November 2023 - 157 articles
Under the influence of long-term vehicle loads and large attenuation degrees, asphalt pavement performance gradually decreases, which leads to failure in fulfilling the appropriate requirements and, in turn, may affect driving safety. The purpose of...
In this study, NiO films were fabricated through radio frequency sputtering with various oxygen flow rates and processed via rapid thermal annealing under Ar, O2, and N2 atmospheres. The electrical, optical, and crystallographic properties of the NiO...
Mixed-particle spraying has been applied to various aspects of industrial cold spraying for a long time. Due to the complexity of mixed-particle simulations, most studies only consider dozens of particles when considering particle collisions. This pa...
Ti-6Al-4V is a widely used titanium alloy in aviation and bio/chemical applications for its attractive mechanical and corrosion resistance properties. The use of Ti-6Al-4V as a coating for repair purposes through thermal spray techniques provides a u...
In order to better determine the applicable working conditions of Al-Si alloy cylinder liners and cast-iron cylinder liners, their tribological performance and scuffing resistance are discussed in this paper. After wear and scuffing tests, it was fou...
In this research, a design method for triply periodic minimal surface (TPMS) structures with a high specific strength for broadband sound absorption is proposed. The graded TPMS structures are controlled by linear, quadratic, and sine functions. Homo...
The use of organic coatings in conjunction with cathodic protection (CP) for buried structures is the usual method for protecting steel against corrosion. When the organic coating loses its protective ability, regardless of the reason, the CP becomes...
Fuel cladding tubes are devices used in reactors to encapsulate fuel clots and transmit heat to coolants. However, zirconium alloy materials which are widely used in the fuel cladding pipe of pressurized water reactors have noticeable safety risks in...
Laser cladding is a new method to prepare coatings with good quality. Laser power is one of the main factors affecting the quality of laser cladding coatings. An appropriate laser power helps obtain a high-performance laser cladding coating. In order...
The main objective of this investigation was to study the implications of incorporating zinc oxide nanoparticles into the matrix of a bioactive glass for the bioactivity and structural properties of the deposited coating. ZnO-containing bioactive gla...
of 16
Get Alerted
Add your email address to receive forthcoming issues of this journal.
