Stem Cell Bioprocessing and Manufacturing

Dear Colleagues,

The next healthcare revolution will apply regenerative medicines using human cells and tissues. The aim of the regenerative medicine approach is to create biological therapies or substitutes in vitro for the replacement or restoration of tissue function in vivo lost through failure or disease. However, whilst science has revealed the potential, and early products have shown the power of such therapies, there is an immediate and long-term need for expertise with the necessary skills to face the engineering and life science challenges before the predicted benefits in human healthcare can be realized. Specifically, there is a need for the development of bioprocess technology for the successful transfer of laboratory-based practice of stem cell and tissue culture to the clinic as therapeutics through the application of engineering principles and practices. This Special Issue of Bioengineering on Stem Cell Bioprocessing and Manufacturing addresses the central role in defining the engineering sciences of cell-based therapies by bringing together contributions from worldwide experts on stem cell biology and engineering, bioreactor design and bioprocess development, scale-up, and manufacturing of stem cell-based therapies.

Prof. Dr. Joaquim M. S. Cabral
Assoc. Prof. Dr. Cláudia Lobato da Silva
Assist. Prof. Dr. Maria Margarida Diogo
Guest Editors

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 250 words) can be sent to the Editorial Office for assessment.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Bioengineering is an international peer-reviewed open access monthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2700 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.