Skip to Content

4 Results Found

  • Article
  • Open Access
2 Citations
6,299 Views
16 Pages

29 November 2017

In this study, we demonstrate and investigate a new droplet injection design. We create a thermal inkjet (TIJ) printhead using an application-specific integrated circuit system and bulk micromachining technology (microelectromechanical systems). We d...

  • Article
  • Open Access
4,441 Views
13 Pages

A Simple Method for Fabricating Ink Chamber of Inkjet Printheads

  • Zheguan Huang,
  • Yang Tang,
  • Zhibin Liu,
  • Xiaofei Zhang and ,
  • Yan Zhou and
  • Yonglin Xie
  • + 1 author+ 0 author

17 March 2022

The process of fabricating chambers is becoming more important for inkjet printheads. However, there are some problems with the majority of present fabrication methods, such as nozzle structural deformation, blocked chambers, and collapsed chambers....

(This article belongs to the Section D1: Semiconductor Devices)
  • Article
  • Open Access
3 Citations
3,794 Views
17 Pages

Conjugate Heat Transfer in Thermal Inkjet Printheads

  • S. G. Mallinson,
  • G. D. McBain and
  • B. R. Brown

1 March 2023

The mass of individual droplets ejected from a thermal inkjet printhead increases with increasing local temperature near the ejector nozzles. The amount of ink deposited on the page and so the printed image density depends on the droplet mass. Thus,...

  • Article
  • Open Access
6 Citations
1,438 Views
19 Pages

Effect of Build Orientation on Surface Finish and Hydrodynamic Stability of Inkjet 3D-Printed Microfluidic Channels

  • Emanuela Cutuli,
  • Lorena Saitta,
  • Nunzio Tuccitto,
  • Gianluca Cicala and
  • Maide Bucolo

3 July 2025

This study examined the effect of build orientation on the surface finish of micro-optofludic (MoF) devices fabricated via a polydimethylsiloxane (PDMS)-based 3D-printing primary–secondary fabrication protocol, where an inkjet 3D-printing techn...

(This article belongs to the Section Polymer Analysis and Characterization)