alejandro Vargas-Colorado and ,
  • Armando Aguilar-Melendez and
  • Rolando Salgado-Estrada
  • + 1 author+ 0 author

23 September 2023

This paper’s main aim was to explain the process of characterising the structural over-strength factor (R), seismic behaviour factor (Q), and the effective elastic stiffness, Keff, of cantilever-reinforced concrete (RC) urban bridge columns wit...

(This article belongs to the Special Issue Buildings and Infrastructures Performance in Seismic Events: Understanding the Impact of Earthquakes)
  • Article
  • Open Access
5 Citations
3,675 Views
31 Pages

31 May 2025

Currently, seismic-resistant design is carried out by applying codes that are periodically updated based on research findings and lessons learned from major seismic events. In the case of buildings located on sloping terrains and those composed of re...

(This article belongs to the Special Issue Advanced Structural Analysis for Earthquake-Resistant Design of Buildings)
  • Article
  • Open Access
1 Citations
2,705 Views
16 Pages

Effective Stiffness and Seismic Response Modification Models Recommended for Cantilever Circular Columns of RC Bridges, Second Part: Collapse Prevention Limit State

  • Alejandro Vargas-Colorado,
  • José E. Barradas-Hernández,
  • Franco Carpio,
  • Sergio Márquez-Domínguez and ,
  • Rolando Salgado-Estrada and
  • Armando Aguilar-Melendez
  • + 1 author+ 0 author

23 September 2023

This paper aims to assess the structural overstrength (R), seismic behaviour factor (Q), and effective inertia factor (keff), of which the effective elastic stiffness (Keff) is a function, i.e., Keff (keff), of reinforced concrete (RC) cantilever col...

(This article belongs to the Special Issue Buildings and Infrastructures Performance in Seismic Events: Understanding the Impact of Earthquakes)
  • Article
  • Open Access
12 Citations
5,576 Views
21 Pages

28 June 2020

A seismic performance evaluation of selective storage racks subjected to Chilean Earthquakes was conducted using nonlinear pushover and nonlinear dynamic time-history analyses. Nine seismic records with two horizontal components and magnitude Mw >...

(This article belongs to the Special Issue Advances in Structural Steel Research)
  • Article
  • Open Access
5 Citations
4,654 Views
19 Pages

Assessment of Strength Reduction Factor on Concrete Moment Frames According to the New Venezuelan Seismic Code

  • Ramón Mata-Lemus,
  • Ahmad Idrees-Rustom,
  • Javier Sánchez-Rodríguez,
  • Ronald Torres-Moreno and ,
  • Eduardo Nuñez-Castellanos and
  • Guillermo Bustamante-Laissle
  • + 1 author+ 0 author

22 February 2022

Nonlinear static analysis is a validated tool for the seismic evaluation of existing and new structures, specifically for reinforced concrete buildings. In order to assess the performance of reinforced concrete frames designed according to the new Ve...

(This article belongs to the Collection Advanced Concrete Structures in Civil Engineering)
  • Article
  • Open Access
7 Citations
4,768 Views
20 Pages

31 July 2023

This paper aims to guide structural engineers on how to apply the rapid nonlinear time history analysis (RNLTHA) procedure effectively to predict seismic demand, taking into account ductility and overstrength, and effects of dynamic phenomena includi...

(This article belongs to the Special Issue Site-Specific Seismic Design of Buildings)
  • Article
  • Open Access
2 Citations
1,017 Views
16 Pages

This study investigates the seismic performance and behavior factors of reinforced concrete (RC) frames, focusing on the significant influence of masonry infill walls. While standard design codes like ACI-318, CSA-A23.3, and TBDY-2018 provide framewo...

(This article belongs to the Section Building Structures)
  • Article
  • Open Access
7 Citations
3,505 Views
23 Pages

7 December 2022

The Buckling Restrained Braced Frame (BRBF), consisting of a ductile steel core in concrete or a steel tube encased in concrete, is constructed to avoid brittle failure modes. The application of ductile materials with improved damping properties, suc...

(This article belongs to the Section Sustainable Engineering and Science)
  • Article
  • Open Access
1 Citations
4,354 Views
24 Pages

28 May 2021

To improve the durability and serviceability of reinforced concrete structures, different variants of dual-phase reinforcing steel were developed within the research project NEWREBAR. The investigated variant of the new material, termed DPD2 steel, h...

(This article belongs to the Special Issue Seismic Assessment and Design of Structures)
  • Feature Paper
  • Article
  • Open Access
45 Citations
4,434 Views
19 Pages

Machine Learning Algorithm for Shear Strength Prediction of Short Links for Steel Buildings

  • Ghassan Almasabha,
  • Odey Alshboul,
  • Ali Shehadeh and
  • Ali Saeed Almuflih

The rapid growth of using the short links in steel buildings due to their high shear strength and rotational capacity attracts the attention of structural engineers to investigate the performance of short links. However, insignificant attention has b...

(This article belongs to the Section Construction Management, and Computers & Digitization)