energies-logo

Journal Browser

Journal Browser

Ground-Source Heat Pumps and Thermal Energy Storage Systems—Energy for the Future

A special issue of Energies (ISSN 1996-1073). This special issue belongs to the section "H2: Geothermal".

Deadline for manuscript submissions: 26 May 2024 | Viewed by 1486

Special Issue Editors


E-Mail Website1 Website2
Guest Editor
Dime Department of Mechanical, Energy, Management and Transportation Engineering, The University of Genova, via Opera Pia 15, 16145 Genova, Italy
Interests: ground source heat pumps; borehole heat exchangers; ground modelling; thermal response test; advanced equipment and sensors for geothermal heat pumps; temperature response factor estimation; ground heat exchanger design and criteria; energy pile heat exchangers
Special Issues, Collections and Topics in MDPI journals

E-Mail Website
Guest Editor
Dime Department of Mechanical, Energy, Management and Transportation Engineering, The University of Genova, via Opera Pia 15, 16145 Genova, Italy
Interests: ground coupled heat pumps; energy in buildings; heat transfer; renewable energy
Special Issues, Collections and Topics in MDPI journals

E-Mail Website
Guest Editor
Dime Department of Mechanical, Energy, Management and Transportation Engineering, The University of Genova, via Opera Pia 15, 16145 Genova, Italy
Interests: ground coupled heat pumps

Special Issue Information

Dear Colleagues,

Heat pumps (HPs) are a cornerstone technology in the worldwide shift toward secure and sustainable heating of buildings. According to a recent IEA Report (“Future of Heat Pumps”, a specialised report within the IEA's World Energy Outlook series), heat pumps in 2021 had already met 10% of the global demand for space heating, but their installation is gaining momentum swiftly, marked by record-breaking sales, despite the challenges that are still present along the direction to the progressive substitution of fuel-based heating systems in future cities.

Heat pumps, which operate using electricity with low emissions, serve as the cornerstone technology in the worldwide shift toward secure and sustainable heating. "The Future of Heat Pumps," a specialised report within the IEA's World Energy Outlook series, presents a forward-looking perspective on heat pumps. It not only identifies crucial opportunities to expedite their adoption but also sheds light on the principal challenges and policy solutions. Additionally, the report delves into the repercussions of an accelerated integration of heat pumps, touching upon energy security, consumers' energy expenditures, employment, and endeavours to combat climate change. Again, according to the IEA, financial incentives for heat pumps are already accessible in more than 30 countries, encompassing over 70% of today's heating demand. According to IEA estimates, heat pumps possess the potential to curtail global carbon dioxide (CO2) emissions by at least 500 million tonnes in 2030, an amount equivalent to the yearly CO2 emissions produced by all the cars circulating in Europe during the year 2021.

As is well known, HPs offer a method for generating heat without direct combustion, and they can be successfully employed in both residential and industrial sectors. These systems exhibit exceptional efficiency by utilising electrical energy, resulting in a significant reduction in local environmental pollution and global CO2 emissions, even in countries where electricity production using renewable resources is still a small fraction of the overall amount. The utilisation of electricity, which is partly derived from renewable sources, combined with a coefficient of performance (COP) that can reach values as high as four or more, implies that HPs have the potential to become nearly carbon neutral; hence, HPs contribute to the goal of zero emissions by the year 2050.

The appropriate selection of a heat source and the careful design of heat exchangers are essential for achieving high HP efficiencies. This can encompass various approaches, including Ground-Source Heat Pumps (GSHPs), where the lower temperature heat source can be the ground or open waters and aquifers. Heat exchangers in GSHP applications play a pivotal role in heat pump performance, and enhancing their performance contributes significantly to the overall system's effectiveness. Furthermore, different from air-source heat pumps, the ground-coupled ones can perform energy storage in the ground (or water), thus providing an additional benefit to clean heating strategies.

Many studies have been devoted to ground heat pumps, from ground heat exchanger design, to heat pump component engineering, to proper refrigerant selection, to the correct modelling and monitoring of the entire building and heat pump system. Optimal control of the HPs as well as best matching with the hourly electricity production are other fundamental fields of research. A multidisciplinary approach to analysis is imperative in the GSHP sector. The present Special Issue is addressed to this aim.

Prof. Dr. Marco Fossa
Dr. Antonella Priarone
Prof. Dr. Stefano Morchio
Guest Editors

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Energies is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.

Published Papers (1 paper)

Order results
Result details
Select all
Export citation of selected articles as:

Research

18 pages, 5370 KiB  
Article
Modelling and Experimental Characterisation of a Water-to-Air Thermoelectric Heat Pump with Thermal Energy Storage
by Kaixuan Zhou, Shunmin Zhu, Yaodong Wang and Anthony Paul Roskilly
Energies 2024, 17(2), 414; https://doi.org/10.3390/en17020414 - 15 Jan 2024
Cited by 1 | Viewed by 1202
Abstract
Nowadays, increasing the penetration of renewable heat technologies is an important approach to minimise global primary energy use and reduce CO2 emissions for a sustainable future. Thermoelectric heat pumps, which have some unique characteristics in comparison with conventional vapour compression heat pumps, [...] Read more.
Nowadays, increasing the penetration of renewable heat technologies is an important approach to minimise global primary energy use and reduce CO2 emissions for a sustainable future. Thermoelectric heat pumps, which have some unique characteristics in comparison with conventional vapour compression heat pumps, can be integrated with solar thermal energy storage to form a promising renewable heat technology. However, currently, a reliable numerical model for TeHPs suitable for building energy simulation is lacking and the benefits achievable for a TeHP thanks to the integration with heat storage are unclear. To solve these issues, in this work, an experimental apparatus consisting of a water-to-air TeHP unit with a heat storage tank is modelled and tested for the first time, under the scenarios with thermal energy storage and without thermal energy storage, respectively. The results found that the developed numerical model could well predict the output performance of the TeHP unit, with deviations within 12%. Additionally, the output performance of the TeHP unit when combined with a heat storage tank is better than that of the TeHP unit without heat storage, in terms of the maximum temperature achieved in the testing box, the temperature response speed of the testing box, and the coefficient of performance (COP) of the TeHP unit. This work not only paves the way for the following building-integrated simulations of TeHP units, but also provides guidance for the design of the integrated systems that include TeHPs and thermal energy storage. Full article
Show Figures

Figure 1

Back to TopTop