Error in Figure
In the original publication [1], there was a mistake in Figure 14b as published. The labels of the curves were swapped during the Matlab processing of our experimental results. The red/diamond curve corresponds to signal “FAR” and the blue/o curve corresponds to “Switch Only”. This has significant importance since FAR has better performance than the Switch Only, as described in the text. The corrected Figure 14b appears below. The authors apologize for any inconvenience caused and state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.
Figure 14.
Output power as a function of (a) 1/RL, (b) Vrec.
Reference
- Frick, V.; Wassouf, L.; Jamshidpour, E. Voltage Flip Efficiency Enhancement for Piezo Energy Harvesting. Electronics 2021, 10, 2400. [Google Scholar] [CrossRef]
Publisher’s Note: MDPI stays neutral with regard to jurisdictional claims in published maps and institutional affiliations. |
© 2022 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).