Skip to Content
ElectronicsElectronics
  • Article
  • Open Access

29 May 2025

18 Pages

Design Methodology and Robustness Analysis of a 13–15 GHz Three-Stage Low-Noise Amplifier in pHEMT GaAs Technology †

,
,
,
,
and
Department of Electronic Engineering, University of Roma Tor Vergata, 00133 Rome, Italy
*
Authors to whom correspondence should be addressed.
†
An Expanded Article of a Conference Paper: Abdalrahman, F.; Longhi, P.E.; Limiti, E. A Simple Synthesis Methodology for 3-Stage LNA Design in GaAs Technology. In Proceedings of the 2024 19th Conference on Ph.D. Research in Microelectronics and Electronics (PRIME), Larnaca, Cyprus, 9–12 June 2024; pp. 1–4. https://doi.org/10.1109/PRIME61930.2024.10559679.

Abstract

This work presents a novel three-stage low-noise amplifier (LNA) design methodology. The first two stages consist of common-source stages with inductive source degeneration, while the third stage consists of an RC network attached before the common-source FET transistor. The input matching network is designed to meet the optimum noise measurement termination, which results in a noise Figure of less than 1.6 dB. The highest gain level of 25 dB was measured, and the input and output reflection coefficients are better than 10 dB for the operating bandwidth, i.e., 13–15 GHz. The LNA’s large signal performance and robustness against continuous high input power and pulse waves are reported. This LNA can handle up to 15 dBm input pulse of 50 nS width and 10% duty cycle, and 18 dBm continuous wave without noticing an increment in the forward gate current.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.