Correction: Grenez, F., et al. Wireless Prototype Based on Pressure and Bending Sensors for Measuring Gait Quality. Sensors 2013, 13, 9679–9703

Florent Grenez; María Viqueira Villarejo; Begoña García Zapirain; Amaia Méndez Zorrilla

doi:10.3390/s131115861

,

and

¹

Computer Science Department, ICAM University, 6 rue Auber-59000 Lille, France

²

DeustoTech-Life Unit, Deusto Institute of Technology, University of Deusto, Avda. de las Universidades, 24, Bilbao 48007, Spain

^*

Author to whom correspondence should be addressed.

Sensors2013, 13(11), 15861-15862;https://doi.org/10.3390/s131115861

This article belongs to the Section Physical Sensors

Version Notes

Order Reprints

In [1], we would like to change “Gate” to “Gait” in the title, which should read “Prototype Based on Pressure and Bending Sensors for Measuring Gait Quality”. In Figure 7 we would like to change the analog inputs. The measurements should be between the sensor and the resistance, and not after the resistance. The revised figure is shown below.

Figure 7. General circuit.

Acknowledgments

The authors would like to apologize for any inconvenience caused to the readers by these changes.

Reference

Grenez, F.; Villarejo, M.V.; Zapirain, B.G.; Zorrilla, A.M. Wireless Prototype Based on Pressure and Bending Sensors for Measuring Gate Quality. Sensors 2013, 13, 9679–9703. [Google Scholar]

© 2013 by the authors; licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution license (http://creativecommons.org/licenses/by/3.0/).

Correction: Grenez, F., et al. Wireless Prototype Based on Pressure and Bending Sensors for Measuring Gait Quality. Sensors 2013, 13, 9679–9703

Acknowledgments

Reference

Article Metrics

Citations

Article Access Statistics