Controlled Free-Radical Polymerization: Recent Developments and Industrial Applications

Dear Colleagues,

Conventional free radical polymerization (FRP) has many advantages over other polymerization processes. FRP does not require stringent process conditions and can be used with a wide range of vinyl monomers. Nearly 50% of all commercial synthetic polymers are prepared using radical chemistry, providing materials for a wide spectrum of applications. The major limitation of FRP is poor control over some of the key elements of the process that would allow for the preparation of well-defined polymers with controlled molecular weight, polydispersity, composition, chain architecture, and site-specific functionality. Until three decades ago, controlled/living radical polymerization (CRP) was not considered. There are now several procedures for controlling radical polymerization, and corporations are introducing products based on CRP into numerous high-value markets. This Special Issue focuses on the evolution of CRP in recent years, from both the point of view of fundamental science and of applied outputs.

Prof. Dr. Dario Pasini
Guest Editor

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 250 words) can be sent to the Editorial Office for assessment.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-anonymized peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. International Journal of Molecular Sciences is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. There is an Article Processing Charge (APC) for publication in this open access journal. For details about the APC please see here. Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.