Skip to Content
BuildingsBuildings
  • Article
  • Open Access

15 December 2025

25 Pages

Full-Scale Test on Hysteretic Behavior of T-Shaped Steel Beam–Column Joints with Locally Corrugated Web (RBS) Considering Folding Effect

,
,
,
and
1
School of Civil Engineering, Yantai University, Yantai 264005, China
2
China Construction Third Engineering Bureau Group Co., Ltd., Wuhan 430064, China
*
Author to whom correspondence should be addressed.
This article belongs to the Section Building Structures

Abstract

Steel frame structures have been increasingly widely used in high-rise and multi-story building design. However, traditional rigid welded beam–column joints exhibit poor ductility and high residual stress, which are key reasons for their susceptibility to brittle failure under strong earthquake actions. This study proposes a new type of beam–column joint for steel frames: the corrugated web beam–column joint. In this new joint, the web of the I-beam near the beam flange is partially replaced with a corrugated web that exhibits a folding effect—this modification weakens the plastic bending capacity of the I-beam and promotes the outward movement of plastic hinges. Low-cycle reciprocating loading tests were conducted to verify the performance of two specimens, namely one with the traditional beam–column joint and the other with the corrugated web beam–column joint. Through experimental comparison, it was found that plastic hinges in the new corrugated web joint are generated at the corrugated web, while no damage occurs at the beam-end welds. This indicates that the corrugated web beam–column joint can stably achieve the outward movement of plastic hinges and avoid the location of the beam-end welds, thereby providing theoretical and experimental foundations for the structural design of new ductile steel frames.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.