Abstract
Immobilizing semiconductor photocatalysts in polymeric matrices has emerged as an effective strategy to overcome one of the main limitations of heterogeneous photocatalysis: recovering and reusing powdered catalysts after wastewater treatment. In this study, biodegradable poly(butylene adipate-co-terephthalate) (PBAT) was used as a support for niobium oxyhydroxide (S2) to produce photocatalytic composites by melt extrusion followed by hot pressing. The materials were characterized by Fourier-transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA), and differential scanning calorimetry (DSC), and their photocatalytic performance was evaluated by measuring methylene blue degradation under UV irradiation. FTIR analyses indicated interfacial interactions between PBAT and niobium oxyhydroxide without compromising the polymer structure. Thermal analyses showed that incorporating the catalyst preserved the thermal stability and processability of the composites. Among the formulations investigated, the composite containing 95 wt% PBAT, 5 wt% S2, and an additional surface deposition of 0.2 g of catalyst exhibited the highest photocatalytic performance, achieving approximately 88% methylene blue removal within 120 min. The improved efficiency was attributed to the synergistic contribution of adsorption and photocatalytic oxidation, promoted by accessible catalytically active sites and the generation of reactive oxygen species. Electrospray ionization mass spectrometry confirmed the progressive oxidative degradation of methylene blue. In addition to efficiently removing pollutants, immobilizing S2 on a biodegradable polymer matrix enables simple catalyst recovery. This approach offers a sustainable alternative for advanced oxidation processes aimed at wastewater remediation.