Fibers, Volume 11, Issue 7

Terpolymers of acrylonitrile with acrylic acid and alkyl acrylates, including methyl-, butyl-, 2-ethylhexyl-, and lauryl acrylates, were synthesized using the reversible addition–fragmentation chain transfer method. In this study, the focus was...

Unlike the recycling of particleboards, the recycling of medium-density fiberboards (MDF) is not a widespread industrial practice, and currently, most waste MDF panels are landfilled or incinerated after the end of their life cycle. Therefore, it is...

In recent years, there has been growing interest in utilizing bark fibers as reinforcements for polymer composites. This study focused on the characterization of epoxy composites reinforced with Acacia caesia bark (ACB) fibers, considering their mech...

The dispersion properties of surface plasmon polaritons (SPPs) during propagation on metal wires with a dielectric coating in the terahertz frequency range were investigated theoretically. An analytical expression was obtained for a pulsed electric f...

In this study, an experimental program was developed to investigate the flexural behavior of pre-damaged reinforced concrete (RC) beams that had been repaired and strengthened using carbon fiber-reinforced polymer (CFRP) laminates under a monotonic l...

A new hi-accuracy method for slight-shift determination of low-resolution spectra is proposed. The method allows determining a spectrum shift with an accuracy exceeding the spectrum analyzer resolution to more than three orders of magnitude due to th...

Fibre-reinforced shotcrete is an essential part of the support of hard rock tunnels. Due to the complexity of the design, a combination of empirical and numerical analysis is commonly used in the design. The required dosage of fibres for structural p...

A frequent problem in geotechnics is soils with inadequate physical–mechanical properties to withstand construction work, incurring cost overruns caused by their engineering improvement. The need to improve the engineering properties of soils i...

Fiber laser sources operating near 2300 nm in the atmospheric transparency window are interesting for different applications, such as remote sensing, lidars, and others. The use of Tm-doped fiber lasers based on tellurite fibers is highly promising....