Skip to Content

7 Results Found

  • Article
  • Open Access
9 Citations
1,839 Views
29 Pages

29 August 2023

The description of the areal texture of the surface is more comprehensive than that of roughness profiles. Ball burnishing led to an improvement in surface quality. In this work, the changes in areal surface textures due to ball burnishing were studi...

  • Article
  • Open Access
2 Citations
1,061 Views
20 Pages

23 June 2025

This paper investigates the effect of plasticity ball burnishing on characteristics of surface integrity, residual stress and hardness of laser direct energy deposited (DEDed) Stellite 21 alloys, with a focus on the burnishing directional effect on s...

  • Article
  • Open Access
59 Citations
5,550 Views
16 Pages

Burnishing of FSW Aluminum Al–Cu–Li Components

  • Adrián Rodríguez,
  • Amaia Calleja,
  • Luis Norberto López de Lacalle,
  • Octavio Pereira,
  • Haizea González,
  • Gorka Urbikain and
  • Julien Laye

21 February 2019

Ball-burnishing is presented herein as a mechanical surface treatment for improving mechanical properties after the friction stir welding process. Ball-burnishing provides good surface finish, high compressive residual stresses, and a hardness increa...

  • Article
  • Open Access
24 Citations
3,340 Views
14 Pages

8 October 2021

Additive manufacturing technologies are increasingly being used in production systems because they shorten product development time and production cost, but surface integrity remains a limitation to meet the standards set by conventional manufacturin...

  • Article
  • Open Access
2 Citations
2,257 Views
13 Pages

9 September 2023

Austenitic stainless steel gears were fabricated via the fine blanking process that can be used for mass production. A carbon-supersaturated (CS)-matrix high-speed steel punch was prepared to minimize the adhesive and abrasive wear damage. Its edge p...

  • Article
  • Open Access
9 Citations
4,723 Views
21 Pages

Manufacturing of Al Alloy Microrods by Micro Cutting in a Micromachining Center

  • M. Azizur Rahman,
  • Mustafizur Rahman,
  • Mozammel Mia,
  • A.B.M.A. Asad and
  • Ahmed Fardin

29 November 2019

This paper presents the micromanufacturing of aluminum (Al) alloy microrods using micro turning as a competing process to other nontraditional micromachining methods. In that regard, the challenges in such manufacturing have been identified and overc...

  • Article
  • Open Access
29 Citations
4,906 Views
23 Pages

20 January 2022

Processes of surface texture characterisation can be roughly divided into measurement issues and analysis of the results obtained. Both actions can be fraught with various errors, some of which can be analysed with frequency performance. In this pape...