Polymers, Volume 17, Issue 6

Ionogels, as emerging stretchable conductor materials, have garnered significant attention for their potential applications in flexible electronics, particularly in wearable strain sensors. However, a persistent challenge in optimizing ionogels lies...

The optical and radiation shielding of PVA have been enhanced through embedding with ZnO/CuO/SWCNT (ZCS) nanocomposites. ZCS polymeric nanocomposites (PNCs) were prepared with the solution casting method. Scanning electron, optical microscopy and FT-...

The structure of nitrofen is stable and resistant to natural degradation, persisting in environments for extended periods. It can accumulate through the food chain, posing risks to human health. Here, we report a sensor based on carbon quantum dots (...

This paper studies the effect of specimen size on the moisture uptake characteristics of pultruded E-glass/vinylester composites exposed to conditions of immersion and 99% RH over a range of temperatures. Four different specimen sizes representative...

Tepals of the Crocus sativus flower constitute the most abundant floral residue during saffron production (350 kg tepals/kg stigmas). Being a natural source of polyphenols with antioxidant properties, they can be reused to create potentially valuable...

This research aims to create a high-efficiency, low-resistance biodegradable air-filter structure containing beeswax as a result of the simultaneous production of fibers by solution-blowing and melt-blowing. The melt-blowing method is effective for p...

This study presents the results of an investigation into the influence of few-layer graphene, produced by self-propagating high-temperature synthesis from various types of biopolymers (glucose, cellulose, and lignin), on the mechanical, thermophysica...

Direct ink writing (DIW) of low-yield-stress UV-curable silicone rubber faces challenges in maintaining dimensional accuracy due to post-extrusion swelling and viscoelastic deformation. This study proposes an ultraviolet-follow curing (UFC) method to...

The exponential increase in medical waste production has increased the difficulty of waste management, resulting in higher medical waste dispersion into the environment. By employing a circular economy approach, it is possible to develop new material...

The preference and demand for low-fat diets have increased due to their health benefits. This study aimed to develop a thermally stable water-in-oil (W/O) emulsion. The addition of 3.75 wt% of polysaccharide colloids, including curdlan gum (CG), kapp...