Skip to Content
You are currently on the new version of our website. Access the old version .
WaterWater
  • Article
  • Open Access

1 October 2019

23 Pages

Multi-Parametrical Tool for the Design of Bottom Racks DIMRACK—Application to Small Hydropower Plants in Ecuador

,
,
and
1
Mining and Civil Engineering Department, Universidad Politécnica de Cartagena, Paseo Alfonso XIII, 52, 30203 Cartagena, Spain
2
Civil and Environmental Engineering Department, Escuela Politécnica Nacional, Ladrón de Guevara E11-253, Quito 170517, Ecuador
*
Author to whom correspondence should be addressed.
This article belongs to the Section Hydraulics and Hydrodynamics

Abstract

A novel computational tool, DIMRACK, is presented for the design of the required length of bottom racks in intake systems. The users may consider clear water cases or the rack’s occlusion due to sediment transport in the river. The computational tool uses a methodology based on the experimental works undertaken at the Universidad Politécnica de Cartagena from 2010. This work also presents an extension of the methodology to cover a broad range of void ratios, bar profiles, slopes, and flow rates. Designing nomograms are also proposed. These are two diagrams to allow the approximate graphical computation of the rack length with clear water. In sediment transport cases, an occlusion factor is proposed, obtained from experimental gravel tests. This parameter enables an increment in the rack length due to occlusion, depending on the bar type. The results are compared with those proposed in classical technical manuals. Finally, the results have been compared with ten existing small hydropower plants’ bottom intake designs in Ecuador.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.