Fluids, Volume 8, Issue 5

Erythrocyte enrichment is needed for blood disease diagnosis and research. DLD arrays with an I-shaped pillar (I-pillar) sort erythrocytes in a unique, accurate, and low-reagent method. However, the existing I-shaped pillar DLD arrays for erythrocyte...

Acting upon clinical patient data, acquired in the pathway of percutaneous intervention, we deploy hierarchical, multi-stage, data-handling protocols and interacting low- and high-order mathematical models (chamber elastance, state-space system and C...

Gaussian solutions of the diffusion equation can be applied to visualize the flow paths in subsurface reservoirs due to the spatial advance of the pressure gradient caused by engineering interventions (vertical wells, horizontal wells) in subsurface...

Evaluating the hydrodynamic force fluctuations acting on each structure in a group of subsea objects of different cross-section shapes, sizes and relative positions represents a challenge due to the sensitivity of the vortex shedding process, especia...

The present article addresses the topic of grid motion computation in Arbitrary Lagrange–Euler (ALE) simulations, where a fluid mesh must be updated to follow the displacements of Lagrangian boundaries. A widespread practice is to deduce the mo...

Racecar aerodynamic development requires well-correlated simulation data for rapid and incremental development cycles. Computational Fluid Dynamics (CFD) simulations and wind tunnel testing are industry-wide tools to perform such development, and the...

Among the most relevant fields of research recently investigated for improving the performance of gasoline direct injection (GDI) engines, there are ultrahigh injection pressures and the flash-boiling phenomenon. Both perform relevant roles in improv...

In this work, we performed molecular dynamics simulations to study the dynamics of a shock wave-induced single nanobubble collapsing near one flexible and two rigid boundaries. The flexible boundary consisted of polyethylene, and the rigid boundaries...

We theoretically considered two-dimensional flow in a vertically aligned thick molten liquid film to investigate the competition between cooling and gravity-driven draining, which is relevant in the formation of metallic foams. Molten liquid in films...

The understanding of impingement processes is crucial for optimizing automotive selective catalytic reduction (SCR) systems. An accurate description of this behavior helps design exhaust systems and increases the validity of modeling approaches. A co...

Ventricular assist devices (VADs) are implantable turbomachines that save and improve the lives of patients with severe heart failure. In the preclinical evaluation, a VAD design must be experimentally or numerically tested regarding its pump charact...

Due to its low global warming potential (GWP) and good environmental properties, CF₃I can be a suitable component of refrigerant mixtures in the field of refrigeration and air conditioning. In this work, the local condensation heat transfer character...

The results of a numerical solution of the problem of supersonic flow past a blunt fin mounted on a plate with a developing boundary layer are presented. The initial formulation of the problem is based on the presented in the literature computational...

Simulations are presented for flow around pairs of circular cylinders at a Reynolds number of 3900. The flow is assumed to be two-dimensional and incompressible in nature and the simulations are performed using a RANS (Reynolds Averaged Navier Stokes...

We present an open-source code, Xyst, intended for the simulation of complex-geometry 3D compressible flows. The software implementation facilitates the effective use of the largest distributed-memory machines, combining data-, and task-parallelism o...

A novel approach for sensing and characterising the flow over an aerofoil is introduced. Arrays of flexible wind-hair-like sensors distributed over an aerofoil, which are tracked remotely using high-speed imaging and processing, acting as “digi...

In this paper, the characterization of a new clutch control strategy by means of a magnetorheological fluid (MR) has been investigated. The clutch system was designed and manufactured in the laboratory in order to determine its static and dynamic cha...

To enable the lattice-Boltzmann method (LBM) to account for temporally constant but spatially varying thermophysical properties, modifications must be made. Recently, many methods have emerged that can account for conjugate heat transfer (CHT). Howev...

The CFD numerical study of the flash boiling phenomenon of a water film was conducted using an Euler–Euler method, and compared to the experiments on the flashing of a water film. The water film is initially heated at temperatures ranging from...

Magnetohydrodynamical (MHD) turbulence is ubiquitous in magnetized astrophysical plasmas, and it radically changes a great variety of astrophysical processes. In this review, we introduce the concept of MHD turbulence and explain the origin of its sc...

The efficiency of heat transfer in air-cooled heat exchangers of various industrial facilities depends on the flow rate of the coolant, its inlet temperature and ambient temperature. These parameters are transient and depend both on the features of t...

The purpose of this paper is to investigate the fire performance in a multi-storey cross-laminated timber (CLT) structure by the computational fluid dynamics (CFD) technique using the Fire Dynamics Simulator (FDS v.6.7). The study investigates fire t...

The two-fluid (Euler–Euler) model and large-eddy simulation are used to compute the turbulent two-phase flow of air and water in a cyclonic flotation device known as an Air-Sparged Hydrocyclone (ASH). In the operation of ASH, air is injected th...

The interfacial instability of a complex fluid in a multiphase flow system is ubiquitous in both nature and industry. We experimentally investigated the spreading and interfacial instability dynamics of a binary droplet (a water and 2-propanol (IPA)...

In this study, we investigate the performance of the smoothed particle hydrodynamics (SPH) method regarding the computation of confined flows in microchannels. Modeling and numerical simulation with SPH involve the representation of flowing matter as...