Skip to Content

18 Results Found

  • Article
  • Open Access
2 Citations
1,265 Views
12 Pages

Peculiarities of the Creep Behavior of 15Kh2NMFAA Vessel Steel at High Temperatures

  • Egor Terentyev,
  • Artem Marchenkov,
  • Vladimir Loktionov,
  • Anastasia Pankina and ,
  • Georgy Sviridov,
  • Ksenia Borodavkina,
  • Danila Chuprin and
  • Nikita Lavrik
  • + 3 authors+ 0 author

22 May 2025

The creep properties of 15Kh2NMFAA nuclear WWER (water–water energetic reactor) vessel steel in the range of 500–1200 °C temperatures, which may appear during severe nuclear reactor accidents, were investigated. The present paper atte...

  • Article
  • Open Access
10 Citations
5,479 Views
12 Pages

9 May 2019

The creep-buckling behaviors of cylindrical stainless-steel tubes subjected to radial external pressure load at elevated temperatures—800, 900, and 1000 °C—were experimentally investigated. Prior to the creep-buckling tests, the buckl...

(This article belongs to the Special Issue Creep and High Temperature Deformation of Metals and Alloys)
  • Article
  • Open Access
166 Views
22 Pages

22 October 2026

Creep-life prediction and assessment of creep-strain accumulation are important for the safe operation of gas-turbine hot-section components. This study investigates a nickel-based superalloy using finite element (FE) creep analysis and the Larson&nd...

  • Article
  • Open Access
17 Citations
12,058 Views
15 Pages

Creep Life Prediction of 10CrMo9–10 Steel by Larson–Miller Model

  • Agnieszka Zuzanna Guštin,
  • Borut Žužek and
  • Bojan Podgornik

23 June 2022

Creep is defined as the permanent deformation of materials under the effect of sustained stress and elevated temperature for long periods of time, which can essentially lead to fracture. Due to very time-consuming and expensive testing requirements,...

(This article belongs to the Section Mechanics of Materials)
  • Article
  • Open Access
18 Citations
5,083 Views
29 Pages

1 September 2018

Advanced power plant alloys must endure high temperatures and pressures for durations at which creep data are often not available, necessitating the extrapolation of creep life. Many methods have been proposed to extrapolate creep life, and one of re...

  • Article
  • Open Access
11 Citations
4,479 Views
45 Pages

13 December 2018

Advanced power plant alloys must endure high temperatures and pressures for durations at which creep data are often not available, necessitating the extrapolation of creep life. A recently developed creep life extrapolation method is the Wilshire equ...

  • Article
  • Open Access
606 Views
14 Pages

15 April 2026

The article documents the cause of a sharp decrease in the fracture toughness of HR3C austenitic steel intended for heat exchange surfaces of supercritical energy blocks during its exposure to elevated temperature. The documentation of the cause of t...

(This article belongs to the Section Metals and Alloys)
  • Article
  • Open Access
18 Citations
4,760 Views
15 Pages

Creep Behavior of Diffusion-Welded Alloy 617

  • Injin Sah,
  • Jong-Bae Hwang and
  • Eung-Seon Kim

19 May 2021

Plate-type heat exchangers are anticipated to be used in the next-generation nuclear industry, and solid-state diffusion welding is a critical technology for building plate-type heat exchangers with high integrity. In this study, we manufactured a di...

  • Article
  • Open Access
37 Citations
7,006 Views
19 Pages

A Phenomenological Primary–Secondary–Tertiary Creep Model for Polymer-Bonded Composite Materials

  • Xiaochang Duan,
  • Hongwei Yuan,
  • Wei Tang,
  • Jingjing He and
  • Xuefei Guan

18 July 2021

This study develops a unified phenomenological creep model for polymer-bonded composite materials, allowing for predicting the creep behavior in the three creep stages, namely the primary, the secondary, and the tertiary stages under sustained compre...

(This article belongs to the Section Polymer Processing and Engineering)
  • Article
  • Open Access
5 Citations
2,190 Views
18 Pages

Data and Knowledge Dual-Driven Creep Life Prediction for Austenitic Heat-Resistance Steel

  • Xiaochang Xie,
  • Mutong Liu,
  • Ping Yang,
  • Zenan Yang and ,
  • Chengbo Pan,
  • Chenchong Wang and
  • Xiaolu Wei
  • + 2 authors+ 0 author

25 January 2025

Traditional creep life prediction methods are generally difficult for researchers to fully consider the key factors affecting the creep performance, which limits their application in the research and development of new alloys. The artificial intellig...

  • Article
  • Open Access
7 Citations
3,511 Views
10 Pages

Assessment of Creep Properties Using Small Punch Test for a 9%Cr-Mo-Co-B Power Plant Steel

  • Xiao Tian,
  • Saifei Zhang,
  • Hui Xu,
  • Taijiang Li and ,
  • Baixun Yang and
  • Min Zhang
  • + 1 author+ 0 author

10 December 2021

The present study provides a feasible method to evaluate creep properties for a 9%Cr-Mo-Co-B power plant steel by comparing two sets of data obtained from small punch tests and conventional uniaxial creep tests. The method includes three steps: first...

(This article belongs to the Special Issue Corrosion and Protection of Metallic Materials)
  • Article
  • Open Access
5 Citations
2,358 Views
21 Pages

Analysis of the Causes of the Emergency Shutdown of Natural Gas-Fired Water Peak Boilers at the Large Municipal Combined Heat and Power Plant

  • Marcin Trojan,
  • Piotr Dzierwa,
  • Jan Taler,
  • Mariusz Granda and ,
  • Karol Kaczmarski,
  • Dawid Taler and
  • Tomasz Sobota
  • + 2 authors+ 0 author

29 August 2023

The paper presents a cause-and-effect analysis of the failure of a 130 MWt gas-fired water boiler. The fault was a rupture of the helically finned tubes in the first rows of the second-stage water heater (ECO2). The high frequency of failures forced...

  • Article
  • Open Access
34 Citations
4,377 Views
15 Pages

A Reliability Assessment Method for High Speed Train Electromagnetic Relays

  • Jianqiang Liu,
  • Ming Zhang,
  • Nan Zhao and
  • Aifeng Chen

14 March 2018

The condition of electromagnetic relays is crucial to the safe and normal operation of the high-speed train (HST). At present, there are no proper testing and assessment methods for the condition of electromagnetic relays. Electromagnetic relays expe...

  • Article
  • Open Access
12 Citations
4,297 Views
13 Pages

4 March 2021

We developed a health-monitoring methodology for high-temperature steam pipes that estimated the life prediction of creep–fatigue interaction by directly measuring the displacement of hot parts. Three different methods (boiler code, design stress, an...

(This article belongs to the Section Materials Science and Engineering)
  • Article
  • Open Access
404 Views
23 Pages

Aging-Induced Microstructural Evolution and Fracture Mechanisms of 35Cr45NiNb Alloy Under High-Temperature Tensile Deformation

  • Molin Su,
  • Gang Yu,
  • Zhijie Gao,
  • Huajun Tao and ,
  • Huitao Li,
  • Zihui Gao,
  • Yingli Li,
  • Yue Zhao,
  • Mingchao Bai and
  • Kai Song
  • + 6 authors+ 1 author

Centrifugally cast 35Cr45NiNb alloy has been widely employed in ethylene-cracking furnace tubes owing to its excellent carburization and creep resistance. However, the influence of microstructural degradation and temperature on its high-temperature t...

(This article belongs to the Section Innovations in Materials Science and Materials Processing)
  • Article
  • Open Access
4 Citations
4,184 Views
40 Pages

27 April 2023

In this study, we propose a consistent and explainable degradation indexing method and a non-destructive-based degradation and creep-life prediction method from extensive destructive test (creep-rupture) data of a nickel-based superalloy (DA-5161 SX)...

(This article belongs to the Section Sustainable Engineering and Science)
  • Article
  • Open Access
9 Citations
5,138 Views
22 Pages

24 April 2024

Stress relaxation cracking (SRC) is considered one of the major failure mechanisms for 347H stainless steel welds at elevated service temperatures or during post weld heat treatment (PWHT), especially within the heat-affected zone (HAZ). This work fo...

(This article belongs to the Section Metal Failure Analysis)
  • Article
  • Open Access
4 Citations
4,449 Views
13 Pages

2 November 2021

The Hellenic Air Force (HAF) operates both EMB-145 and EMB-135 LR versions of Embraer aircraft, used in surveillance and civil missions respectively. These aircraft are equipped with the same version of Rolls Royce, AE 3007 turbofan engine. This stud...

(This article belongs to the Special Issue Technologies for Future Distributed Engine Control Systems)