Journal Menu► ▼ Journal Menu
Journal Browser► ▼ Journal Browser
Topical Collection "Micromixers: Analysis, Design and Fabrication"
A topical collection in Micromachines (ISSN 2072-666X).Viewed by 2226
Interests: micromixer; micro heat sink; fluid machinery; optimization; heat transfer
Special Issues, Collections and Topics in MDPI journals
Special Issue in Micromachines: Optimization of Microfluidic Devices
Special Issue in Micromachines: Analysis, Design and Fabrication of Micromixers
Special Issue in Micromachines: Analysis, Design and Fabrication of Micromixers, Volume II
Topical Collection Information
Micromixers are an important component in micro-total analysis systems (μTAS) and lab-on-a-chip platforms which are widely used for sample preparation and analysis, drug delivery, and biological and chemical synthesis. The successful operation of microfluidic devices requires fast and adequate mixing, but mixing is a challenging task due to the laminar feature of flow at the microscale. Mixing in laminar flows relies on diffusion and requires a longer channel to achieve complete mixing due to the slow process compared with that in turbulent flows. Hence, it is crucial to overcome this challenge to improve the mixing performance. Based on their mixing mechanism, micromixers are classified into two types: active and passive. Passive micromixers are easy to fabricate and generally use geometry modification to cause chaotic advection or lamination to promote the mixing of fluid samples, unlike active micromixers, which use moving parts or some external agitation/energy for the mixing. This collection will highlight recent developments within new mechanisms, numerical and/or experimental mixing analysis, design, and fabrication of various micromixers.
Prof. Dr. Kwang-Yong Kim
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the collection website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Micromachines is an international peer-reviewed open access monthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2000 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
- microfluidic device