Skip to Content
ProcessesProcesses
  • Article
  • Open Access

7 July 2026

27 Pages

Mitigating Particle Erosion in Axial-Flow Turbines Through Air Injection at the Inlet Rotor Section

,
,
and
1
Department of Mechanical Engineering, Federal University of Triângulo Mineiro, Uberaba 38025-180, Brazil
2
Department of Mechanical Engineering, Federal University of Espirito Santo, Vitória 29075-910, Brazil
3
Laboratory of Fluid Dynamics and Particulate, FluidPar, Federal University of Pará, Tucuruí 68455-901, Brazil
*
Author to whom correspondence should be addressed.
This article belongs to the Special Issue CFD Simulation of Fluid Machinery

Abstract

This study presents a computational analysis of degradation caused by cavitation and hydro-abrasive erosion in a low-head axial microturbine (H=4m), incorporating strategic air injection as a passive mitigation technique. Using Computational Fluid Dynamics (CFD) within ANSYS CFX 2025 R2, the study investigates hydrodynamic performance and the spatial distribution of surface wear across the runner blades. The turbine geometry was developed from aerofoil profiles mapped onto cylindrical coordinates, using a structured three-dimensional mesh with localized refinement to ensure grid independence. Physical modeling employed the Shear Stress Transport (SST) turbulence model, with cavitation dynamics governed by the Rayleigh–Plesset equation and sediment transport modeled using a Lagrangian framework incorporating the Finnie erosion model. The numerical framework showed good agreement with reference characteristic curves, confirming its predictive accuracy. The results indicate that vapor cavities form predominantly on the suction side, whereas solid particle erosion highly concentrated on the pressure side of the blades, where the outer 20% of the span accounts for over 91% of the total erosion intensity. Parametric assessments of controlled air injection revealed a highly non-linear mitigation response, identifying IAVF 2 as the optimal air-injection case. This configuration reduced integrated erosion by 0.95% and maximum localized erosion by 6.17%. In contrast, excessive air volumes accelerated material removal due to localized flow distortion. The findings indicate that carefully controlled air injection is a viable strategy for extending the operational lifespan of small-scale hydropower assets.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.