materials-logo

Journal Browser

Journal Browser

Continuum Mechanics of Micro-Structured and Nano-Structured Materials

A special issue of Materials (ISSN 1996-1944). This special issue belongs to the section "Materials Physics".

Deadline for manuscript submissions: closed (20 February 2022) | Viewed by 543

Special Issue Editor

Dipartimento di Ingegneria Civile e Ambientale, Politecnico di Milano, Piazza L. da Vinci 32, 20133 Milano, Italy
Interests: MEMS; smart materials; micromechanics; machine learning-driven materials modeling
Special Issues, Collections and Topics in MDPI journals

Special Issue Information

Dear Colleagues,

With a continuous trend towards miniaturization, micro- and nano-structural features are gaining importance in the analysis of the effective behavior of the materials constituting the building blocks of everyday life devices. Continuum approaches for polycrystalline or composite materials have been typically centered around a phenomenological description of the processes taking place at small length-scales; in this way, tuning parameters (with a limited physical meaning) have to be quantified through sometimes expensive experimental tests and, if possible, post-mortem analyses. The main risk of these approaches is a loss of generalization or a reduced capability to match the actual materials’ response under different loading conditions, in case different mechanisms are triggered at the micro-scale.

The goal of the current Special Issue is to collect contributions regarding microstructure-informed approaches that are able to account (even in a simplified way) for the possible phenomena taking place at length-scales comparable to, or even smaller than, the microstructural one. Topics of interest include but are not limited to:

  • Continuum thermodynamics of materials with internal length-scale(s);
  • Generalized continuum descriptions of multi-phase (composite) materials, including, e.g., gradient, Cosserat, micromorphic, couple stress, and nonlocal ones;
  • High-order homogenization procedures, inducing or allowing for a length-scale in the effective behavior of structured or architectured materials;
  • Multi-physics of materials with a microstructure;
  • Bio-inspired materials in architecture, and possible emergence of hierarchies of length-scales;
  • Effects of manufacturing processes, including 3D printing, on the effective response of materials at all length-scales;
  • Statistical analysis of uncertainties at small length-scales, and interactions with materials in architecture;
  • Design and analysis of micro- and nano-devices, either exploiting or exploring the opportunities offered by materials with a sub-mm architecture.

Dr. Stefano Mariani
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Materials is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Keywords

  • composite and architectured materials
  • bio-inspired and 3D-printed (meta)materials
  • continuum mechanics and thermodynamics
  • generalized continua
  • micromechanics
  • homogenization
  • multi-scale and multi-physics analyses

Published Papers

There is no accepted submissions to this special issue at this moment.
Back to TopTop