Materials, Volume 12, Issue 9

Nanoporous materials have a wide range of applications in clean energy and environmental research. The permeability of nanoporous materials is low, which affects the fluid transport behavior inside the nanopores and thus also affects the performance...

Two natural polymers, i.e., cellulose and water soluble pullulan, have been selectively oxidized employing the TEMPO-mediated protocol, to allow the introduction of C6-OOH groups. Thereafter, the composite hydrogels of poly(vinyl alcohol) (PVA) and d...

Inhibition of residual malignant tumors in patients with colon cancer after operation is one of the difficulties in rehabilitation treatment. At present, using biocompatible materials to remove the copper ion which is the growth dependence of maligna...

The fabrication of Ti-aluminide multi-layered composites have attracted great attention for their excellent mechanical properties, such as high specific strength, high specific stiffness, tolerable toughness, and low density. The preparation of the c...

Previous studies of alkali-activated slag cement (AASC) using nano-silica have mentioned mostly powdered nano-silica and binder weight replacement methods, which have a rapid decrease in fluidity, a short setting time and a low nano-silica replacemen...

The friction of hydrogenated diamond-like carbon (H-DLC) films was evaluated under the controlled environments of humid air and vacuum by varying the applied load. In humid air, there is a threshold applied load below which no obvious friction drop o...

The development of novel Ti-based amorphous or β-phase nanostructured metallic materials could have significant benefits for implant applications, due to improved corrosion and mechanical characteristics (lower Young’s modulus, better wear...

This paper examines the possibility of using basalt-based glass ceramics for construction of structural parts of equipment in metallurgy and mining. An ultrasonic vibration method with a stationary sample pursuant to the ASTM G32 standard was used to...

In this paper, the effect of equal channel angular pressing (ECAP) on microstructure and mechanical properties of hypereutectic Al-20%Mg2Si and Al-15%Mg2Si, as well as hypoeutectic Al-10%Mg2Si composites has been investigated. After fabricating the c...

Deformation of an as-rolled rare earth Mg-2Y-0.6Nd-0.6Zr alloy, at different temperatures, was carried out along the BC (90° anticlockwise rotation of the samples after each ECAP pass) route by equal channel angular pressing (ECAP). The effects o...