Energies, Volume 15, Issue 12

By creating a special edition entitled Fundamentals of Enhanced Oil Recovery, the editors focus on the problem of the global increase in energy demand [...]

The measurement of the growth rate, or the so-called inverse period, of a nuclear reactor is crucial for safety monitoring and control purposes. Due to the inevitable statistical fluctuation of neutron flux at low power-levels, it is difficult to pre...

The organic Rankine cycle (ORC) has been widely studied to recover waste heat from internal combustion engines in commercial on-road vehicles. To achieve a cost-effective ORC, a trade-off between factors such as costs, power outputs, back pressure, a...

This paper provides computer analysis and experiential investigation of the permanent magnet machines with neodymium and ferrite permanent magnets to discuss the feasibility of utilizing induction machines-oriented equipment for PM machine production...

Whilst various new technologies for power generation are continuously being evaluated, the owners of almost-new facilities, such as combined-cycle gas turbine (CCGT) plants, remain motivated to adapt these to new circumstances and avoid the balance-s...

The performance of rotating detonation engines (RDEs) is theoretically better than that of traditional aero engines because of self-pressurization. A type of swirl injection scheme is introduced in this paper for two-phase detonation. On the one hand...

A method of biodiesel production from the freshwater microalgae Chlorella vulgaris based on the conversion of the dewatered algal biomass from a foam column (“foamate”) was investigated. The foam column collected and concentrated the micr...

Various technological fluids, such as drilling muds, drill-in fluids, fracturing fluids, spacers, washes and cement slurries are used in the wellbore drilling process. The fundamental issue, which needs to be addressed in order to become acquainted w...

The aim of the article is to present a new idea of limiting the bearing voltage in electric machines with permanent magnets through the use of a shielding winding placed in stator slot wedges. The first part of the article is dedicated to the mechani...

There is global pressure to make advanced biofuels profitable. For cellulosic ethanol, three aspects remain as bottlenecks: collection of feedstocks, pretreatment methods, and enzyme production. In this paper, the first aspect is investigated, by add...