CFD-DEM Modelling of Multiphase Flow
This special issue belongs to the section "Mathematical and Computational Fluid Mechanics".
Special Issue Information
Dear Colleague,
Fluid flow and particle transport have attracted the attention of the researchers due to its widespread applications in engineering systems as well as in other applications. There are many possible applications for gas–liquid, liquid–liquid, gas–solid, and liquid–solid flow regimes. Slug flow, particle-laden flow, slurry flow, fluidized beds, and sedimentation are a few examples of multiphase flow. Many real-life applications, including spray drying, inertial separation, particle transport in the lung, cyclone separatord, liquid fuel, and aerosol dispersion, are classic examples of multiphase flow. A precise understanding of multiphase flow modelling is important for engineering systems and device optimization. This Special Issue is open to any subject area related to fluid flow and particle transport modelling.
Dr. Saidul Islam
Guest Editor
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 250 words) can be sent to the Editorial Office for assessment.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-anonymized peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Fluids is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 1800 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- fluid flow
- particle transport
- human lung modelling
- particle flow and heat transfer
- two-phase heat transfer
- boiling
- evaporation
- microfluidics
- nanofluidics
- phase change
- condensation
- multiphase flow
- CFD
- DEM
- particle-laden flow
- machine learning and particle flow
- fluidized bed
- microfluidic cell separation
- porous media
- heat transfer
- granular flow
- other flows
- particle dispersion and segregation
- particle technology
Benefits of Publishing in a Special Issue
- Ease of navigation: Grouping papers by topic helps scholars navigate broad scope journals more efficiently.
- Greater discoverability: Special Issues support the reach and impact of scientific research. Articles in Special Issues are more discoverable and cited more frequently.
- Expansion of research network: Special Issues facilitate connections among authors, fostering scientific collaborations.
- External promotion: Articles in Special Issues are often promoted through the journal's social media, increasing their visibility.
- Reprint: MDPI Books provides the opportunity to republish successful Special Issues in book format, both online and in print.
Published Papers
Fluids - ISSN 2311-5521