July 2020 - 101 articles
To solve the problem of contamination flashover of a catenary insulator in an electrified railway, the collision mechanism and deposition characteristics of contamination particles on the insulator surface should be studied to ensure the safe operati...
Herein, we performed a comparative study of plasma-enhanced atomic layer deposition (PEALD) of SnO2 films using Sn(dmamp)2 as the Sn source and either H2O plasma or O2 plasma as the oxygen source in a wide temperature range of 100–300 °C. S...
The Taidong Tomb in the imperial tombs of the Qing dynasties has great aesthetic value and a rich history. In this study, we conducted the first investigation ever performed on the raw materials used in the paintings in the Taidong Tomb. Energy dispe...
Studies have already established that the mechanical properties of Babbitt coatings significantly depend on the microstructural characteristics, such as the amount and distribution of intermetallic compounds dispersed in a soft solid solution matrix....
SiO2/ZrO2 and SiO2/ZrO2/Al2O3 composite organic–inorganic coatings were prepared by the sol-gel technology. The structure of the coating was characterized by IR, particle size analyzer, SEM, and AFM, respectively. The results showed that ZrO2,...
This study presents the theoretical investigation of a roll-over thin layer formation under the lubrication approximation theory. The set of differential equations derived by lubrication approximation is solved by the optimal homotopy asymptotic meth...
The reduction of graphene oxide (GO) thin films deposited on substrates is crucial to achieve a technologically useful supported graphene material. However, the well-known thermal reduction process cannot be used with thermally unstable substrates (e...
Water-line corrosion is a highly concentrated type of localized corrosion. The conventional single electrode method is limited in its ability to obtain the kinetic information of the corrosion occurrence and development processes. Herein, the coating...
Top coating are usually moulded, painted or sprayed onto the wind blade Leading-Edge surface to prevent rain erosion due to transverse repeated droplet impacts. Wear fatigue failure analysis based on Springer model has been widely referenced and vali...
The YBa2Cu3O7−x/LaAlO3/YBa2Cu3O7−x (YBCO/LAO/YBCO) heterogeneous trilayer film structures were prepared on the LaAlO3 (001) single-crystal substrate via the sol-gel method. The characteristics of the phase, orientation, and superconductin...
of 11
Get Alerted
Add your email address to receive forthcoming issues of this journal.
